Adaptive Multi-state Millimeter Wave Cell Selection Scheme for 5G communication

Millimeter wave bands have been introduced as one of the most promising solutions to alleviate the spectrum secrecy in the upcoming future cellular technology (5G) due the enormous amount of raw bandwidth available in these bands. However, the inherent propagation characteristics of mmWave frequencies could impose new challenges i.e. higher path loss, atmospheric absorption, and rain attenuation which in turn increase the outage probability and hence, degrading the overall system performance. Therefore, in this paper, a novel flexible scheme is proposed namely Adaptive Multi-State MmWave Cell Selection (AMSMC-S) through adopting three classes of mmWave base stations, able to operate at various mmWave carrier frequencies (73, 38 and 28 GHz). Two mmWave cellular Grid-Based cell deployment scenarios have been implemented with two inter-site-distances 200 m and 300 m, corresponding to target area of (2.1 km2) and (2.2 km2). The maximum SINR value at the user equipment (UE) is taken in to consideration to enrich the mobile user experience. Numerical results show an improvement of overall system performance, where the outage probability reduced significantly to zero while maintaining an acceptable performance of the 5G systems with approximately more than 50% of the mobile stations with more than 1Gbps data rate.

Performance Comparison of Dual Connectivity and Hard Handover for LTE-5G Tight Integration in mmWave Cellular Networks

MmWave communications are expected to play a major role in the Fifth generation of mobile networks. They offer a potential multi-gigabit throughput and an ultra-low radio latency, but at the same time suffer from high isotropic pathloss, and a coverage area much smaller than the one of LTE macrocells. In order to address these issues, highly directional beamforming and a very high-density deployment of mmWave base stations were proposed. This Thesis aims to improve the reliability and performance of the 5G network by studying its tight and seamless integration with the current LTE cellular network. In particular, the LTE base stations can provide a coverage layer for 5G mobile terminals, because they operate on microWave frequencies, which are less sensitive to blockage and have a lower pathloss. This document is a copy of the Master's Thesis carried out by Mr. Michele Polese under the supervision of Dr. Marco Mezzavilla and Prof. Michele Zorzi. It will propose an LTE-5G tight integration architecture, based on mobile terminals' dual connectivity to LTE and 5G radio access networks, and will evaluate which are the new network procedures that will be needed to support it. Moreover, this new architecture will be implemented in the ns-3 simulator, and a thorough simulation campaign will be conducted in order to evaluate its performance, with respect to the baseline of handover between LTE and 5G.Comment: Master's Thesis carried out by Mr. Michele Polese under the supervision of Dr. Marco Mezzavilla and Prof. Michele Zorz

Millimetre wave frequency band as a candidate spectrum for 5G network architecture : a survey

In order to meet the huge growth in global mobile data traffic in 2020 and beyond, the development of the 5th Generation (5G) system is required as the current 4G system is expected to fall short of the provision needed for such growth. 5G is anticipated to use a higher carrier frequency in the millimetre wave (mm-wave) band, within the 20 to 90 GHz, due to the availability of a vast amount of unexploited bandwidth. It is a revolutionary step to use these bands because of their different propagation characteristics, severe atmospheric attenuation, and hardware constraints. In this paper, we carry out a survey of 5G research contributions and proposed design architectures based on mm-wave communications. We present and discuss the use of mm-wave as indoor and outdoor mobile access, as a wireless backhaul solution, and as a key enabler for higher order sectorisation. Wireless standards such as IEE802.11ad, which are operating in mm-wave band have been presented. These standards have been designed for short range, ultra high data throughput systems in the 60 GHz band. Furthermore, this survey provides new insights regarding relevant and open issues in adopting mm-wave for 5G networks. This includes increased handoff rate and interference in Ultra-Dense Network (UDN), waveform consideration with higher spectral efficiency, and supporting spatial multiplexing in mm-wave line of sight. This survey also introduces a distributed base station architecture in mm-wave as an approach to address increased handoff rate in UDN, and to provide an alternative way for network densification in a time and cost effective manner