Several questions may be raised about the practicability of the heating feature of a heat pump. Is the heat pump as economical to operate as the ordinary air conditioner and a separate heating system? What months during the year could the heat pump be operated to the best advantage? Could the heat pump supply all the heat requirements for South Dakota conditions? Because there were so many unknown factors involved it was impossible to estimate the operating cost by calculation. Therefore, the purpose of this study was to compare the operating efficiency of a commercially available heat pump air conditioner ( window model) with that of an electric heating panel under actual operating conditions in a single room

Moe, D. L.

Winterfeld, H.

English

Public Research Access Institutional Repository and Information Exchange

South Dakota State UniversityOpen PRAIRIE: Open Public Research Access InstitutionalRepository and Information ExchangeBulletins South Dakota State University AgriculturalExperiment Station11-1-1962Comparison of Heating Efficiency of a Heat Pumpto Electric Heating PanelsH. WinterfeldD. L. MoeFollow this and additional works at: http://openprairie.sdstate.edu/agexperimentsta_bulletinsThis Bulletin is brought to you for free and open access by the South Dakota State University Agricultural Experiment Station at Open PRAIRIE: OpenPublic Research Access Institutional Repository and Information Exchange. It has been accepted for inclusion in Bulletins by an authorizedadministrator of Open PRAIRIE: Open Public Research Access Institutional Repository and Information Exchange. For more information, pleasecontact michael.biondo@sdstate.edu.Recommended CitationWinterfeld, H. and Moe, D. L., "Comparison of Heating Efficiency of a Heat Pump to Electric Heating Panels" (1962). Bulletins. Paper512.http://openprairie.sdstate.edu/agexperimentsta_bulletins/512BULLETIN 512 HEATS COOLS Comparison of l-leating �fficiency of a I-IEAT PUMP TO ELECTRIC I-IEATING PANELS AGRICULTURAL ENGINEERING DEPARTMENT AGRICULTURAL EXPERIMENT STATION SOUTH DA KOT A STA TE COLLEGE, BROOKINGS CONTENTS Procedure --------------------------------··------------------·---------------------------------------___ 7 Description of Eq ui pmen t ________________________________ ·----------------------------_ ____ 7 Results __ __ __ ___ _ __ __ _ _ ___________ _ _ _ __ _ ____ _____ __ __ _____ _ __ ___ _____ _ _ __ __ _ _ ____ __ ___ __ _ __ _ _ _______ _ __ __ __ 9 Discussion -----------------------------------------------------------------------------------------· ___ 11 Conclusions --------------· ----------------------------------------------------------------------------- 11 3 A portion of the funds used for this research was provided as a grant by the South Dakota Rural Electric Association, Inc. 4 Comparison of Heating Efficiency of a 1-H�AT PUMP TO ELECTRIC HEATING PANELS By HAROLD WINTERFELD, Assistant Agricultural Engineer, and DENNIS L. MoE, Head, Agricultural Engineering Department have the necessary controls to re­verse the action to provide either heating or cooling. When controls are provided for either heating or cooling, the device is commonly called a heat pump. A heat pump can provide more heat to the heated space than the electrical energy input under favor­able operating conditions. The ratio of heat output to electrical energy input is commonly called the C.O.P. ( coefficient of performance). For example, a C.O.P. of 1.5 means the heat output is 1.5 times the electri­cal input. The additional heat is ex­tracted from outside air or other heat sources. For many years engineers have known that heat exists in outdoor air down to approximately-460 ° F. and have attempted to devise a practical means to extract this ener­gy for use indoors. Usually when an attempt has been made to extract this energy, the same basic mechan­isms and devices have been utilized as those involved with present re­frigeration; that is, a refrigerant liquid is made to boil by releasing the liquid from a high pressure to a lower pressure. As it boils the re­frigerant absorbs the heat. The vaporized refrigerant is then com­pressed by a motor-driven com­pressor to a higher pressure and temperature, where it condenses back to a liquid. As it condenses, the refrigerant releases heat. Figure 1 shows the path of ,the refrigerant through the reve'rsing During the past few years several valve for the cooling cycle. Figure manufacturers have introduced to 2 shows the path of the refrigerant the market air conditioners which for the heating cycle. Built-in re-5 REVERSING VALVE HEAT PUMP DISCHARGE LINE t ......._ ______ _ OUTSIDE INSIDE COIL COIL COOLING CYCLE FIG. I RE VERSING VALVE OUTSIDE COIL DISCHARGE LINE SU CTION LINE INSIDE COIL HEATING CYCLE FIG. 2 6 COMPRESSOR COMPRESSOR Comparison of Heating Efficiency of a Heat Pump to Electric Panels 7 sistance heaters are commonly used to supply additional heat at 'colder outdoor temperatures. Several questions may be raised about the practicability of the heating feature of a heat pump. Is the heat pump as economical to operate as the ordinary air condi­tioner and a separate heating sys­tem? What months during the year could the heat pump be operated to the best advantage? Could the heat pump supply all the heat require­ments for South Dakota conditions? Because there were so many un­kp.own factors involved it was im­possible to estimate the operating cost bv calculation. Therefore, the purpo;e of this study was to com­pare the operating efficiency of a commercially available heat pump air conditioner ( window model) with that of an electric heating panel under actual operating con­ditions in a single room. PROCEDURE Two methods of heating, heat pump and electric glass panel, were arranged through suitable controls and separate watt-hour meters to operate alternately, each for a 24-hour period. This gave approxi­mately the same conditions for each method of heating during the period of this study. Switching from one heating method to the other was done each midnight, to correspond with official weather and tempera­ture records. \Veather data were obtained from records kept by the Weather Engi­neering Station at South Dakota State College. The degree days used in this work were derived by taking the average of the high and low temperatures for the 24-hour period. A base of 65 ° F. was used to deter­mine the heating degree days. Fig­ure 3 shows the controls and sepa­rate meters used in the research. Research was interrupted for the 19.59-60 heating season. During the fall of 1959 the Agricultural Engi­neering Department moved to its new building. At this time the equipment being used for the heat pump research had to be moved from its original location to the new building. Procedure for the 1960-61 heating season was generally the same ?...s that for the 1958-59 work, except in 1960-61 the glass panel was used in­stead of the built-in resistance heat­ers in the pump. DESCRIPTION OF EQUIPMENT The electric heating panels were typical hard glass with the conduct­ing element on the reverse side. In the first installation three 600-watt units were mounted on the outside wall under a window. The heat pump air conditioner ( window model) was typical in ap­pearance and size. It was rated 1 horsepower with cooling capacity of approximately 9,100 BTU's at 40 ° F. outdoor temperature. Features differing from an ordinary air con­ditioner included: ( 1) A reversing valve for the refrig­erant, controlled by a thermo­stat in the unit, to switch from cooling to heating automati­cally. 8 South Dakota Experiment Station Bulletin 512 Figure 3. Control and watt-hour meters. ( 2) A defrost control which auto­matically switched the unit to the air conditioning cycle tem­porarily to melt frost built up on the outdoor coil when the unit was heating. ( 3) An outdoor thermostat which turned the compressor off when t h e  o u t d o o r  temperature reached approximately 15° F. At the same time the thermostat turned on an 1,800-watt resist­ance heat unit which supplied heat as required by the room thermostat. ( 4) A smaller 1,000-watt resistance heat unit, controlled by a fixed temperature thermostat that came on whenever room tem­perature fell below 70 ° F. The thermostat automatically dis­connected the 1,000-watt heater when the room temperature rose above 74 ° F. Later models by the same manu­facturer omit the ·outdoor thermo­stat to turn off the compressormotor. They also omit the fixed tempera­ture thermostat and 1,000-watt heater, but substitute one larger re­sistance heater which is allowed to come on if the heat pump does not maintain the temperature setting of the thermostat when the outdoor temperature is below 45 ° F. \Nater produced in defrosting the outdoor coil is directed to the indoor side where a 200-watt resistance heater evaporates the water into the room. This has the effect of humidi­fying the indoor air. The amount evaporated into the room is least when outdoor temperatures are coldest and the need for humidifica­tion is greatest. For purposes of the experiment, control of both types of heating was accomplished by a wall-mounted Comparison of Heating Efficiency of a Heat Pump to Electric Panels 9 thermostat. This was partly to pro­duce the same room temperature by both heating methods and partly to eliminate the continuous operation of the blower on the heat pump. In­termittent operation of the blower was not nearly as objectionable to the people in the room as continu­ous operation. Equipment used during the 1960-61 heating season was the same as that used . during the 1958-59 heat­ing season except for a single 3,000-watt glass panel unit instead of the three 600-watt glass panels. Figure 4 shows the heat pump and glass panel used. For the 1960-61 season the resistance heating elements in the heat pump were disconnected. An outdoor thermostat switched operation from the heat pump to the glass panel at temperatures be­low 15 ° F. RESULTS During the heating season for 1958-59 the two heating methods were able to produce comfortable living conditions in a single room at all times, even though the building ( a relocated barracks building) was poorly constructed and not well in­sulated. The graph in :figure 5 gives the average consumption in kilo­watt-hours per degree day from the first part of March until November. The graph in :figure 6 gives the re­sults of the research for the 1960-61 beating season. It shows the average consumption in kilowatt-hours per degree day to compare the two . heating methods. In this graph you will note that for the heat pump method part of the bar indicates the amount of kilowatt-hours per de­gree day the heat pump used, and the other part the amount in kilo­watt-hours per degree day the heat panel used to maintain the room temperature. The total of the two represents the kilowatt-hours used in comparison to those used by the glass panel alone. The heat pump unit provided the heating requirements with less kilo­watt-hours per degree day for �larch, April, and May. The glass panel alone was more efficient dur­ing the colder months of November, December, January, and February. Figure 4. Heat pump ( upper half) and electric glass panel ( lower half) . .8 .7 .6 .5 >, .4 0 0 • � : .3 0 ... • Q. r .2 5 � 0 J ..2 i2 ... ----,-D heat panel • heat pump r- r-- -r-- r- r-I I Oct. Nov. Dec. Jon. Feb. Mar. Apr. May 19.:·6 - 1959 Heating Season; 7,760 Degree Days. Figure 5. Efficiency comparison of heat pump and electric glass panels. .8 -O heat panel .7 - � • heat pump K "' [SJ auxilary heat f"s ._ '"" "  heat pump C) cle "" '"" "' "' -.6 ""' "" � " "" �· f"s [\ '"" .5 � \ - -- " " .4 ->, 0 . .3 . ... 0 ... ,--. 2 ... :, -1 0 3! ..2 :,:: .. Dec. Jan. Feb. Mar. Apr. May 1960 - 1961 Heating Season ; 6,455 Deg. Days. Figure 6. Efficiency comparison of heat pump and electric glass panels. � � � � S-� � � t h:1 � � i' � � $:l ;s· � t:x:l � -�-Comparison of Heating Efficiency of a Heat Pump to Electric Panels 11 DISCUSSION Results show that the heat pump is not as efficient as the electrical panel heating method during the cold winter season. This inefficiency would partly be explained by the fact that the blower and compressor motors on the heat pump are mount­ed in the outdoor air stream and the energy input to these motors is largely wasted. Also the coefficient of performance of the heat pump ( amount of heat transferred per watt input) decreases as the tem­perature drops. The heat pump was shut off at 15 ° F. when its coefficient of perform­ance was theoretically equal to that for resistance heating. Data would seem to indicate that its coefficient of performance between the approx­imate temperature of 35 ° and 15° F. was poorer than that for the glass panel. Results indicate a possible appli­cation of the heat pump unit in con­junction with another heating sys­tem-that is, either where resistance electric heating is already in use ( using the heat pump on milder days) or where it is desired to shut down the central heating plant for a longer time during spring and fall. It would be expected that the only place where most persons would justify the cost would be where heating as well as cooling is desired. The heat pump model costs approx­imately 20 to 30% more than the model that does only cooling. Heating as well as cooling may be desired during the months when hot days are followed by cool eve­nings. The heat pump is particu-larly convenient during the spring and fall when it is desirable to re­move the chill without starting the central heating system. It can be used in summer cottages or cabins without any other source of heat. It can be used for added-on rooms, basement and attic rooms, and offices which cannot be fully accom­modated or controlled accurately with existing heating systems. CONCLUSIONS ( 1) The glass heating panel was more efficient than the heat pump during the coldest months even though on milder days, ab<)Ve 15 ° F., it proved to be less efficient. For the two heat­ing seasons studied the heat pump proved more efficient than the glass panels during the spring and fall. ( 2) The heat pump unit used in this study proved to be quite dependable in operation and performed well according to its design and purpose. It appears that control by a wall-mounted thermostat may be desirable in some locations to eliminate the objection to the otherwise con­tinuous blower noise. ( 3) The heat pump air conditioner may find application in multiple occupancy buildings such as of­fices and apartments where cen­tral heating systems do not sup­ply the varying temperatures desired in individual rooms. ( 4) It can serve as a supplemental heat source in homes that have a central heating system. 

Comparison of Heating Efficiency of a Heat Pump to Electric Heating Panels

https://openprairie.sdstate.edu/cgi/viewcontent.cgi?article=1511&amp;context=agexperimentsta_bulletins

Comparison of Heating Efficiency of a Heat Pump to Electric Heating Panels

Abstract

Similar works

Full text

Available Versions

Public Research Access Institutional Repository and Information Exchange