Benke M

Pait TG


OBJECTIVE
The segmental occipital condyle screw (OCS) is an alternative fixation technique in occipitocervical fusion. A thorough morphological study of the occipital condyle (OC) is critical for OCS placement. The authors set out to introduce a more precise CT-based method for morphometric analysis of the OC as it pertains to the placement of the segmental OCS, and they describe a novel preoperative simulation method for screw placement. Two new clinically relevant parameters, the height available for the OCS and the warning depth, are proposed.

METHODS
CT data sets from 27 fresh-frozen human cadaveric occipitocervical spines were used. All measurements were performed using a commercially available 3D reconstruction software package. The length, width, and sagittal angle of the condyle were measured in the axial plane at the base of the OC. The height of the OC and the height available for the segmental OCS were measured in the reconstructed oblique sagittal plane, fitting the ideal trajectory of the OCS recommended in the literature. The placement of a 3.5-mm-diameter screw that had the longest length of bicortical purchase was simulated into the OC in the oblique sagittal plane, with the screw path not being blocked by the occiput and not violating the hypoglossal canal cranially or the atlantooccipital joint caudally. The length of the simulated screw was recorded. The warning depth was measured as the shortest distance from the entry point of the screw to the posterior border of the hypoglossal canal.

RESULTS
The mean length and width of the OC were found to be larger in males: 22.2 ± 1.7 mm and 12.1 ± 1.0 mm, respectively, overall (p &lt; 0.0001 for both). The mean sagittal angle was 28.0° ± 4.9°. The height available for the OCS was significantly less than the height of the OC (6.2 ± 1.3 mm vs 9.4 ± 1.5 mm, p &lt; 0.0001). The mean screw length (19.3 ± 1.9 mm) also presented significant sex-related differences: male greater than female (p = 0.0002). The mean warning depth was 7.5 ± 1.7 mm. In 7.4% of the samples, although the height of the OC was viable, the height available for the OCS was less than 4.5 mm, thus making screw placement impractical. For these cases, a new preoperative simulation method of the OCS placement was proposed. In 92.6% of the samples that could accommodate a 3.5-mm-diameter screw, 24.0% showed that the entry point of the simulated screw was covered by a small part of the C-1 posterosuperior joint rim.

CONCLUSIONS
The placement of the segmental OCS is feasible in most cases, but a thorough preoperative radiological analysis is essential and cannot be understated. The height available for the OCS is a more clinically relevant and precise parameter than the height of the OC to enable proper screw placement. The warning depth may be helpful for the placement of the OCS.</jats:sec

Jinsong Zhou

Alejandro A. Espinoza Orías

Xia Kang

Jade He

Zhihai Zhang

Nozomu Inoue

Howard S. An

Crossref

Journal of Neurosurgery Spine

CT-based morphometric analysis of the occipital condyle: focus on occipital condyle screw insertion

CT-based morphometric analysis of the occipital condyle: focus on occipital condyle screw insertion

Abstract

Similar works

Full text

Available Versions

Crossref