Robot computer problem solving system

The conceptual, experimental, and practical phases of developing a robot computer problem solving system are outlined. Robot intelligence, conversion of the programming language SAIL to run under the THNEX monitor, and the use of the network to run several cooperating jobs at different sites are discussed

Survey of Routing Algorithms for Computer Networks

This thesis gives a general discussion of routing for computer networks, followed by an overview of a number of typical routing algorithms used or reported in the past few years. Attention is mainly focused on distributed adaptive routing algorithms for packet switching (or message switching) networks. Algorithms for major commercial networks (or network architectures) are reviewed as well, for the convenience of comparison

The battle between standards: TCP/IP vs OSI victory through path dependency or by quality?

Between the end of the 1970s and 1994 a fierce competition existed between two possible standards, TCP/IP and OSI, to solve the problem of interoperability of computer networks. Around 1994 it became evident that TCP/IP and not OSI had become the dominant standard. We specifically deal with the question whether the current dominance of the TCP/IP standard is the result of third degree path dependency or of choices based on assessments of it being technical-economically superior to the OSI standard and protocols

Analysis of adaptive algorithms for an integrated communication network

Techniques were examined that trade communication bandwidth for decreased transmission delays. When the network is lightly used, these schemes attempt to use additional network resources to decrease communication delays. As the network utilization rises, the schemes degrade gracefully, still providing service but with minimal use of the network. Because the schemes use a combination of circuit and packet switching, they should respond to variations in the types and amounts of network traffic. Also, a combination of circuit and packet switching to support the widely varying traffic demands imposed on an integrated network was investigated. The packet switched component is best suited to bursty traffic where some delays in delivery are acceptable. The circuit switched component is reserved for traffic that must meet real time constraints. Selected packet routing algorithms that might be used in an integrated network were simulated. An integrated traffic places widely varying workload demands on a network. Adaptive algorithms were identified, ones that respond to both the transient and evolutionary changes that arise in integrated networks. A new algorithm was developed, hybrid weighted routing, that adapts to workload changes

Connecting remote systems for demonstration of automation technologies

An initial estimate of the communications requirements of the Systems Autonomy Demonstration Project (SADP) development and demonstration environments is presented. A proposed network paradigm is developed, and options for network topologies are explored

Protection and restoration algorithms for WDM optical networks

Currently, Wavelength Division Multiplexing (WDM) optical networks play a major role in supporting the outbreak in demand for high bandwidth networks driven by the Internet. It can be a catastrophe to millions of users if a single optical fiber is somehow cut off from the network, and there is no protection in the design of the logical topology for a restorative mechanism. Many protection and restoration algorithms are needed to prevent, reroute, and/or reconfigure the network from damages in such a situation. In the past few years, many works dealing with these issues have been reported. Those algorithms can be implemented in many ways with several different objective functions such as a minimization of protection path lengths, a minimization of restoration times, a maximization of restored bandwidths, etc. This thesis investigates, analyzes and compares the algorithms that are mainly aimed to guarantee or maximize the amount of remaining bandwidth still working over a damaged network. The parameters considered in this thesis are the routing computation and implementation mechanism, routing characteristics, recovering computation timing, network capacity assignment, and implementing layer. Performance analysis in terms of the restoration efficiency, the hop length, the percentage of bandwidth guaranteed, the network capacity utilization, and the blocking probability is conducted and evaluated

Design issues in quality of service routing

The range of applications and services which can be successfully deployed in packet-switched networks such as the Internet is limited when the network does nor provide Quality of Service (QoS). This is the typical situation in today's Internet. A key aspect in providing QoS support is the requirement for an optimised and intelligent mapping of customer traffic flows onto a physical network topology. The problem of selecting such paths is the task of QoS routing QoS routing algorithms are intrinsically complex and need careful study before being implemented in real networks. Our aim is to address some of the challenges present m the deployment of QoS routing methods. This thesis considers a number of practical limitations of existing QoS routing algorithms and presents solutions to the problems identified. Many QoS routing algorithms are inherently unstable and induce traffic fluctuations in the network. We describe two new routing algorithms which address this problem The first method - ALCFRA (Adaptive Link Cost Function Routing Algorithm) - can be used in networks with sparse connectivity, while the second algorithm - CAR (Connectivity Aware Routing) - is designed to work well in other network topologies. We also describe how to ensure co-operative interaction of the routing algorithms in multiple domains when hierarchial routing is used and also present a solution to the problems of how to provide QoS support m a network where not all nodes are QoS-aware. Our solutions are supported by extensive simulations over a wide range of network topologies and their performance is compared to existing algorithms. It is shown that our solutions advance the state of the art in QoS routing and facilitate the deployment of QoS support in tomorrow's Internet

Web page performance analysis

Computer systems play an increasingly crucial and ubiquitous role in human endeavour by carrying out or facilitating tasks and providing information and services. How much work these systems can accomplish, within a certain amount of time, using a certain amount of resources, characterises the systems’ performance, which is a major concern when the systems are planned, designed, implemented, deployed, and evolve. As one of the most popular computer systems, the Web is inevitably scrutinised in terms of performance analysis that deals with its speed, capacity, resource utilisation, and availability. Performance analyses for the Web are normally done from the perspective of the Web servers and the underlying network (the Internet). This research, on the other hand, approaches Web performance analysis from the perspective of Web pages. The performance metric of interest here is response time. Response time is studied as an attribute of Web pages, instead of being considered purely a result of network and server conditions. A framework that consists of measurement, modelling, and monitoring (3Ms) of Web pages that revolves around response time is adopted to support the performance analysis activity. The measurement module enables Web page response time to be measured and is used to support the modelling module, which in turn provides references for the monitoring module. The monitoring module estimates response time. The three modules are used in the software development lifecycle to ensure that developed Web pages deliver at worst satisfactory response time (within a maximum acceptable time), or preferably much better response time, thereby maximising the efficiency of the pages. The framework proposes a systematic way to understand response time as it is related to specific characteristics of Web pages and explains how individual Web page response time can be examined and improved