Stress is a proximal interphalangeal (PIP) joint model was analyzed by the two-dimensional and three-dimensional finite element methods (FEM) to study the onset mechanisms of the middle phalangeal base fracture. The structural shapes were obtained from sagittally sectioned specimens of the PIP joint for making FEM models. In those models, four different material properties were given corresponding to cortical bone, subchondral bone, cancellous bone and cartilage. Loading conditions were determined by estimating the amount and position of axial pressure added to the middle phalanx. A general finite element program (MARC) was used for computer simulation analysis. The results of the fracture experiments compared with the clinical manifestation of the fractures justify the applicability of the computer simulation models using FEM analysis. The stress distribution changed as the angle of the PIP joint changed. Concentrated stress was found on the volar side of the middle phalangeal base in the hyperextension position, and was found on the dorsal side in the flexion position. In the neutral position, the stress was found on both sides. Axial stress on the middle phalanx causes three different types of fractures (volar, dorsal and both) depending upon the angle of the PIP joint. These results demonstrate that the type of PIP joint fracture dislocation depends on the angle of the joint at the time of injury. The finite element method is one of the most useful methods for analyzing the onset mechanism of fractures.</p