The aggregate base layer is a vital part of the flexible pavement system. Unlike rigid pavements, the base layer provides a substantial contribution to the load bearing capacity in flexible pavements, and this contribution is complex: stress dependent, moisture dependent, particle size dependent, and is anisotropic in nature. Furthermore, the response of the aggregate layer in the pavement structure is defined not only by resilient properties of the base layer but also by permanent deformation properties of the aggregate layer. Before the benefits of revolutionary changes in the typical pavement structures, such as deep unbound aggregate base (UAB) layers under thin hot mix asphalt surfaces and inverted pavement systems can be justified, an accurate assessment of the UAB is required... In the realm of geotechnical engineering, the ratio of the horizontal modulus to vertical modulus is commonly referred to as the level of anisotropy. When the vertical and horizontal moduli are equal, the system is isotropic, but when they differ, the system is anisotropic. This research showed that the level of anisotropy can vary considerably depending on aggregate mix properties such as gradation, saturation level, and the geometry of the aggregate particles. Cross anisotropic material properties for several unbound and stabilized aggregate systems were determined. A comprehensive aggregate database was developed to identify the contribution level of aggregate features to the directional dependency of material properties. Finally a new mechanistic performance protocol based on plasticity theory was developed to ensure the stability of the pavement foundations under traffic loads.Aggregates Foundation for Technology, Research, and Education (AFTRE)Civil, Architectural, and Environmental Engineerin
