Data availability: Data will be made available on request.The main objective of this study is to develop 3D printed heavyweight concrete (3DPHWC) to produce elements with a dry density of up to 3500 kg/m3 by replacing natural aggregate (SA) with magnetite aggregate (MA) up to 100%. A comprehensive systematic study was conducted to thoroughly assess mixtures' mechanical properties, physical proficiency, fresh properties, and printing qualities. The inclusion of MA exhibited the desired fresh properties required for 3D printing and promising physical and mechanical properties. Evaluation of the mechanical properties of designed 3DPHWC indicates that replacing SA with MA increases both cast and printed samples' strengths. The 3D printed M100 sample achieved higher 28 days flexural and compressive strengths by 18 % and 20 %, respectively, compared to printed control mix (M0). Micro-CT study correspondingly demonstrated improvements in the composites' porosity, pore size, and pore morphologies. The linear attenuation coefficients (LACs) and half-value layer (HVLs) for slow neutron and gamma-ray were measured to assess radiation shielding characteristics. A significant performance improvement was obtained for slow neutrons by introducing the magnetite aggregate. Unlike slow neutrons, no significant difference was observed between cast and printed samples against γ-rays. Moreover, the effect of porosity on the shielding performance was discussed.This research was funded in whole by the National Science Centre, Poland within Project No. 2020/39/D/ST8/00975 (SONATA-16). This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (Ministry of Science and ICT Grant no. NRF-2021R1A4A3030924)
