The research work described in this Thesis concentrates on studying surface acoustic wave (SAW) resonators, in particular resonators which utilize the leaky surface acoustic wave (LSAW) mode. Such resonators constitute building blocks for radio-frequency SAW bandpass filters, which are widely employed in modern cordless and cellular telecommunication systems. The number of radio frequency SAW filters produced presently exceeds 3 billion per year.
The work is carried out with an optical Michelson laser interferometer developed at the Materials Physics Laboratory specifically for the purpose of studying SAW components. In the course of this work the interferometer was equipped with a high-speed photodetector and state-of-the-art detection electronics, enabling the measurement of surface vibrations at frequencies as high as 2 GHz with amplitudes on the order of a few picometers. Furthermore, the setup was equipped with high-precision motorized scanning stages and computer control in order to facilitate automatically performed two-dimensional scans with a large number of scanning points and measuring speeds up to 50 000 points per hour. The optical setup features a spatial resolution better than one micrometer, enabling measurement of surface waves with wavelengths down to 2 micrometers. The interferometer can be used for analysis of surface acoustic wave devices as well as for thin-film bulk acoustic wave resonators and radio-frequency microelectromechanical systems (RF-MEMS).
Laser-interferometric measurements were performed on LSAW resonators and filters on rotated Y-cut lithium tantalate (LiTaO3). As a result, an unexpected acoustic field distribution was observed. Further measurements and simulations showed that the observed field distributions resulted from LSAWs escaping outside the resonator into the busbars. This acoustic loss mechanism can significantly degrade the performance of an LSAW filter. The obtained results have been acknowledged by SAW filter manufacturers in Japan and in Europe. In addition, measurements of bulk acoustic wave (BAW) radiation from LSAW resonators were carried out. Such radiation is inherent for LSAW resonators. Theoretical models and numerical simulations characterizing the phenomenon exist but very few direct measurements have been reported. Here, direct measurement results of BAW radiation fields generated by an LSAW resonator on LiTaO3 are reported revealing both fast shear and slow shear bulk waves. Furthermore, two coupling mechanisms, backscattering and direct excitation, were identified. Such information can be used in the development of more accurate simulation models.reviewe
