Chihara, Kazuyuki

Kaneko, Yosuke

Mizuochi, Hisashi

Terakado, Takuya

Qucosa - Publikationsserver der Universität Leipzig

 Diffusion in  Multicomponent Gas Adsorption  on MSC5A, Chromatographic study  Kazuyuki Chihara, Yosuke Kaneko, Takuya Terakado, Hisashi Mizuochi  Department of Industrial Chemistry, Meiji University, 1-1-1 Higashi-mita, Tama-ku, Kawasaki, Kanagawa, 214-8571, Japan, E-mail:chihara@isc.meiji.ac.jp 1. Introduction The combination of chromatographic method and moment analysis of the response peaks is one of the useful techniques to study adsorption equilibrium and adsorption rate. Perturbation chromatography with the mixed multi component adsorbate gas carrier (two adsorbates) has been applied to several studies on adsorption. In this work, perturbation chromatography with multi component gas carrier (two adsorbates with inert gas) and non-equilibrium thermodynamics liner law was applied for discussion of the interference effect and the displacement effect (those are cross effects) on mass transfer in multi component gas adsorption. Moment analysis method and stop & go simulation method were utilized to obtain each mass transfer parameters of adsorbate gases. Dependency of micropore diffusion on amount adsorbed and correlation of micropore diffusion with chemical potential driving force for microporous adsorbent were discussed. Also, cross effect were discussed. Ruthven already pointed the dependency of micropore diffusivity on amount adsorbed in single component adsorption. Tondeur et al gave general background on multi component perturbation chromatography for the first moment only.  2. Experimental method  0 25 50 75 100 125Tim e[sec]Experim entSim ulationFig.1: Comparison of experimental peaks with simulation The apparatus was similar to a conventional gas chromatograph. Adsorbent particles  (MSC5A) were packed in a column. Carrier gas was a mixture of two or three components among He, N2, CH4. Perturbation pulse was introduced into the carrier gas stream. Introduction of pulses was performed by 6-way valve. The pulse size was 1cc, which meant injection period was 1.4 sec. Then pulse response was detected by TCD cell and by mass filter. Output signal of TCD was transmitted to a personal computer through RS232c. Also, pulse response was introduced to mass detector to get individual response of each component. These signals were also transmitted to the personal computer. Simulated chromatogram by a personal computer can be overlapped on experimental chromatogram shown in the monitor screen. Further, moment of pulse response, which is shown in the monitor screen, can be automatically calculated by the personal computer.   3. Result and discussion Fig.1 shows an example of comparison of experimental chromatogram with simulated chromatogram for MSC5A to obtain Ksav for LDF model. Experimental conditions were 313[K], column pressure 5[atm], flow rate The Open-Access Journal for the Basic Principles of Diffusion Theory, Experiment and Application© 2005, Y. KanekoDiffusion Fundamentals 3 (2005) 16.1 - 16.4 1 25[cm/sec] and He+CH4 mixed gas carrier with CH4 pulse. Here CH4 concentration in the carrier gas was changed 40, 60 and 80[%].  Fig.2 shows the dependency of micropore diffusivity coefficient of CH4 with amount adsorbed at 303, 313 and 323 [K] for MSC5A. Fig.3 shows the correlation of micropore diffusivity of CH4 with chemical potential driving force at 303, 313 and 323[K] for MSC5A. Proportional relation was obtained, which means that micropore diffusion is based on chemical potential driving force.            Fig.2: Dependency of micropore diffusivity  2.E-084.E-086.E-088.E-081.E-070 20 40 60 80amount adsorbed [cc/g]D [cm2 /sec]303K313K323KFig.3: Correlation based on chemical potential driving force 1.E-081.E-071 1δlnp/δlnqD [cm2/sec]0303K313K323KSlope=1Fig.4 shows comparison of Ksav obtained from single adsorbate system and binary adsorbates system. Both Ksav for N2 and CH4 for single experiment show dependencies on amount adsorbed itself. As for Ksav for binary adsorbate [He+CH4 carrier + N2 pulse], CH4-binary shows reasonable dependency, same as single case. Here N2-binary should remain constant, cause no amount adsorbed in the column. However, the Ksav for N2 is affected by CH4 adsorption, as if there is some N2 amount adsorbed.   00.511.522.50 20 40 60 80Am ount adsorbed [cc/g]Ksav [g/cc/sec]C H 4-single C H4-binary N2-single N2-binary        Fig.4: Comparison of Ksav of single adsorbate, and Ksav of binary adsorbate [He+ CH4- N2] 4. Conclusion Good agreements between experimental chromatogram and simulated chromatogram, which were based on the modeling of Stop & Go method, were observed in case of peturbation chromatography with mixed adsorbate gas carrier. And micropore diffusivities obtained were interpreted by chemical potential driving force consideration based on non-equilibrium thermodynamics law. Some possibilitty was shown for cross effect of micropore diffusion in multicomponent adsorption. Diffusion Fundamentals 3 (2005) 16.1 - 16.4 2 References [1]   Chihara K. et al; “Simulation of Pressure Swing Adsorption for Air Separation” Proc. 7th Int. zeolite Conf., 563(1986) [2]   Chihara K. and Kondo A.; “Simulation of Pressure Swing Adsorption –Three Gas Components and Three Adsorption Columns-” 2nd FOA, 165 (1986) [3]   Chihara, K., Suzuki M. and Kawazoe K.; “Adsorption Rate on Molecular Sieving Carbon by Chromatography” AIChE J., 24, 237 (1978) [4]    Karger J. and Bulows M.; Chem. Eng. Sci., 30, 893(1975) [5]    Kumar R., Duncan R.C. and Ruthven D.M.; “A Chromatographic Study of Diffusion of Single Components and Binary Mixtures of Gases in 4A and 5A Zeolites” Can.J.Chem.Eng., 57, 342 (1982)  [6]   Tondeur D., Kabir H., Luo L., and Granger J.; “Multicomponent adsorption equilibria from impulse response chromatography” Chem. Eng. Science, 51(N15) 3781-3799 (1996) [7]   Ruthven D.M,; “Principle of Adsorption and Adsorption Process” Wiley, 146 (1984) [8]   Ruthven D.M. and Kumar R.; “A Chromatographic Study of  the Diffusion of N2, CH4 and Binary CH4-N2 Mixtures in 4A Molecular Sieve” Can.J.Chem.Eng., 57, 342 (1979)     2.2 Moment Analysis The first absolute moment and the second central moment were evaluated from the effluent peak Ce(t) as follows: ( ) ∫∫ ∞∞=001 )(/ dttCtdttC eeμ    (1)     (2) ∫ ∫∞ ∞−=′0 0212 )(/))(( dttCdtttC ee μμ1st moment was calculable from the retention time of the peak. And 2nd  moment was calculable from the retention width. Equation (3) was used along with the experimented 1st moment to obtain the absorption equilibrium constant K*. Equations (4), (5), (6), (7), (8) were used along with the experimented 2nd moment to obtain the diffusivities in the micropore.  ( ) ( )⎭⎬⎫⎩⎨⎧ −−+= ερεμ *1111 Kyuz p                                 (3)  ( ) ( ) ( ))(2*11*11222 iafdppuzKsavKyuKEzuz δδδδερεερεμ +++=⎥⎥⎦⎤⎢⎢⎣⎡ −−+⎭⎬⎫⎩⎨⎧ −+=           (4)  ( ) ( ) 22*111⎭⎬⎫⎩⎨⎧ −−+= ερεδ KyuEz pd    (5)        ( ) 22 *131 KykRpff −−= ρεεδ       (6) Diffusion Fundamentals 3 (2005) 16.1 - 16.4 3    222*)1(151 KyDRpaa −−= ρεεδ    (7)       ( ) )exp(15*11 22 σρεεδ aDKypi−−=     (8) 2.3 Stop & Go Simulation Numerical solution for multi component chromatogram in time domain could be obtained by appropriate model equations with experimental conditions. This simulated chromatogram can be compared with experimental chromatogram to determine the equilibrium and the adsorption kinetic parameters. Here Markham-Benton equation as for adsorption equilibrium and linear driving force (LDF) approximation as for adsorption kinetics were adapted for numerical calculation, which was based on stop & go method (Chihara et al. 1986, Chihara and Kondo 1986). In particular, LDF model of adsorption kinetics was based on non-equilibrium thermodynamics. For binary adsorbates, adsorption rate equations are  ( ) )*(* 222,1111,11 qqKsavqqKsavtq −+−=∂∂γ    (9)   )*()*( 222,1111,22 qqKsavqqKsavtq −+−=∂∂γ                                                                        (10)  where Ksav= Overall mass transfer coefficients.  Overall mass transfer coefficients (Ksav) for LDF model were determined. Then, micropore diffusivities were obtained by subtracting other mass transfer effects from overall resistance (γ/Ksav). Thus obtained micropore diffusivities were correlated with chemical potential driving force by consideration of Fick’s diffusion equation and non-equilibrium thermodynamics (Karger and Bulows 1975).  1121211lnlnqpaDaDδδ′=             (11)         211221212lnlnqpqqaDaDδδ′=           (12)  121222221lnlnqpqqaDaDδδ′=           (13)          2222222lnlnqpaDaDδδ′=           (14)  For instance, Ksav is related to D in single adsorbate case as  ⎟⎟⎠⎞⎜⎜⎝⎛ ++=af DRkRKDaKsav ε153*151 22                            (15) For binary case, when using Equation (15), apparent K* could be determined by appropriate slope of adsorption isothermal plane at perturbation point.  Diffusion Fundamentals 3 (2005) 16.1 - 16.4 4

Diffusion in multicomponent gas adsorption on MSC5A, chromatographic study

http://ul.qucosa.de/api/qucosa%3A14304/attachment/ATT-0/

Diffusion in multicomponent gas adsorption on MSC5A, chromatographic study

Abstract

Similar works

Full text

Available Versions

Qucosa - Publikationsserver der Universität Leipzig