Absolute, soft x-ray calorimetry on the Z facility at Sandia National Laboratories

Abstract

Simple and reliable x-ray fluence measurements, in addition to time-resolved diagnostics, are needed to understand the physics of hot Z-pinch plasmas. A commercially available laser calorimeter has been modified for measuring soft x-ray fluence from the Z facility at Sandia National Laboratories. The x-ray absorber of this calorimeter is an aluminum disk, attached to a two-dimensional thermopile and surrounded by an isoperibol shroud. The time-integral and the maximum of the thermopile voltage signal are both proportional to the x-ray energy deposited. Data are collected for 90 seconds, and the instrument has, thus far, been used in the 1--25 mJ range. A wider dynamic measuring range for x-ray fluence (energy/area) can be achieved by varying the area of the defining aperture. The calorimeter is calibrated by an electrical substitution method. Calibrations are performed before and after each x-ray experiment on the Z facility. The calibration of the time-integral of the thermopile voltage vs. energy deposited (or the peak of thermopile voltage vs. energy deposited) is linear with zero offset at the 95% confidence level. The irreproducibility of the calibration is <2%, and the imprecision in the measurement of the incident x-ray energy (inferred from signal noise and the calibration) is estimated to be {approximately}0.9 mJ (95% confidence level). The inaccuracy is estimated at {+-}10%, due to correctable systematic errors (e.g., baseline shifts). Comparisons have been made of the calorimeter to time-resolved x-ray diagnostics, e.g., bolometers and XRD (x-ray diode) arrays, by integrating the flux measured by these instruments over time