Thesis (S.M.)--Massachusetts Institute of Technology, Dept. of Aeronautics and Astronautics, 2006.Includes bibliographical references (p. 137).Numerical experiments have been implemented to characterize the unsteady loading on the rotating impeller blades in a modem centrifugal compressor. These consist of unsteady Reynolds-averaged Navier Stokes simulations of three-dimensional and quasi-two dimensional approximate models. The interaction between the rotating impeller and the stationary downstream diffuser has been identified as strong source of unsteady loading on the impeller blades. First of a kind unsteady calculations haven been carried out to elucidate an upstream manifestation of a downstream stimulus experienced in a particular centrifugal compressor stage. Here the upstream manifestation is the considerable unsteady loading in the splitter blade leading edge while the downstream stimulus is the unsteady impeller-diffuser interaction Three key parameters that control the level and extent of the unsteady loading are the impeller-diffuser gap, stage loading, and the impeller passage relative Mach number. Impeller-diffuser gap has been shown to control the peak level of unsteady loading on the blade. Stage loading has been shown to control the upstream attenuation of the loading.(cont.) A hypothesis has been put forward that increased diffusion associated with increased stage loading increases the impeller sensitivity to the downstream disturbance. The relative Mach number has been shown to set the chordwise distribution of the unsteady load on the blade. Unsteady blade loading has been computed through a quasi two-dimensional model in which an unsteady pressure boundary condition is imposed at the impeller exit to approximate the presence of the downstream diffuser. Results of this approximate model have been shown to yield unsteady loading characteristics that are in accord with the full three-dimensional unsteady model. An implied utility of this result is that a quasi-2D approximation could be used during the design phase to approximate the unsteady loading in a timeframe that is compatible with the design environment. The effect of unsteady flow on mass flow capacity of a fluid device is eliminated as a source for over-predictions in mass flow when a steady-state approximation is used.by Kenneth A. Gould.S.M
