Internet Protocol version six (IPv6) is the next generation internet protocol. It is not yet possible to completely migrate to IPv6, but several transitions mechanisms are available to allow IPv6 and IPv4 coexist together in the same network infrastructure. The main benefit of this protocol is a larger address space and enhanced security options. It is not easy to migrate from current Internet Protocol version four (IPv4) to Internet Protocol version six (IPv6) as it is not “Plug n Play” since both are incompatible protocol. For smooth integration between these protocols, native IPv6 testbed (TEST6) was deployed in an intranet environment. In other hand, this gained an experience and confidence before fully integrating it with an existing Internet protocol. This paper describes how TEST6 was setup in intranet environment (TEST6-I) through numerous of process and network test performed to verify the connectivity

Abdollah, Mohd Faizal

Bahaman, Nazrulazhar

Hamid , Erman

Mas'ud, Mohd Zaki

Mat Ariff, Nor Azman

English

Universiti Teknikal Malaysia Melaka (UTeM) Repository

 7 67Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/          Establishment of IPv6 Network on Intranet Environment Nazrulazhar Bahaman1, Mohd Zaki M.2, Erman Hamid3, Mohd Faizal Abdullah4 and Azman Mat Ariff5 1 University Teknikal Malaysia, Malaysia, Faculty of Information and Communication Technology, nazrulazhar@utem.edu.my 2 University Teknikal Malaysia, Malaysia, Faculty of Information and Communication Technology, zaki.masud@utem.edu.my 3 University Teknikal Malaysia, Malaysia, Faculty of Information and Communication Technology, erman@utem.edu.my 4 University Teknikal Malaysia, Malaysia, Faculty of Information and Communication Technology, faizalabdollah@utem.edu.my 5 University Teknikal Malaysia, Malaysia, Faculty of Information and Communication Technology, nazman@utem.edu.my  Abstract Internet Protocol version six (IPv6) is the next generation internet protocol. It is not yet possible to completely migrate to IPv6, but several transitions mechanisms are available to allow IPv6 and IPv4 coexist together in the same network infrastructure. The main benefit of this protocol is a larger address space and enhanced security options. It is not easy to migrate from current Internet Protocol version four (IPv4) to Internet Protocol version six (IPv6) as it is not “Plug n Play” since both are incompatible protocol. For smooth integration between these protocols, native IPv6 testbed (TEST6) was deployed in an intranet environment. In other hand, this gained an experience and confidence before fully integrating it with an existing Internet protocol. This paper describes how TEST6 was setup in intranet environment (TEST6-I) through numerous of process and network test performed to verify the connectivity.   Key words: IPv6, TEST6-1, Deploy, Intranet  7 68Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/  1 Introduction The version of IP currently being used on the Internet is IPv4. IPv4 has been around for twenty-odd years and has not been substantially changed since RFC 791 was published in 1981. IPv4 has proven to be robust, easily implemented and interoperable, and has stood the test of scaling an internetwork to a global utility the size of today's Internet. This is a tribute to its initial design.   However, the initial design did not anticipate in the recent exponential growth of the Internet and the impending exhaustion of the IPv4 address space. An action has been taken in 1991, where the Internet Architecture Board (IAB) started studying the growth of the Internet and the number of addresses needed. In 1994, Request For Comments (RFC) 1752 [2], entitled "The Recommendation for the IP Next Generation Protocol", was issued then the Internet Engineering Task Force (IETF) has developed a suite of protocols and standards known as IP version 6 (IPv6). This new version, previously named IP-The Next Generation (IPng), incorporates the concepts of many proposed methods for updating the IPv4 protocol.   IPv6 uses a 128-bit address instead of the 32-bit address of IPv4. This benefit not only gives 4 times the addresses of IPv4 but rather the number of IPv4 addresses squared twice. A couple of articles out there have stated that this works out to billions of billions of addresses for every square meter on the planet.   IPv6 offer numbers of advantages over IPv4 and the most prominent are:   Larger address space for global connectivity and scalability  Simplified header for routing efficiency and performance  Enhance multicast support with increased addresses and efficient mechanism.  Mandatory IP Security (IPSec) support for all IPv6 devices.  Auto configuring, easier renumbering and improved plug and play support.  Efficient support for routing 2 Implementation The deployment of intranet IPv6 testbed (TEST6-I) takes several steps. One of them is designing an infrastructure which had IPv6 compatible. The TEST6-I was setup with sequences techniques in basic networking approach which started with stand alone, peer-peer connection under single network and ending by internetwork connection as depicted in the following figure.                                 Figure 1: Standalone Workstation  Figure 2: Peer-to-peer in Single Network  Figure 3: Internetwork Connection             7 69Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/ 3 Inventory All processes were supported by multi platform of operating system with several selected software and hardware. This selection was an inventory that determined from the analysis and the observation done.  Taking the inventory of the current infrastructure gives an outline of which software and hardware is part of the project. It is important that every part of the current situation is being described in detail [1]. A detailed description of the infrastructure gives a good insight in which hardware and software is to be IPv6 enabled. Table 1 gives an overview of which aspects to take into account when making an inventory.  Table 1: Inventory List System Hardware OS IPv6 capable Network device IPv6 compatible Version Y or N Client IPv6 compatible Version and Patches Y or N  For the TEST6-I an inventory has been made and found several kinds of software that would be able to implement IPv6. The results of the inventory taken in TEST6-I is listed in Table 2.  Table 2: Inventory TEST6-I System Hardware OS IPv6 capable Cisco Router 2811 IPv6 compatible IOS 12.X Y MS Windows IPv6 compatible XP, SP2 Y IPv6 compatible Vista Y Linux IPv6 compatible Fedora9 Y IPv6 compatible RedHat Enterprise Linux5 Y  4 Infrastructure An IPv6 network infrastructure has been designed by considering several aspects such as distribution of IP addresses, hardware and network testing.                                                                                 4.1 Distribution of IP Addresses  An IPv6 address has 128bits or 16 bytes. The address is divided into eight 16 bit hexadecimal blocks, separated by colons. An example of an IPv6 unicast address as follows:  2001:610:158:1500:20a:95ff:fede:d038  If there are zeros in the address then it can place a double colon, under the condition that uses it only once. IPv6 has preﬁx lengths, it specify how many bits of the address specify in the preﬁx. RFC 2374 [3] shows the 128 bits divided in three groups, Table 3 shows these groups. RFC 2374 also explains how subnets and host addresses are constructed. The bits representing the Site Topology are to be used for designing subnets, the Interface identifier bits are used to identify interfaces of different systems (one per interface) [4]. This means a total of 65536 subnets can be created each containing up to approximately 20 trillion nodes.          Table 3: IPv6 Address Scheme Name Bits Public Topology 1-48 Site Topology 49-64 Interface Identifier 65-128                 7 70Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/ The IPv6 preﬁx assigned to the TEST6-I is 2002:660:1111:: /48. Bits 49 to 64 are to be used for creating subnets refer Table 4. Table 5 shows a number plan for the TEST6-I. All devices were configured with static addresses.  Table 4: TEST6-I IP Addresses Distribution Category Prefix Site Interface Mask Network 1 2002:660:111 5100 ON /64 Network 2 2002:660:111 5200 ON /64  4.2 Hardware Consideration Hardware that is used in the infrastructure (routers and switches) has to be IPv6 compatible. For internetwork connection, the router is the most important component, because it is dealing with routing IPv6 traffic between the different (sub) networks. The TEST6-I run IPv6 in normal operation use CISCO 2811 router and CISCO 2950-24 switch.  4.3 Network Testing After implementing the IPv6 infrastructure, the next step is for hosts to be able to make IPv6 based connectivity.The network testing process done within small scale, because the impact on the new IPv6 environment cannot be predicted. The process performed with usual network testing procedure such as ‘ping’ and ‘tracert’ to verify connectivity status.   First, to confirm the functionality, IPv6 has been activated on every host and network devices. Next, the process start with loopback testing on standalone node, followed by consisting of two nodes testing (host-to-host testing on single network and host-to-gateway or router interface testing on internetwork) and the rest is internetwork testing. Two interfaces of the router were configured for different IPv6 networks (Figure 5) and each network consists of hosts attached to it (Figure 3). Figure 6 shows an example of configuration that has been made on the router.    Figure 5: Two Interfaces of the Router Were Configured with IPv6 Addresses Figure 6: Example of Configuration made in CLI Form.  Migrating different services to IPv6 depends on the possibility of the software version whether this is possible or not [10]. Most new software versions have IPv6 implemented. 5 Result These network connectivity testing (ping and tracert) was done with difference network connection and the result obtained are as follow.          7 71Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/ 5.1 Ping  All connectivity testing using ping command is successful and the results are depicted in Figure 7 to Figure 121.    Figure 7: Stand alone ping connectivity testing     (a) (b)  Figure 8: Two Nodes Ping Connectivity Testing on the Same Network. (a) Between 2 Workstations. (b) Between Workstations to Gateway   7 72Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/  Figure 9: Internetwork Ping Connectivity Testing  5.2 Tracert  All connectivity testing using tracert command is also successful, the result are shown on the figures below.   Figure 10: Stand Alone Tracert Connectivity Testing    (a) (b)  Figure 11: Two Nodes Tracert Connectivity Testing on the Same Network. (a) Between 2 Workstations.  (b) Between Workstations to Gateway    Figure 12: Internetwork Tracert Connectivity Testing  7 73Nazrulazhar Bahaman Mohd Faizal Abdollah Mohd Zaki M.  Azman Mat Ariff Erman Hamid  Establishment of IPv6 Network on Intranet Environment   International Journal of Network and Mobile Technologies ISSN 1832-6758 Electronic Version VOL 1  / ISSUE 2 / November 2010 © 2010 INTI University College  This paper is available online at http://ijnmt.intimal.edu.my/ 6 Conclusion With the results shown in Section 5 it becomes clear that IPv6 networking can be implemented in intranet environment. On a Linux distribution, there is a lot of marketable software available that supports IPv6. It depends on the version and the platform it is installed on whether or not IPv6 can be enabled. On the other hand, Microsoft platform has some software that is not supporting IPv6 yet there are some alternative software available.  It will take some time for software and hardware to fully support IPv6 technology, until than both IPv6 and IPv4 can coexist together without any problems. Therefore it is advisable to implement IPv6 as much as possible, because sooner or later the migration from IPv4 to IPv6 will become compulsory. It is Important to plan the IPv6 Infrastructure very carefully before deciding to implement IPv6. Especially when it comes to services, it is important to know whether or not the services installed and configured in your situation are capable of handling IPv6.   In conclusion, base on our implementation, it shown that there is no difficulty in implementing an IPv6 network in an intranet environment. This could be the preliminary step towards the migrating from IPv4 and IPv6.  References [1] A. Ahrouch, and S. Ezzine, IPv4 to IPv6 Migration,  UvA 2004. [2] R. Giligan, and E. Nordmark, Transition Mechanisms for IPv6 Hosts and Router, RFC 1933, April 1996. [3] RFC 2374 - http://rfc.net/rfc2374.html [4] M. Steenman, and J. van Lith, Implementing IPv6 in an Organization, 2005  

Establishment of IPv6 network on intranet environment

http://eprints.utem.edu.my/id/eprint/11234/1/Establishment_of_IPv6_Network_on_Intranet_Environment.pdf

Establishment of IPv6 Network on Intranet Environment

Abstract

Similar works

Full text

Available Versions

Universiti Teknikal Malaysia Melaka (UTeM) Repository