Superimposition of contractional structures is widely observed in different scales in the world. Superimposed structures form due to different processes: change in strain accommodation from one type of structure to another during a single progressive shortening; successive coaxial shortening phases separated by an unconformity; superimposition of different non-coaxial shortening phases. Using results of a series of systematic analogue models and detailed field structural mapping, this thesis focuses on the geometry and kinematics of such superimposed structures that are formed by these three processes. During a single progressive folding, thrusts develop within a fold to accommodate stain variations in different regime of the fold. Limited displacement along these thrusts does not significantly modify the geometry of the fold. However, during multiple shortening phases (coaxial or non-coaxial), early formed structures are modified by the later phase ones. The later thrusts can cut and displace the pre-existing structures. The early folds are tightened or interfered by the later folding phase. Pre-existing thrusts may be reactivated either in dip direction and/or along strike during the later shortening. The pre-existing structures in turn influence development of the later structures, which results in change in structure spacing. An angular unconformity between two shortening phases clearly truncates the early phase structures and separates structures of different levels. Unlike in the post-erosional layers, in the layers below the unconformity, complicated superimposed structures are visible. This thesis shows that geometry and sequence of structures formed during one progressive shortening or multiple shortening phases strongly depend on the mode of the superimposition (coaxial, orthogonal or oblique) and the orientation of pre-existing structures