A 10Gb/s data-dependent jitter equalizer

An equalization circuit is presented that reduces data-dependent jitter by aligning data transition deviations. This paper presents an analytic solution to data-dependent jitter and demonstrates its impact on the phase noise of the recovered clock. A data-dependent jitter equalizer is presented that compensates for impairment of the channel and lowers the phase noise of the recovered clock. The circuit is implemented in a SiGe BiCMOS process and operates at 10 Gb/s. It suppresses phase noise resulting from data-dependent jitter by 10 dB

Reduction of 1/f Noise in MOSFETS by Switched Bias Techniques

Switched Biasing is presented as a technique for reducing the 1/f noise in MOSFETS. It exploits an intriguing physical effect: cycling a MOS transistor from strong inversion to accumulation reduces its 1/f noise!! The history of the discovery of the effect and the main experimental results obtained so far will be reviewed

All-optical pulse reshaping and retiming systems incorporating pulse shaping fiber Bragg grating

This paper demonstrates two optical pulse retiming and reshaping systems incorporating superstructured fiber Bragg gratings (SSFBGs) as pulse shaping elements. A rectangular switching window is implemented to avoid conversion of the timing jitter on the original data pulses into pulse amplitude noise at the output of a nonlinear optical switch. In a first configuration, the rectangular pulse generator is used at the (low power) data input to a nonlinear optical loop mirror (NOLM) to perform retiming of an incident noisy data signal using a clean local clock signal to control the switch. In a second configuration, the authors further amplify the data signal and use it to switch a (low power) clean local clock signal. The S-shaped nonlinear characteristic of the NOLM results in this instance in a reduction of both timing and amplitude jitter on the data signal. The underlying technologies required for the implementation of this technique are such that an upgrade of the scheme for the regeneration of ultrahigh bit rate signals at data rates in excess of 320 Gb/s should be achievable

Analysis and equalization of data-dependent jitter

Data-dependent jitter limits the bit-error rate (BER) performance of broadband communication systems and aggravates synchronization in phase- and delay-locked loops used for data recovery. A method for calculating the data-dependent jitter in broadband systems from the pulse response is discussed. The impact of jitter on conventional clock and data recovery circuits is studied in the time and frequency domain. The deterministic nature of data-dependent jitter suggests equalization techniques suitable for high-speed circuits. Two equalizer circuit implementations are presented. The first is a SiGe clock and data recovery circuit modified to incorporate a deterministic jitter equalizer. This circuit demonstrates the reduction of jitter in the recovered clock. The second circuit is a MOS implementation of a jitter equalizer with independent control of the rising and falling edge timing. This equalizer demonstrates improvement of the timing margins that achieve 10/sup -12/ BER from 30 to 52 ps at 10 Gb/s

Time Domain Simulations of Arm Locking in LISA

Arm locking is a technique that has been proposed for reducing laser frequency fluctuations in the Laser Interferometer Space Antenna (LISA), a gravitational-wave observatory sensitive in the milliHertz frequency band. Arm locking takes advantage of the geometric stability of the triangular constellation of three spacecraft that comprise LISA to provide a frequency reference with a stability in the LISA measurement band that exceeds that available from a standard reference such as an optical cavity or molecular absorption line. We have implemented a time-domain simulation of arm locking including the expected limiting noise sources (shot noise, clock noise, spacecraft jitter noise, and residual laser frequency noise). The effect of imperfect a priori knowledge of the LISA heterodyne frequencies and the associated 'pulling' of an arm locked laser is included. We find that our implementation meets requirements both on the noise and dynamic range of the laser frequency.Comment: Revised to address reviewer comments. Accepted by Phys. Rev.

Synchronization and Characterization of an Ultra-Short Laser for Photoemission and Electron-Beam Diagnostics Studies at a Radio Frequency Photoinjector

A commercially-available titanium-sapphire laser system has recently been installed at the Fermilab A0 photoinjector laboratory in support of photoemission and electron beam diagnostics studies. The laser system is synchronized to both the 1.3-GHz master oscillator and a 1-Hz signal use to trigger the radiofrequency system and instrumentation acquisition. The synchronization scheme and performance are detailed. Long-term temporal and intensity drifts are identified and actively suppressed to within 1 ps and 1.5%, respectively. Measurement and optimization of the laser's temporal profile are accomplished using frequency-resolved optical gating.Comment: 16 pages, 17 figures, Preprint submitted to Elsevie

Programmable rate modem utilizing digital signal processing techniques

The engineering development study to follow was written to address the need for a Programmable Rate Digital Satellite Modem capable of supporting both burst and continuous transmission modes with either binary phase shift keying (BPSK) or quadrature phase shift keying (QPSK) modulation. The preferred implementation technique is an all digital one which utilizes as much digital signal processing (DSP) as possible. Here design tradeoffs in each portion of the modulator and demodulator subsystem are outlined, and viable circuit approaches which are easily repeatable, have low implementation losses and have low production costs are identified. The research involved for this study was divided into nine technical papers, each addressing a significant region of concern in a variable rate modem design. Trivial portions and basic support logic designs surrounding the nine major modem blocks were omitted. In brief, the nine topic areas were: (1) Transmit Data Filtering; (2) Transmit Clock Generation; (3) Carrier Synthesizer; (4) Receive AGC; (5) Receive Data Filtering; (6) RF Oscillator Phase Noise; (7) Receive Carrier Selectivity; (8) Carrier Recovery; and (9) Timing Recovery

VHF command system study

Solutions are provided to specific problems arising in the GSFC VHF-PSK and VHF-FSK Command Systems in support of establishment and maintenance of Data Systems Standards. Signal structures which incorporate transmission on the uplink of a clock along with the PSK or FSK data are considered. Strategies are developed for allocating power between the clock and data, and spectral analyses are performed. Bit error probability and other probabilities pertinent to correct transmission of command messages are calculated. Biphase PCM/PM and PCM/FM are considered as candidate modulation techniques on the telemetry downlink, with application to command verification. Comparative performance of PCM/PM and PSK systems is given special attention, including implementation considerations. Gain in bit error performance due to coding is also considered