Dynamic Programming-Based Energy-efficient Rate Adaptation for Wireless Ad Hoc Networks

Resource constraints require that ad hoc wireless networks are energy efficient during transmission and rate adaptation. In this paper we propose a novel cross-layer energy-efficient rate adaptation scheme that employs dynamic programming (DP) principle to analytically select the modulation scheme online. The scheme uses channel state information from the physical layer and congestion information from the scheduling layer to select a modulation rate. This online selection maximizes throughput while saving energy and preventing congestion. The simulation results indicate that an increase in throughput by 96% and energy-efficiency by 131% is observed when compared to the Receiver Based AutoRate (RBAR) protocol

Decentralized Power Control with Implementation for RFID Networks

In radio frequency identification (RFID) systems, the detection range and read rates will suffer from interference among high power reading devices. This problem grows severely and degrades system performance in dense RFID networks. In this paper, we investigate a suite of feasible power control schemes to ensure overall coverage area of the system while maintaining a desired read rate. The power control scheme and MAC protocol dynamically adjusts the RFID reader power output in response to the interference level seen locally during tag reading for an acceptable signal-to-noise ratio (SNR). We present novel distributed adaptive power control (DAPC) and probabilistic power control (PPC) as two possible solutions. A generic UHF wireless testbed is built using UMR/SLU GEN4-SSN for implementng the protocol. Simulation and hardware results are included

Joint Adaptive Distributed Rate and Power Control for Wireless Networks

A novel adaptive distributed rate and power control (ADRPC) protocol is introduced for wireless networks. The proposed controller contrasts from others by providing nonlinear compensation to the problem of transmission power and bit-rate adaptation. The protocol provides control of both signal-to-interference ratio (SIR) and quality-of-service (QoS) support to bit-rate adaptation. Bit-rate adaptation is performed by local estimation of congestion levels, rendering little packet overhead, using Lyapunov based adaptive control methods. Performance of the proposed control scheme is shown through analytical proof and simulation examples

Route Aware Predictive Congestion Control Protocol for Wireless Sensor Networks

Congestion in wireless sensor networks (WSN) may lead to packet losses or delayed delivery of important information rendering the WSN-based monitoring or control system useless. In this paper a routing-aware predictive congestion control (RPCC) yet decentralized scheme for WSN is presented that uses a combination of a hop by hop congestion control mechanism to maintain desired level of buffer occupancy, and a dynamic routing scheme that works in concert with the congestion control mechanism to forward the packets through less congested nodes. The proposed adaptive approach restricts the incoming traffic thus preventing buffer overflow while maintaining the rate through an adaptive back-off interval selection scheme. In addition, the optimal routing scheme diverts traffic from congested nodes through alternative paths in order to balance the load in the network, alleviating congestion. This load balancing of the routes will even out the congestion level throughout the network thus increasing throughput and reducing end to end delay. Closed-loop stability of the proposed hop-by-hop congestion control is demonstrated by using the Lyapunov-based approach. Simulation results show that the proposed scheme results in reduced end-to-end delays

Adaptive and Probabilistic Power Control Algorithms for RFID Reader Networks

In radio frequency identification (RFID) systems, the detection range and read rates will suffer from interference among high power reading devices. This problem grows severely and degrades system performance in dense RFID networks. Consequently, medium access protocols (MAC) protocols are needed for such networks to assess and provide access to the channel so that tags can be read accurately. In this paper, we investigate a suite of feasible power control schemes to ensure overall coverage area of the system while maintaining a desired read rate. The power control scheme and MAC protocol dynamically adjusts the RFID reader power output in response to the interference level seen during tag reading and acceptable signal-to-noise ratio (SNR). We present novel distributed adaptive power control (DAPC) and probabilistic power control (PPC) as two possible solutions. A suitable back off scheme is also added with DAPC to improve coverage. Both the methodology and implementation of the schemes are presented, simulated, compared, and discussed for further work

Predictive Congestion Control Protocol for Wireless Sensor Networks

Available congestion control schemes, for example transport control protocol (TCP), when applied to wireless networks, result in a large number of packet drops, unfair scenarios and low throughputs with a significant amount of wasted energy due to retransmissions. To fully utilize the hop by hop feedback information, this paper presents a novel, decentralized, predictive congestion control (DPCC) for wireless sensor networks (WSN). The DPCC consists of an adaptive flow and adaptive back-off interval selection schemes that work in concert with energy efficient, distributed power control (DPC). The DPCC detects the onset of congestion using queue utilization and the embedded channel estimator algorithm in DPC that predicts the channel quality. Then, an adaptive flow control scheme selects suitable rate which is enforced by the newly proposed adaptive backoff interval selection scheme. An optional adaptive scheduling scheme updates weights associated with each packet to guarantee the weighted fairness during congestion. Closed-loop stability of the proposed hop-by-hop congestion control is demonstrated by using the Lyapunov-based approach. Simulation results show that the DPCC reduces congestion and improves performance over congestion detection and avoidance (CODA) [3] and IEEE 802.11 protocols

Communication models for monitoring and mobility verification in mission critical wireless networks

Recent technological advances have seen wireless sensor networks emerge as an interesting research topic because of its ability to realize mission critical applications like in military or wildfire detection. The first part of the thesis focuses on the development of a novel communication scheme referred here as a distributed wireless critical information-aware maintenance network (DWCIMN), which is presented for preventive maintenance of network-centric dynamic systems. The proposed communication scheme addresses quality of service (QoS) issues by using a combination of a head-of-the-line queuing scheme, efficient bandwidth allocation, weight-based backoff mechanism, and a distributed power control scheme. A thorough analysis of a head-of-the-line priority queuing scheme is given for a single-server, finite queue with a batch arrival option and user priorities. The scheme is implemented in the Network Simulator (NS-2), and the results demonstrate reduced queuing delays and efficient bandwidth allocation for time-critical data over non time critical data. In the second part, we introduce a unique mobility verification problem in wireless sensor networks wherein the objective is to verify the claimed mobility path of a node in a co-operating mission critical operation between two allies. We address this problem by developing an efficient power-control based mobility verification model. The simulation framework is implemented in Matlab and the results indicate successful detection of altered claimed paths within a certain error bound --Abstract, page iii

A Distributed Power Control MAC Protocol for Wireless Ad-hoc Networks.

A novel distributed power control (DPC)⋅ scheme and a MAC protocol for wireless ad hoc networks in the presence of radio channel uncertainties such as path loss, Shadowing and Rayleigh fading is presented. The DPC quickly estimates the time-varying nature of the channel and uses the information to select a suitable transmitter power value in order to maintain a target Signal-to-Interference ratio (SIR) at the receiver. The standard assumption of a constant interference during a link\u27s power update used in other works is relaxed. The performance of the proposed DPC is demonstrated analytically. The power used for all RTS-CTS-DATA-ACK frames is selected using the proposed DPC; hence, energy savings and spatial reuse are achieved. The hidden-terminal problem is overcome by periodically increasing the power. The NS simulator is used to compare the proposed scheme with 802.11. The proposed MAC protocol renders a significant increase in throughput in the presence of channel variations compared with 802.11 while consuming low energy per bit

Energy efficient wireless sensor network protocols for monitoring and prognostics of large scale systems

In this work, energy-efficient protocols for wireless sensor networks (WSN) with applications to prognostics are investigated. Both analytical methods and verification are shown for the proposed methods via either hardware experiments or simulation. This work is presented in five papers. Energy-efficiency methods for WSN include distributed algorithms for i) optimal routing, ii) adaptive scheduling, iii) adaptive transmission power and data-rate control --Abstract, page iv

Quality of service-aware routing and admission control for mobile ad hoc networks

EThOS - Electronic Theses Online ServiceGBUnited Kingdo