The main goal of the dissertation was following: preparation of a new concept, implementation and analysis of the piezoelectric resonant sensor/actuator for measuring the aging process of human skin. The research work has been carried out in the framework of cooperation between the INP-ENSEEIHT-LAPLACE, Toulouse, France, and at the Gdansk University of Technology, Faculty of Electrical and Control Engineering, Research Group of Power Electronics and Electrical Machines, Gdask, Poland. A concept of transducer for the characterization of mechanical properties of soft tissues was presented. The piezoelectric resonant, bending transducer, referred to as “unimorph transducer” was chosen from different topologies of piezoelectric benders based on the fulfillment of the stated requirements. The innovation of the project lies in the integration of the dynamic indentation method by using a unimorph as an indentation device. This allows the use of a number of attractive electromechanical properties of piezoelectric transducers. The thesis is divided into seven chapters. Chapter 1 states the thesis and goals of the dissertation. Chapter 2 presents piezoelectric phenomenon and piezoelectric applications in the fields of medicine and bioengineering. Chapter 3 describes the requirements for the developed transducer. The choice of unimorph transducer is justified. Chapter 4 presents an analytical description of the unimorph transducer, including the calculations of static deformations, equivalent circuit description, and description of the contact conditions between the transducer and the tested materials. Chapter 5 contains the numerical analysis of the unimorph transducer using FEM virtual model. Results of static and modal simulations are described for two considered geometries of the transducer. Chapter 6 describes the experimental verification process of analytic and numerical models developed for unimorph transducer. The final chapter includes general conclusions concerning obtained research results and achievements, as well as possible future works. In order to verify the proposition of the thesis a full research cycle was carried out, that covered: analytical study, numerical analysis (FEM simulations), prototype realization, and experimental verification of the considered (developed) piezoelectric sensor/actuator structures
