Boso, Gianluca

Buttafava, Mauro

Ruggeri, Alessandro

Tamborini, Davide

Tosi, Alberto

Zappa, Franco

TAMBORINI, DAVIDE

BUTTAFAVA, MAURO

RUGGERI, ALESSANDRO

BOSO, GIANLUCA

TOSI, ALBERTO

ZAPPA, FRANCO

Archivio istituzionale della ricerca - Politecnico di Milano

Cost-Effective High-Performance Single-Photon Detection System Davide Tamborini1, Mauro Buttafava1, Alessandro Ruggeri1, Gianluca Boso2, Alberto Tosi1,  and Franco Zappa1 1 Politecnico di Milano, Dipartimento di Elettronica, Informazione e Bioingegneria, Piazza Leonardo da Vinci 32, I-20133 Milano, Italy  2 was with 1, now is with Group of Applied Physics, University of Geneva, Geneva, Switzerland davide.tamborini@polimi.it We pioneer a novel single-photon detection platform able to exploit the best performance out from state-of-the-art Single-Photon Avalanche Diodes (SPADs), fabricated in CMOS, custom Silicon and also InGaAs/InP technologies. The platform provides cost-effective, high-performance, fully programmable, time-resolved detection modules, all based on a common FPGA processing board and compact industry-standard 1-inch aluminum tube housing.  Two implementations exploit either a large area (up to 100 µm) CMOS SPAD [1] with Active Quenching Circuit [2] and a 10 ps resolution Time-to-Digital Converter (TDC) [3] or a 32x2 (50 µm) linear CMOS SPAD array with multiplexed TDC and readout. The modules effectively provide two stand-alone complete Time-Correlated Single-Photon Counting (TCSPC) systems, with either single-channel or 64-channels, with extremely reduced size (1” x 2”), low power consumption (self-powered through a standard USB 2.0 link), low cost and no need of expensive and bulky external TCSPC boards. The FPGA architecture and the 40 MB/s communication interface enable real-time data analysis and built-in histogram computation, with a high degree of data processing flexibility. A bidirectional wide-band SMA connector can be programmed as trigger output/input, for synchronization with external systems (e.g. laser) in TCSPC or 3D LIDAR setups.  Fig. 1 : (A) Complete module with a single CMOS SPAD; (B) 32x2 CMOS SPAD array Detection Board; (C) TDC+FPGA Board, with micro USB link and input/output SMA connector.  Fig. 2 : Temporal response of a single-pixel 50 μm SPAD Detection Board to an 850 nm laser pulse (40 ps FWHM), resulting in ~ 100 ps FWHM at 6 V excess bias. Fig. 1 shows platform’s hardware, based on a Detection Board and a TDC+FPGA Board, hosting the 10 ps TDC chip [3], a Xilinx Spartan-6 FPGA for data processing, an USB 2.0 high-speed controller and a wide-bandwidth connector, which provides all power supply and communication I/O lines to the Detection Board. Different Detection Boards have been developed, for hosting different home-made or third party SPADs: for example, Fig. 1A and Fig. 1B shows the ones with the single SPAD chip and the 32x2 CMOS SPAD array mounted, respectively. These boards directly provide digital “photon-out” signals to the TDC+FPGA Board, since the AQC can be either on-chip with the CMOS SPAD, or off-chip for custom SPADs. Excess bias, breakdown voltage and hold-off time are all user-programmable through a friendly graphical interface. Some Detection Boards host a CPLD (as for the 32x2 SPAD array implementation) for routing channel signals to TDC and for application-specific customizations (e.g. on-board counters, coincidence detection, correlation, etc.). These implementations detect single-photons with 45 % detection efficiency at 550 nm (still > 15 % at 800 nm), a dark count rate less than 100 cps at room temperature and an afterpulsing probability less than 1 % with 60 ns hold-off time, giving a maximum saturated count rate of 16 MHz. The TDC performs time measurements over a range of 160 ns, with a maximum conversion rate of 3 Mconv/s. The whole system’s single-shot precision is 100 ps FWHM (with the 50 µm CMOS SPAD, as in Fig. 2), and the differential nonlinearity is lower than 1.3% of LSB rms (i.e. < 130 fs). References [1] F. Villa, D. Bronzi, Y. Zou, C. Scarcella, G. Boso, S. Tisa, A. Tosi, F. Zappa, D. Durini, S. Weyers, U. Paschen and W. Brockherde, “CMOS SPADs with up to 500 µm diameter and 55% detection efficiency at 420 nm”, J. of Modern Optics, vol. 61, pp. 102-115 (2014). [2] D. Bronzi, S. Tisa, F. Villa, S. Bellisai, A. Tosi and F. Zappa, “Fast Sensing and Quenching of CMOS SPADs for Minimal Afterpulsing Effects”, IEEE Photonic Technology Letters, vol. 25, no. 8, pp. 776-779 (2013). [3] B. Markovic, S. Tisa, F. A. Villa, A. Tosi, and F. Zappa, “A High-Linearity, 17 ps Precision Time-to-Digital Converter Based on a Single-Stage Vernier Delay Loop Fine Interpolator”, IEEE Transactions on Circuits and Systems I, vol. 60, pp. 557-569 (2013). 

Cost-Effective High-Performance Single-Photon Detection System

https://re.public.polimi.it/retrieve/handle/11311/984150/108398/SPW2015_SPAD_Tubes.pdf

Cost-Effective High-Performance Single-Photon Detection System

Abstract

Similar works

Full text

Available Versions

Archivio istituzionale della ricerca - Politecnico di Milano