Ankara : The Department of Electrical and Electronics Engineering and the Institute of Engineering and Sciences of Bilkent University, 2010.Thesis (Master's) -- Bilkent University, 2010.Includes bibliographical references leaves 57-59.Orthogonal Frequency Division Multiplexing (OFDM) is a multicarrier transmission
technique, in which a single bitstream is transmitted over a large number of
closely-spaced orthogonal subcarriers. It has been adopted for several technologies,
such as Wireless Local Area Networks (WLAN), Digital Audio and Terrestrial
Television Broadcasting and Worldwide Interoperability for Microwave
Access (WiMAX) systems.
In this work, IEEE802.11a WLAN standard was implemented on Field Programmable
Gate Array (FPGA) for being familiar with the implementation problems
of OFDM systems. The algorithms that are used in the implementation
were firstly built up in MATLAB environment and the performance of system
was observed with a simulator developed for this purpose. The transmitter and
receiver FPGA implementations, which support the transmission rates from 6
to 54 Mbps, were designed in Xilinx System Generator Toolbox for MATLAB
Simulink environment. The modulation technique and the Forward Error Coding
(FEC) rate used at the transmitter are automatically adjusted by the desired
bitrate as BPSK, QPSK, 16QAM or 64QAM and 1/2, 2/3 or 3/4, respectively.The transceiver utilizes 5986 slices, 45 block RAMs and 73 multipliers of a Xilinx
Virtex-4 sx35 chip corresponding to % 39 of the resources. In addition, the
FPGA implementation of the transceiver was also tested by constructing a wireless
link between two Lyrtech Software Defined Radio Development Kits and
the bit error rate of the designed system was measured by performing a digital
loop-back test under an Additive White Gaussian Noise (AWGN) channel.İnce, MustafaM.S