559 research outputs found
Hybrid Precoder and Combiner Design with Low Resolution Phase Shifters in mmWave MIMO Systems
Millimeter wave (mmWave) communications have been considered as a key
technology for next generation cellular systems and Wi-Fi networks because of
its advances in providing orders-of-magnitude wider bandwidth than current
wireless networks. Economical and energy efficient analog/digial hybrid
precoding and combining transceivers have been often proposed for mmWave
massive multiple-input multiple-output (MIMO) systems to overcome the severe
propagation loss of mmWave channels. One major shortcoming of existing
solutions lies in the assumption of infinite or high-resolution phase shifters
(PSs) to realize the analog beamformers. However, low-resolution PSs are
typically adopted in practice to reduce the hardware cost and power
consumption. Motivated by this fact, in this paper, we investigate the
practical design of hybrid precoders and combiners with low-resolution PSs in
mmWave MIMO systems. In particular, we propose an iterative algorithm which
successively designs the low-resolution analog precoder and combiner pair for
each data stream, aiming at conditionally maximizing the spectral efficiency.
Then, the digital precoder and combiner are computed based on the obtained
effective baseband channel to further enhance the spectral efficiency. In an
effort to achieve an even more hardware-efficient large antenna array, we also
investigate the design of hybrid beamformers with one-bit resolution (binary)
PSs, and present a novel binary analog precoder and combiner optimization
algorithm with quadratic complexity in the number of antennas. The proposed
low-resolution hybrid beamforming design is further extended to multiuser MIMO
communication systems. Simulation results demonstrate the performance
advantages of the proposed algorithms compared to existing low-resolution
hybrid beamforming designs, particularly for the one-bit resolution PS
scenario
Hybrid Beamforming for Large Antenna Arrays with Phase Shifter Selection
This paper proposes an asymptotically optimal hybrid beamforming solution for
large antenna arrays by exploiting the properties of the singular vectors of
the channel matrix. It is shown that the elements of the channel matrix with
Rayleigh fading follow a normal distribution when large antenna arrays are
employed. The proposed beamforming algorithm is effective in both sparse and
rich propagation environments, and is applicable for both point-to-point and
multiuser scenarios. In addition, a closed-form expression and a lower-bound
for the achievable rates are derived when analog and digital phase shifters are
employed. It is shown that the performance of the hybrid beamformers using
phase shifters with more than 2-bits resolution is comparable with analog phase
shifting. A novel phase shifter selection scheme that reduces the power
consumption at the phase shifter network is proposed when the wireless channel
is modeled by Rayleigh fading. Using this selection scheme, the spectral
efficiency can be increased as the power consumption in the phase shifter
network reduces. Compared to the scenario that all of the phase shifters are in
operation, the simulation results indicate that the spectral efficiency
increases when up to 50% of phase shifters are turned off.Comment: Accepted to Transactions on Wireless Communications, 201
Multiuser Precoding and Channel Estimation for Hybrid Millimeter Wave MIMO Systems
In this paper, we develop a low-complexity channel estimation for hybrid
millimeter wave (mmWave) systems, where the number of radio frequency (RF)
chains is much less than the number of antennas equipped at each transceiver.
The proposed channel estimation algorithm aims to estimate the strongest
angle-of-arrivals (AoAs) at both the base station (BS) and the users. Then all
the users transmit orthogonal pilot symbols to the BS via these estimated
strongest AoAs to facilitate the channel estimation. The algorithm does not
require any explicit channel state information (CSI) feedback from the users
and the associated signalling overhead of the algorithm is only proportional to
the number of users, which is significantly less compared to various existing
schemes. Besides, the proposed algorithm is applicable to both non-sparse and
sparse mmWave channel environments. Based on the estimated CSI, zero-forcing
(ZF) precoding is adopted for multiuser downlink transmission. In addition, we
derive a tight achievable rate upper bound of the system. Our analytical and
simulation results show that the proposed scheme offer a considerable
achievable rate gain compared to fully digital systems, where the number of RF
chains equipped at each transceiver is equal to the number of antennas.
Furthermore, the achievable rate performance gap between the considered hybrid
mmWave systems and the fully digital system is characterized, which provides
useful system design insights.Comment: 6 pages, accepted for presentation, ICC 201
- …