Scandium Nitride Thin Films for Thermoelectrics

Abstract

Thermoelectric devices are one of the promising energy harvesting technologies, since they can convert heat (i.e. a temperature gradient) to electricity. This result leads us to use them to harvest waste heat from heat engines or in power plants to generate usable electricity. Moreover, thermoelectric devices can also perform cooling. The conversion process is clean, with no emission of greenhouse gases during the process. However, the converting efficiency of thermoelectrics is very low because of the materials limitations of the thermoelectric figure of merit (ZTm). Thus, there is high demand to maximize the ZTm. I have discovered that ScN has high power factor 2.5 mW/(mK2) at 800 K, due to low metalliclike electrical resistivity (∼3.0 μΩm) with retained relatively large Seebeck coefficient of -86 μV/K. The ScN thin films were grown by reactive dc magnetron sputtering from Sc targets. For ScN, X-ray diffraction, supported by transmission electron microscopy, show that we can obtain epitaxial ScN(111) on Al2O3(0001). We also reported effects on thermoelectric properties of ScN with small changes in the composition with the power factor changing one order of magnitude depending on e.g. oxygen, carbon and fluorine content which were determined by elastic recoil detection analysis. The presence of impurities may influence the electronic density of states or Fermi level (EF) which could yield enhancement of power factor. Therefore, the effects of defects and impurities on the electronic density of states of scandium nitride were investigated using first-principles calculations with general gradient approximation and hybrid functionals for the exchange correlation energy. Our results show that for Sc and N vacancies can introduce asymmetric peaks in the density of states close to the Fermi level. We also find that the N vacancy states are sensitive to total electron concentration of the system due to their possibility for spin polarization. Substitutional point defects shift the Fermi level in the electronic band according to their valence but do not introduce sharp features. The energetics and electronic structure of defect pairs are also studied. By using hybrid functionals, a correct description of the open band gap of scandium nitride is obtained, in contrast to regular general gradient approximation. Our results envisage ways for improving the thermoelectric figure of merit of ScN by electronic structure engineering through stoichiometry tuning and doping