Solar photocatalytic degradation of polyethylene terephthalate nanoplastics: Evaluation of the applicability of the TiO2/MIL-100(Fe) composite material
For the first time, TiO2/MIL-100(Fe) photocatalysts supported on perlite mineral particles prepared by the solvothermal/microwave methods and post-annealing technique were tested in the degradation of polyethylene terephthalate nanoplastics (PET NPs). Powder X-ray diffraction, Fourier transform infrared spectroscopy, thermogravimetric analysis, scanning electron microscopy, X-ray photoelectron spectroscopy, UV–vis diffuse reflectance spectroscopy, N2 physisorption, photoluminescence emission spectroscopy, photocurrent response, and electrochemical impedance spectroscopy were used to characterize the as-prepared materials. The response surface methodology approach was used to study the effects: pH of the NPs suspension and incorporated amount of MIL-100(Fe) on the TiO2/MIL-100(Fe) catalyst to optimize the photocatalytic degradation of the PET NPs under simulated solar light. The degradation of the PET NPs was evaluated by measuring turbidity and carbonyl index (FTIR) changes. The total organic carbon (TOC) in the solution during the degradation of the PET NPs was assessed to measure NPs oxidation into water-soluble degradation by-products. The active species involved in the photocatalytic degradation of PET NPs by the TiO2/MIL-100(Fe) composite was further examined based on trapping experiments. The use of 12.5 wt% TiO2/MIL-100(Fe) catalyst showed improved photocatalytic efficacy in the oxidation of PET NPs at pH 3 under simulated sunlight compared to bare TiO2. The increase in the carbonyl index (CI = 0.99), the reduction in the turbidity ratio (0.454), and the increase in the content of TOC released (3.00 mg/L) were possible with 12.5 wt% TiO2/MIL-100(Fe) material. In contrast, the PET NPs were slowly degraded by TiO2-based photocatalysis (CI = 0.96, turbidity ratio = 0.539, released TOC = 2.12 mg/L). The mesoporous TiO2/MIL-100(Fe) composites with high specific surface area, capacity to absorb visible light, and effective separation of photogenerated electron-hole charges clearly demonstrated the enhancement of the photocatalytic performance in the PET NPs degradation under simulated solar light
