Frequency Synthesis in Wireless and Wireline Systems

First, a frequency synthesizer for IEEE 802.15.4 / ZigBee transceiver applications that employs dynamic True Single Phase Clocking (TSPC) circuits in its frequency dividers is presented and through the analysis and measurement results of this synthesizer, the need for low power circuit techniques in frequency dividers is discussed. Next, Differential Cascode Voltage-Switch-Logic (DCVSL) based delay cells are explored for implementing radio-frequency (RF) frequency dividers of low power frequency synthesizers. DCVSL ip- ops offer small input and clock capacitance which makes the power consumption of these circuits and their driving stages, very low. We perform a delay analysis of DCVSL circuits and propose a closed-form delay model that predicts the speed of DCVSL circuits with 8 percent worst case accuracy. The proposed delay model also demonstrates that DCVSL circuits suffer from a large low-to-high propagation delay ( PLH) which limits their speed and results in asymmetrical output waveforms. Our proposed enhanced DCVSL, which we call DCVSL-R, solves this delay bottleneck, reducing PLH and achieving faster operation. We implement two ring-oscillator-based voltage controlled oscillators (VCOs) in 0.13 mu m technology with DCVSL and DCVSL-R delay cells. In measurements, for the same oscillation frequency (2.4GHz) and same phase noise (-113dBc/Hz at 10MHz), DCVSL-R VCO consumes 30 percent less power than the DCVSL VCO. We also use the proposed DCVSL-R circuit to implement the 2.4GHz dual-modulus prescaler of a low power frequency synthesizer in 0.18 mu m technology. In measurements, the synthesizer exhibits -135dBc/Hz phase noise at 10MHz offset and 58 mu m settling time with 8.3mW power consumption, only 1.07mWof which is consumed by the dual modulus prescaler and the buffer that drives it. When compared to other dual modulus prescalers with similar division ratios and operating frequencies in literature, DCVSL-R dual modulus prescaler demonstrates the lowest power consumption. An all digital phase locked loop (ADPLL) that operates for a wide range of frequencies to serve as a multi-protocol compatible PLL for microprocessor and serial link applications, is presented. The proposed ADPLL is truly digital and is implemented in a standard complementary metal-oxide-semiconductor (CMOS) technology without any analog/RF or non-scalable components. It addresses the challenges that come along with continuous wide range of operation such as stability and phase frequency detection for a large frequency error range. A proposed multi-bit bidirectional smart shifter serves as the digitally controlled oscillator (DCO) control and tunes the DCO frequency by turning on/off inverter units in a large row/column matrix that constitute the ring oscillator. The smart shifter block is completely digital, consisting of standard cell logic gates, and is capable of tracking the row/column unit availability of the DCO and shifting multiple bits per single update cycle. This enables fast frequency acquisition times without necessitating dual loop fi lter or gear shifting mechanisms. The proposed ADPLL loop architecture does not employ costly, cumbersome DACs or binary to thermometer converters and minimizes loop filter and DCO control complexity. The wide range ADPLL is implemented in 90nm digital CMOS technology and has a 9-bit TDC, the output of which is processed by a 10-bit digital loop filter and a 5-bit smart shifter. In measurements, the synthesizer achieves 2.5GHz-7.3GHz operation while consuming 10mW/GHz power, with an active area of 0.23 mm2

Générateur distribué d'horloge pour puces globalement et localement synchrones de grande taille

This thesis addresses the problem of global synchronization of large system on chip (SoC). It focuses on the study of an alternative clock generation technique to conventional clock distribution and asynchronous communication. It allows implementation of highly reliable synchronous circuit. My PhD project aims to study and implement a large network (10x10) of all digital phase-locked loop (ADPLL), containing 100 nodes generating a clock for each local digital circuitry. The prototype was implemented on silicon generating clocks in the range 903-1161 MHz. It highlights a maximum phase error of less than 40 ps between two clocks in any neighboring zones. Another important result is the analysis of phase error between two non-neighboring oscillators in distance. By studying an FPGA prototype of the network, we obtained that maximum phase error at steady state between any clock signal and the reference signal is less than three steps of the PFD quantification steps. In order to validate the performance of synchronization in ASIC, we designed an on-chip clocking error measurement circuit. This circuit has a low rate for the off-chip readout (several MHz), and a high resolution (+-2.5 ps). Reconfigurability is another attractive feature. We have explored this feature and proposed a novel topology with different configurations for nodes on the border and in the kernel of the network. This topology has an advantage in prohibiting phase error propagation and reflection.Cette thèse aborde le problème de la synchronisation globale de grand système sur puce (SoC). Il est centré sur l'étude d'une technique de remplacement de la distribution d'horloge classique et d'une communication asynchrone. Il permet la mise en œuvre de circuit synchrone très fiable. Mon projet de thèse vise à étudier et mettre en œuvre un vaste réseau (10x10) de boucle à verrouillage de phase tous numérique (ADPLL), contenant 100 nœuds générant une horloge pour chaque circuit numérique local. Le prototype a été réalisé sur les horloges de génération de silicium dans la gamme de 903-1161 MHz. Elle met en évidence une erreur de phase maximale de moins de 40 ps entre deux horloges dans toutes les zones voisines. Un autre résultat important est l'analyse de l'erreur de phase entre les deux oscillateurs non-voisins dans la distance. En étudiant un prototype FPGA du réseau, on a obtenu que l'erreur de phase maximale à l'état d'équilibre entre un signal d'horloge et le signal de référence est inférieur à trois étapes des étapes de quantification PFD. Afin de valider les performances de la synchronisation dans ASIC, nous avons conçu un circuit d'une erreur de mesure sur la puce d'horloge. Ce circuit a un taux faible de la lecture hors puce (quelques MHz), et une résolution élevée (+ -2,5 ps). Reconfiguration constitue une autre caractéristique intéressante. Nous avons exploré cette fonction et a proposé une nouvelle topologie avec des configurations différentes pour les nœuds sur la frontière et dans le noyau du réseau. Cette topologie présente un avantage en interdisant la propagation des erreurs de phase et de réflexion