Lithology and Internal Structure of the San Andreas Fault at Depth Based on Characterization of Phase 3 Whole-rock Core in the San Andreas Fault Observatory at Depth (SAFOD) Borehole
We characterize the lithology and structure of the spot core obtained in 2007 during Phase 3 drilling of the San Andreas Fault Observatory at Depth (SAFOD) in order to determine the composition, structure, and deformation processes of the fault zone at 3 km depth where creep and microseismicity occur. A total of approximately 41 m of spot core was taken from three separate sections of the borehole; the core samples consist of fractured arkosic sandstones and shale west of the SAF zone (Pacific Plate) and sheared fine-grained sedimentary rocks, ultrafine black fault-related rocks, and phyllosilicate-rich fault gouge within the fault zone (North American Plate). The fault zone at SAFOD consists of a broad zone of variably damaged rock containing localized zones of highly concentrated shear that often juxtapose distinct protoliths. Two zones of serpentinite-bearing clay gouge, each meters-thick, occur at the two locations of aseismic creep identified in the borehole on the basis of casing deformation. The gouge primarily is comprised of Mg-rich clays, serpentinite (lizardite ± chrysotile) with notable increases in magnetite, and Ni-Cr-oxides/hydroxides relative to the surrounding host rock. The rocks surrounding the two creeping gouge zones display a range of deformation including fractured protolith, block-in-matrix, and foliated cataclasite structure. The blocks and clasts predominately consist of sandstone and siltstone embedded in a clay-rich matrix that displays a penetrative scaly fabric. Mineral alteration, veins and fracture-surface coatings are present throughout the core, and reflect a long history of syn-deformation, fluid-rock reaction that contributes to the low-strength and creep in the meters-thick gouge zones
