Functionally graded aluminium matrix composites reinforced with SiC particles are attractive materials for a broad range of engineering applications in the automotive, aircraft, sports, military and aerospace industries, whenever a superior combination of surface and bulk mechanical properties are required. In general, these materials are developed for the production of high wear resistant components. Also, often this kind of mechanical part operates in the presence of aggressive environments, such as marine atmospheres. In this work, aluminium composites with functionally graded properties, obtained by centrifugal cast, are characterised by reciprocating pin-on-plate sliding wear tests against nodular cast iron. Three different volume fractions of SiC reinforcing particles in each functionally graded material were considered. Sliding experiments were performed with and without the presence of a lubricant (3% NaCl aqueous solution). All tests were carried out at room temperature, under a normal load of 10N and constant frequency (1 Hz) and stroke (6 mm). In the case of the lubricated tests, electrochemical parameters (corrosion potential) were monitored during sliding. The worn surfaces as well as the wear debris were characterised by SEM/EDS.
Friction values were in the order of 0.42 for unlubricated conditions, but varied between 0.22 and 0.37 when the aqueous solution was present. Relatively high wear rates (over 110-6 gm-1) were obtained in both unlubricated and lubricated sliding. The volume fraction of SiC particles exerted a net effect on the tribological response of the composites, although conditioned by the presence or absence of the aqueous solution. A deleterious effect of the chloride aqueous solution on the degradation of the matrix, leading to the pull-out of SiC particles induced by the dissolution of the matrix/particle interface was evidenced. Observation of the worn surface morphology indicated that the presence of the lubricant modifies the protective action promoted by the combined effect of the presence of reinforcing particles as load bearing elements and the formation of adherent iron-rich tribolayers. The evolution of the corrosion potential during the sliding action is in accordance to the degradation mechanisms proposed for these systems.(undefined
