Szczepański, Piotr

Wódzki, Romuald

English

Repository of Nicolaus Copernicus University

 XVI-th ARS SEPARATORIA – Borówno, Poland 2001   SIMPLE KINETIC ANALYSIS OF CONTINUOUS MEMBRANE EXTRACTION  Piotr SZCZEPAŃSKI and Romuald WÓDZKI   Faculty of Chemistry, Nicholas Copernicus University, 87-100 Toruń, Poland e-mail: piotrs@chem.uni.torun.pl   INTRODUCTION  The scheme of consecutive reactions has been applied for describing the recovery of Cu2+ in a continuous membrane extraction (CME) process. The procedure is facilitated by an extractant/carrier dissolved in an organic phase (liquid membrane) whereas the interfacial extraction and re-extraction processes are mediated by the polymer cation-exchange membranes located between the liquid membrane and the feed (f) and stripping (s) solution respectively. The overall process can be roughly represented by a simple scheme involving irreversible reactions of the first order:  skLMkf MMM 21 →→      (1)  In Eq.(1) Mf, MLM, and Ms denote the metal cation in the feed, liquid membrane (complexed by the carrier) and stripping solution respectively. According to Eq.(1) the corresponding kinetics can be expressed by the set of first order differential equations, which after integration result in Eq.(2-4) representing the time evolution of reduced concentrations (R) [1,2] of M species in each of the system compartment (i.e. the feed, membrane system and stripping solution):   Rf = tk1e ⋅−        (2) RLM = )ee(kkk tktk121 21 ⋅−⋅− −−    (3) Rs = 1+ )ekek(kk1 tk1tk22121 ⋅−⋅− −−    (4)  In Eqs.(2-3), the reduced concentrations are defined as follows:  Rf = Cf/Cf,0, RLM = CLM/Cf,0,  Rs = Cs/Cf,0,   (5)   XVI-th ARS SEPARATORIA – Borówno, Poland 2001  where Cf,0 is the concentration of the metal cations in the feed at the time t=0, and Cf, CLM, Cs  are the time dependent concentrations of M in the particular solution.  The above phenomenological model was successfully applied to interpret the properties of several bulk liquid membranes in general [2,3], and the liquid membranes containing Acorga reagents in particular (for the Cu2+pertraction processes) [1,2-4]. Therefore, we have expected the model to be feasible also in the case of the CME as a more complex system. The main goal of this investigation was to answer the question how far the CME behaves as a classic liquid membrane system by comparing the values of respective kinetic constants to those reported in the literature. On the other hand, the comparison of k1 and k2 can indicate which of macroscopic processes limits the overall pertraction rate in the membrane system.   EXPERIMENTAL  The experiments were performed in the CME system composed of two contactors with the cation exchange membranes (FKS FuMa Tech, Germany) and the organic phase circulating between. The organic phase (250 cm3) was prepared from Acorga P-50 (94% 5-nonylsalicylaldoxime, Acorga Ltd.) dissolved in technical kerosene (Maker, Poland, b.p. 124-174 0C) to the concentration of 0.1 mol/dm3. The liquid membrane was contacted to the cation exchange membranes of the area 200 cm2, each. The aqueous feed solution (10 dm3) contained Zn2+, Cu2+, Ca2+, Mg2+, Na+ and K+ nitrates, each of the concentration 0.01 mol/dm3. The sulfuric acid solution (0.5, 1, 3 mol/dm3, 100 cm3) has been applied as the stripping phase in the CME system.  RESULTS AND DISCUSSION  The curves representing the dependence of the metal concentrations in the feed and stripping solutions on time have been used as the primary experimental data. The respective membrane concentrations have been calculated using the mass balance equation. The experimental extraction and re-extraction data for Cu2+are presented in Figs. 1-3. They cover the time period up to 100 hr when the process was clearly nonstationary (dJ/dt≠0). After this time (100-800 hrs) the pertraction was observed to occur as a quasi-stationary process. The dependence of Cu2+ reduced concentrations a liquid membrane on time takes a characteristic shape indicating the following interrelations between the extraction (Jf) and re-extraction (Js) rates in time: Jf > Js → Jf = Js → Jf < Js. These relations trivially prove that the process at its beginning stage is limited by a slow re-extraction (due to the accumulation of Cu2+ in the organic phase and a lack of substrates for respective stripping reaction), and after passing a maximum with instantaneous equalization of the rates, the overall process, in turn, is limited  XVI-th ARS SEPARATORIA – Borówno, Poland 2001  by the slower extraction rate. This sequence has been experimentally observed as characteristic accumulation and depletion of Cu2+ cations in the liquid organic phase.                            The kinetic constants k1 and k2 weregression method An additional rate 212kkk212max kkkk−−⋅=   The values of particular rate constresulting from fitting procedure are lines. They agree sufficiently well wicase the squared correlation coeffipresented in Tab.2 show that theconcentration leads to the 6.5  foldconstant. At the same time only 2-fconstant was observed. These conconcentration of sulfuric acid in thtime [h]0 20 40 60 80reduced concentration R0.10.20.30.40.60.70.80.90.01.0time [h]0 20 40 60 80 100reduced concentration R0.10.20.30.40.60.70.80.90.01.0time [h]0 20 40 60 80 100 120 140 160reduced concentration R0.10.20.30.40.60.70.80.90.01.0Fig.1.Dependence of reduced concentrationsof Cu2+ in the CME components on thetime of pertraction: ( ) feed solution,(■) stripping solution, (!) liquidorganic phase. Dashed lines representthe curves calculated according to thefitted kinetic constants and model. Theconcentration of H2SO4 in the strippingsolution: (a) 0.5 mol/dm3 (b) 1 mol/dm3(c) 3 mol/dm3 (c). re calculated by applying a non-linear constant kmax has been calculated from:     (4) ants are listed in Tab.1. The curves drawn in respective figures as dashed th the experimental data giving in any cients higher than 0.94. The results  increase in the stripping solution  increase of the k2 re-extraction rate old increase of the k1 extraction rate stants increase with increasing the e stripping solution and seem to be  XVI-th ARS SEPARATORIA – Borówno, Poland 2001  correlated. However any independence of these apparent constants cannot be postulated because the extraction and re-extraction processes are additionally coupled by diffusion phenomena in the organic phase, which are not specified in the simple kinetic model. The assumption underlying the model calculations requires the homogeneous liquid membrane phase. However, diffusion phenomena create some gradients of concentration and the RLM used for calculations is only a respective integral and the real concentrations RLM at the strip and feed interface can be drastically different and time dependent [5]  Tab. 1. The apparent kinetic rate constants k1, k2 i kmax for continuous membrane extraction of Cu2+ as mediated by Acorga P-50  The comparison of the data in Tab.1 show that the kinetic constants for the CME process are approx. one order of magnitude lower than in the case of a classic process. This is a simple consequence of slow diffusion processes in the polymer phase of the cation exchange membranes. The kinetic constants k1 and k2 enabled us to calculate maximum rate of stripping (Jmax) according to Eq.(5).  Jmax = max, kCAV0fsf ⋅   (mol/cm2s)   (5) This rate amounts 3.77×10-10 mol/cm2s in the case of the extraction system with 0.5 mol/dm3 solution of H2SO4, and increases to 6.45×10-10 mol/cm2s and 9.93×10-10 for 1 mol/dm3 and 3 mol/dm3 H2SO4, respectively. After passing this maximum the stripping rates diminish step by step to zero value due to disappearing of driving forces for the overall process. In practice the kinetic model can be exploited to optimize time and operational conditions for the CME system. The practical application of any membrane system needs of stabile and continuous working that would be acceptable from a Concentration of the sulfuric acid in the stripping solution [mol/dm3] k1 [s-1] r2 k2 [s-1] r2 kmax [s-1] This work 0.5 1.32±0.14×10-6 0.938 2.11±0.19×10-6 0.942 6.02×10-7 1 1.55±0.02×10-6 0.999 7.61±0.64×10-6 0.983 1.03×10-6 3 2.27±0.06×10-6 0.996 1.37±0.06×10-5 0.994 1.59×10-6 Literature data Szpakowska et al. [6] 1.92-2.16×10-5  0.87-1.61×10-5 (BLM/kerosene) 1.14×10-4  6.9×10-5 (BLM/n-octane) Szpakowska [4] 4.16×10-5  8.33×10-7 (BLM/mesitylene)  XVI-th ARS SEPARATORIA – Borówno, Poland 2001  technological point of view. Therefore, the experiment has been prolonged in time to get an operation characteristic for 800 hrs of performance. The results presented in Fig.2 show that the kinetic model of consecutive reactions can be applied only in the first stage of the changes of Cu2+ concentrations in the system compartments. After gaining pseudo-stationary conditions the model based on the first order kinetic (or I-Ficks law for diffusion) is a better approximation for interpreting respective experimental data. Alternatively, a universal network-thermodynamic model generating the accumulation and depletion curves of the shape presented in Fig.2 can be applied as described elsewhere [5].               CONCLUSION  Taking together the results of experiments and calculations one can conclude that the simple phenomenological model represented by two adjustable parameters k1 and k2 is sufficient for describing Cu2+ pertraction phenomena, (mediated by Acorga P-50) in the continuous membrane extraction system operating under non-stationary conditions. The application of the model allows to predict time evolution of the system and to compare the system by the values of calculated kinetic rate constants. The comparison of CME with other membrane systems indicate that the presence of additional polymer membranes stabilizig the interfaces makes the interfacial processes lower by approx. one order of magnitude.  REFERENCES  [1] M.Szpakowska, Zeszyty Naukowe Politechniki Gdańskiej, Nr.35 (1997) p.26-29 [2] M.Szpakowska, B.Nagy, J.Phys.Chem. A, 103 (1999) 1553 [3] M. Kobya, N. Topcu, N. Demircioglu, J.Membrane Sci., 130 (1997) 7 [4] M.Szpakowska, J.Membrane Sci., 109 (1996) 77 [5] R.Wódzki, G.Sionkowski, Polish J.Chem., 69 (1995) 407 [6] M.Szpakowska, O.Nagy, J.Membrane Sci., 64 (1991) 129  Financial support of Nicholas Copernicus University, GRANT CH-320 time [h]0 200 400 600 800 1000reduced concentration R0.10.20.30.40.60.70.80.90.01.0Fig.2. Long-time extraction process of Cu2+ in the CME system. 

Simple kinetic analysis of continuous membrane extraction

https://repozytorium.umk.pl/bitstream/handle/item/4334/P45%20Ars%20Separatoria%202001.pdf?sequence=1

Simple kinetic analysis of continuous membrane extraction

Abstract

Similar works

Full text

Available Versions

Repository of Nicolaus Copernicus University