Solymosi, J.

English

Periodica Polytechnica (Budapest University of Technology and Economics)

THE MINIMUM LOSS OF IMPEDANCE MATCHING TWO-PORTS By J. SOLYMOSI Institute of Communication Electronics, Technical University, Budapest Received FebrucTv 27, 1979 Presented by Prof. Dr. S. CSIBI 1. Characterization of impedance matching two-ports Figure 1 shows a matching two-port terminated by generator impedailce Zs and load resistance R L • Generally, in the design of communication systems the task is to transfer power from a given source to a given load (for example Us, Zs and ZL=Ru or in the opposite direction). This problem often involves the design of a lossless matching two-port to transform the load impedance into the complex conjugate of the source impedance. This question was first considered by H. W. BODE [lJ for a restricted class of impedances. R. M.FANO [2J extended Bode's result to the case of an arbitrary passive impedance. D. C. Y OULA [3] dev.eloped an alternate theory which relied upon the normalized scattering parameters and bypasses some difficulties encountered in Fano's work. Youla's theory can be generalized to active impedances, too [4]. The problem mentioned before is the so-called broadband matching problem and it is practically solved. Sometimes a similar task arises, called the broad band impedance matching problem. In the ideal case of impedance matching Zlin =Zs=Rs+ jXs and Z2in=ZL =RL (Fig. 1). Such questions arise in wirebound telecommunication systems using transmission lines in frequency ranges where the characteristic impedance is frequency-dependent and undesirable reflections are to be avoided. Now, let us investigate some properties of impedance matching n~tworks. Suppose the matching two-port is a lossless one, therefore the normalized scattering matrix is uniter [5] which implies matching two-port Fig. 1. Matching two-port 42 J, SGLYMOSI 1511 1 = 1522 1 , 1512 1=1521 1, 151112+152112=1. (1.a) (1.b) (1.e) (5 11 and 522 are complex reflection coefficients, 512 and 521 are transmission coefficients). According to Fig. 1, for the ideal case we get: Z' s (2.a) (2.b) where * denotes the complex conjugate and <Ps= arc ZS' For example at low frequencies the phase of the characteristic impedance of a transmission line is re 1 <Pr::::: - - , i.e. 1 511 12::::: - . If the transmission line is connected through a lossless 4 2 matching two-port to an equipment with input impedance Rv the problem arises at the second port, because 1 522 1 = 1 511 1 (see Eq. 1.a), and at this po rt the normalized reflection coefficient is equivalent to' the impedance reflexion coefficient (R! = R 2 ) 522 ZZin-Zt ZZin-Rz r22 Z2in+ Z L Z2in+ R Z (3) 1 F or a rigorous specification a reflection attenuation of 20 19 -- = 3 dB is too 15221 low, therefore a lossy matching two-port is needed. One possibility for the circuit is given in Fig. 2 which is suitable for matching between transmission lines and equipments [6]. Fig. 2. Circuit for a possible impedance matching two-port THE MINIMUM LOSS 43 2. Calculation of the minium loss In the previous section, the impedance matching two-port was seen to be lossy having greater attenuation than a lossless circuit ifit is well matched. This is the lower limit of the attenuation. Taking this into account, according to Eq. l.c: (4) ? P2 1 In the case of <Pt';:::; - n/4, we have 1 S 121-=-=- namely, the half of the Po 2 available power is reflected. Of course, in using lossy elements, a part of the power will be dissipated, too, so the attenuation will be higher. Theorem: Let us have a generator of input impedance 21 and a load resistance R 2 • If a lossless impedance matching two-port is designed, which gives a perfect impedance matching at the generator side, then the power attenuation is (PO)dB 1 - =20Ig----P2 cos(arc 2d (5) In practical cases the power attenuation is greater, because the matching two-port is lossy. 3. Example Let the characteristic impedance of a transmlSSlOn line be given in Table I. Designing the impedance matching two-port [6] results in the circuit in Fig. 3 for an equipment impedance Rz = 123 ohm. Measured data have been compiled in Table n, where Table I Characteristic impedance of a lransmission line [(kHz) i 6 : 12 24 36 : 60 , 108 ReZJQ) \ 164 i 144 130 123 123 ! 123 i . : -ImZ,(Q) . 96 61.5 33.3 24.1 13.6 7.7 44 J. SOLYMOSI 123Q Fig. 3. Impedance matching two-port designed for the example Table H Reflection and attenuation data rersus frequency J(kHz) 108 i i i ; 36.5 addB) 15.6 16.1 17.4 19.1 22.6 : 27.8 aJdB) 7.04 4.00 1.56 0.78 0.30 0.13 IZ1' -Z I - /0 I HI C ar1 -- g I ZUn+Zc I Z2in-R21 ar 2 =20 19 Z2in+ R 2 I are the reflection attenuation at ports and 2, resp., au = 20 19 I 'I U I' is the ... 2 voltage attenuation. F ram the view-point of power attenuation the worst case is at 6 kHz. From Eq. 4. at this frequency the lower limit of power attenuation is (PO)dB 1 P =201g 96 2 cos (arc tg ~64 ) 1.28 dB. Actually the power attenuation is 5.79 dB, which can be checked from the given voltage attenuation au = 7.04 dB. 4. Acknowledgement The author is plased to express his thanks to Praf. Dr. Se. K. Geher (Technical University, Budapest) for his constant help and useful criticism. THE MINIMUM LOSS 45 Summary In the usual broad-band matching theory the attenuation in the pass-band approximates zero. In the wirebound telecommunication the transmission lines have a frequency-dependent characteristic impedance and if the reflection coefficient is prescribed both for the transmission line side and for the equipment side, a matching two-port is needed, which is lossy and causes power-loss. Based on the scattering matrix, the minimum loss can be calculated. References 1. BODE, H. W.: Network Analysis and Feedback Amplifier Design. D. Van Nostrand, New York. 1945. 2. F.'\NO, R. M.: "Theoretical Limitation on the Broadband Matching of Arbitrary Impedance". J. Franklin Institute, Vol. 249, Nos 1 and 2, pp. 57-83 and 139-154 (1950). 3. YOliLA, D. c.: "A New Theory of Broadband Matching". IEEE Trans. on Circuit Theory, Vol. CT-ll, No. 1, pp. 30-49 (1964). 4. CHAN, Y. T.-KUH. E. S.: "A General Matching Theory and its Application to Tunnel Diode Amplifiers". IEEE TrailS. on Circuit Theory, VoL eT-13, No. 1, pp. 6-18 (1966). 5. KUH, E. S.--ROHRER, R. A.: Theory of Linear Active Networks. Holden-Day, Inc. San Francisco, 1967. 6. SOLYMOSI, J.: "Synthesis of Lossy Matching Two-ports". Proceedings of the Fifth Colloquium on Microwave Communication, Vol. 2. (CT), pp. 267-277. Budapest, 24-30 June, 1974. Dr. Jinos SOLYMOSI, H-1521 Budapest 

THE MINIMUM LOSS OF IMPEDANCE MATCHING TWO-PORTS

https://pp.bme.hu/ee/article/download/4822/3927

THE MINIMUM LOSS OF IMPEDANCE MATCHING TWO-PORTS

Abstract

Similar works

Full text

Available Versions

Periodica Polytechnica (Budapest University of Technology and Economics)