In this study a simple effective procedure practically based upon the FEM for determination of the dynamic stress intensity factor (DSIF) depending on the input frequency and using an advanced strain energy release evaluation by the simultaneous release of a set of fictitious nodal spring links near the crack tip is developed and applied. The DSIF is expressed in terms of the released energy per unit crack length. The formulations of the linear fracture mechanics are accepted. This technique is theoretically based upon the eigenvalue problem for assessment of the spring stiffnesses and on the modal decomposition of the crack shape. The inertial effects are included into the released energy. A linear elastic material, time-dependent loading of sine type and steady state response of the structure are assumed. The procedure allows the opening, sliding and mixed modes of the structure fracture to be studied. This rational and powerful technique requires a mesh refinement near the crack tip. A numerical test example of a square notched steel plate under tension is given. Opening mode of fracture is studied only. The DSIF is calculated using a coarse mesh and a single node release for the released energy computation as well a fine mesh and simultaneous release of four links for more accurate values. The results are analyzed. Comparisons with the known exact results from a static loading are presented. Conclusions are derived. The values of the DSIF are significantly larger than the values of the corresponding static SIF. Significant peaks of the DSIF are observed near the natural frequences. This approach is general, practicable, reliable and versatile
