32,874 research outputs found
Low power techniques for video compression
This paper gives an overview of low-power techniques proposed in the literature for mobile multimedia and Internet applications. Exploitable aspects are discussed in the behavior of different video compression tools. These power-efficient solutions are then classified by synthesis domain and level of abstraction. As this paper is meant to be a starting point for further research in the area, a lowpower hardware & software co-design methodology is outlined in the end as a possible scenario for video-codec-on-a-chip implementations on future mobile multimedia platforms
Recommended from our members
Data-dependent cycle-accurate power modeling of RTL-level IPs using machine learning
In a chip design project, early design planning has a strong impact on the schedule and the cost of design. Power estimation is part of early design planning, and it greatly affects design decisions. Power modeling performed at a high level of abstraction is fast but inaccurate due to lack of circuit switching activity information. By contrast, power modeling performed at a low level of abstraction is more accurate as the synthesized circuit synthesis is known, but this simulation is typically slow. This report explores a power modeling approach performed at register transfer level (RTL). It exploits machine learning models in order to have a fast yet relatively accurate cycle-by-cycle power estimation. The approach is data-dependent, where cycle-specific models are trained based on the switching activity of signals obtained from RTL simulation and cycle-by-cycle power values obtained from a reference gate-level simulation of an existing RTL design. Therefore, if any changes are applied to the RTL design, re-training of models is required. The approach aims at obtaining fast yet accurate power predictions for new invocations of a given trained model using signal activity information collected during simulation of the unmodified RTL. At a low level, the complete visibility of signals in a design unintuitively might cause overtraining the model leading to inaccurate estimation. The suggested model employs automatic feature selection in each cycle. Based on the invocations used to train the cycle-by-cycle models, only signals that may switch during a given cycle will be selected as the features for their respective cycle-specific model. The method was tested on an 8-by-8 DCT design and the power estimates were within 6.5% of those from a commercial power analysis tool. This report also simulates and compares the approach of cycle-specific models to the approach of a single global model for all cycles and show that the cycle-specific approach is twice as accurate.Electrical and Computer Engineerin
An Energy and Performance Exploration of Network-on-Chip Architectures
In this paper, we explore the designs of a circuit-switched router, a wormhole router, a quality-of-service (QoS) supporting virtual channel router and a speculative virtual channel router and accurately evaluate the energy-performance tradeoffs they offer. Power results from the designs placed and routed in a 90-nm CMOS process show that all the architectures dissipate significant idle state power. The additional energy required to route a packet through the router is then shown to be dominated by the data path. This leads to the key result that, if this trend continues, the use of more elaborate control can be justified and will not be immediately limited by the energy budget. A performance analysis also shows that dynamic resource allocation leads to the lowest network latencies, while static allocation may be used to meet QoS goals. Combining the power and performance figures then allows an energy-latency product to be calculated to judge the efficiency of each of the networks. The speculative virtual channel router was shown to have a very similar efficiency to the wormhole router, while providing a better performance, supporting its use for general purpose designs. Finally, area metrics are also presented to allow a comparison of implementation costs
Energy Model of Networks-on-Chip and a Bus
A Network-on-Chip (NoC) is an energy-efficient onchip communication architecture for Multi-Processor Systemon-Chip (MPSoC) architectures. In earlier papers we proposed two Network-on-Chip architectures based on packet-switching and circuit-switching. In this paper we derive an energy model for both NoC architectures to predict their energy consumption per transported bit. Both architectures are also compared with a traditional bus architecture. The energy model is primarily needed to find a near optimal run-time mapping (from an energy point of view) of inter-process communication to NoC link
Event-based Vision: A Survey
Event cameras are bio-inspired sensors that differ from conventional frame
cameras: Instead of capturing images at a fixed rate, they asynchronously
measure per-pixel brightness changes, and output a stream of events that encode
the time, location and sign of the brightness changes. Event cameras offer
attractive properties compared to traditional cameras: high temporal resolution
(in the order of microseconds), very high dynamic range (140 dB vs. 60 dB), low
power consumption, and high pixel bandwidth (on the order of kHz) resulting in
reduced motion blur. Hence, event cameras have a large potential for robotics
and computer vision in challenging scenarios for traditional cameras, such as
low-latency, high speed, and high dynamic range. However, novel methods are
required to process the unconventional output of these sensors in order to
unlock their potential. This paper provides a comprehensive overview of the
emerging field of event-based vision, with a focus on the applications and the
algorithms developed to unlock the outstanding properties of event cameras. We
present event cameras from their working principle, the actual sensors that are
available and the tasks that they have been used for, from low-level vision
(feature detection and tracking, optic flow, etc.) to high-level vision
(reconstruction, segmentation, recognition). We also discuss the techniques
developed to process events, including learning-based techniques, as well as
specialized processors for these novel sensors, such as spiking neural
networks. Additionally, we highlight the challenges that remain to be tackled
and the opportunities that lie ahead in the search for a more efficient,
bio-inspired way for machines to perceive and interact with the world
- âŠ