Gornakova, Alena S.

Prokofjev, Sergei I.

Straumal, Boris B.

Qucosa - Publikationsserver der Universität Leipzig

The Open-Access Journal for the Basic Principles of Diffusion Theory, Experiment and ApplicationFormation of α-(Ti) phase on grain boundaries in Ti-Co alloysAlena S. Gornakova, Sergei I. Prokofjev∗, Boris B. StraumalInstitute of Solid State Physics RAS, Chernogolovka, Russia∗prokof@issp.ac.ruOne of most important processes in the heat treatment of materials is the decomposition of supersatu-rated solid solutions. The morphology of decomposition products strongly influences the properties ofa material. The heterogeneous nucleation of a new phase in a grain boundary (GB) proceeds easier thanthe homogeneous one in the supersaturated matrix. In the present study a GB wetting is investigated inpolycrystalline alloys of Ti with 2 wt.% and 4 wt.% Co in the temperature range from 680 to 880◦C.The alloys were prepared in the induction furnace in vacuum of approximately 10−5 Pa. Pure Ti andCo (both of 3N purity) were used for it. For the experiments, ∅10 mm × 5 mm slices of the alloyswere annealed in a vacuum of 4·10−4 Pa at 700◦C, 730◦C, 760◦C and 790◦C for 720, 720, 816 and 864hours, respectively. Thereafter, the samples were quenched in water.Composition of phases in the microstructure of obtained samples was investigated using scanning elec-tron microscope equipped by the LINK energy-dispersive spectrometer. Morphology of the microstruc-tures was analyzed by a light microscopy. It has been found that the solid α-(Ti) phase forms a chainof lenticels-shaped inclusions or continuous homogeneous layer in GBs of β-(Ti, Co) matrix, see Fig.1(left). A quantitative analysis of the wetting transition in the polycrystalline samples was performedadopting the following criterion: every GB was considered to be wetted only when a solid layer hadcovered the whole GB. Accordingly, the percentage of wetted GBs was determined. At least 100 GBsof each sample were analyzed. The results are presented in Fig. 1 (right).Figure 1: (left) The microstructure of Ti–4 wt.% Co alloy annealed at 760◦C, 816 h. The α-Ti phase appears light,the β-(Ti, Co) phase appears dark. (right) Temperature dependence of the fraction ofr completely wetted GBs foralloys: Ti-2wt.% Co and Ti-4wt.% Co.One can observe that the fraction of completely wetted GBs increases with an annealing temperaturefor Ti-2wt.% Co alloy. Whereas, this fraction for Ti-4wt.% Co alloy increases until the solvus line isapproached, and then decreases.Formation of the chains of single inclusions can be related to the low-energy GBs, where slower dif-fusion kinetics, smaller density and average size of inclusions, and, then, their slower growth velocity,are expected. In this way, formation of the continuous homogeneous GB layer is associated with high-energy GBs.The authors acknowledge financial support by the Russian Foundation for Basic Research(contract 12-03-00894).

Formation of alpha-(Ti) phase on grain boundaries in Ti-Co alloys

http://ul.qucosa.de/api/qucosa%3A13689/attachment/ATT-0/

Formation of alpha-(Ti) phase on grain boundaries in Ti-Co alloys

Abstract

Similar works

Full text

Available Versions

Qucosa - Publikationsserver der Universität Leipzig