Current MCFCs use a Li/K carbonate mixture; the segregation increases the K concentration near the cathode, leading to increase cathode solubility and performance decline. ANL is developing molten carbonates that have minimal segregation; the approach is using Li-Na carbonates. In screening tests, fully developed potential distributions were obtained for 4 Li/Na compositions, and performance data were used to compare these

Kaun, T.

Krumpelt, M.

Lanagan, M.

UNT Digital Library

. Non-Segregating Electrolytes for Molten Carbonate Fuel Cells M. Krumpelt, T. Kaun, and M. Lanagan Electrochemical Technology Program Argonne National Laboratory 9700 South Cass Avenue Argonne, IL 60439 f Tne submitted manuscript bas been authored by a contractor of the US. Government under contract No. W-31-109-ENG-38. Accordingly, the U. S .  Government retains a nonexclusive, royalty-free license to publish or reproduce the published form of this contribution, or allow others to do so, for U. S .  Government purposes. August, 1996 Morgantown Energy Technology Center Fuel Cell Review, Fuel Cells '96, Morgantown, WV, August 20-21,1996. DISCLAIMER This report was prepared as an account of work sponsored by an agency of the United States Government. Neither the United States Government nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or use- fulness of any information, apparatus, product, or process disclosed, or represents that its use would not infringe privately owned rights. Reference herein to any spe- cific commercia1 product, process. or service by trade name, trademark, manufac- turer, or otherwise does not necessariiy constitute or imply its endorsement, mom- mendotion, or favoring by the United States Government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States Government or any agency thereof. Portions of this document may be illegible in electronic image products. Images are produced from the best available original document. Non-Segregating Electrolytes for Molten Carbonate Fuel Cells M. Krumpelt (krumpelt@cmt.anl.gov; 630-252-8520) T. Kaun (kaun @ cmt.anl.gov; 630-252-5605) M. Lanagan (m-lanagan@qmgate.anl.gov; 630-252-4251) Electrochemical Technology Program Argonne National Laboratory 9700 South Cass Avenue Argonne, IL 60439 Introduction In the current technology, molten carbonate fuel cells (MCFCs) employ a Li/K carbonate mixture. The mixture, usually 62 d o  Li,CO, and 38 d o  K,CO,, melts below about 550°C and, when mixed with lithium aluminate, serves as both the electrolyte and gasketing for the cell and stack. Electrolyte segregation has been reported to occur within both the cell and the stack. In the cell, the segregation increases the potassium concentration near the cathode and leads to increased cathode solubility and performance decline. In the stack, the high potential difference on the gaskets causes electrolyte segregation that, in turn, leads to severe performance decline of the “end” cells. Objective Argonne National Laboratory (ANL) is developing molten carbonate electrolyte compositions that have minimal segregation in the molten carbonate fuel cell (MCFC) and stack electric field. Our approach is to characterize Li-Na carbonate mixtures in terms of their segregation properties in an electric field and, if necessary, to modify the observed segregation by adding alkaline earth carbonates. Segregation properties are examined in “gasket”-strip (20-V) screening studies, as well as in 100-cm2 cell tests. Approach ANL is exploring Li-Na carbonate electrolyte compositions that have minimal segregation in the MCFC and stack under load. The segregatiodmigration characteristics of the electrolyte under load are determined and modified. The liquidus composition range of the Li-Na carbonate electrolyte is broader than that of the Li-K carbonate electrolpe, which aid fuel cell operation. In This work is being conducted under the auspices of the U.S. Department of Energy (DOE), Contract Number W-3 1-109-Eng-38. This research was sponsored by the DOE Morgantown Energy Technology Center. addition, the Li-Na carbonate electrolyte embodies a number of attractive features for MCFC advancement: a It is more conductive than the Li-K carbonate electrolyte [ 11 It may lead to longer life due to lower Ni2+ solubility [2] Corrosion rates for hardware components are lower in the Li-Na carbonate It has no volatile, potassium-containing constituents. electrolyte [3], and Project Description A screening test for electrolyte segregation was developed that was based on an earlier method by Kunz [4] in which carbonate-wetted strips were subjected to 5 to 20 V potential gradients. These conditions simulate the gasketing strip of an externally manifolded MCFC. In our case, strips of carbonate-wetted LiAlO, (Cyprus-Foote) were made from cold-pressed powders (1 50 MPa). The strip contained eight gold probes spaced regularly along its length and Ni electrode strips at each end to apply the voltage. At 650°C, a potential of about 20 V was applied across a 10-cm-long bar of material containing electrolyte and LiA10,. Measuring voltage drops along the length of the strip was used to gauge electrolyte content and composition. This assembly was held between two alumina plates (held in compression by a Belleville spring washer) that also formed the gas-flow channels. The strip was purged with a 2: 1 0, to CO, gas mixture (500 mL/min) at 655+10”C. The effects of cell chemistry on Li-Na carbonate electrolyte segregation were investigated in 10 x 10-cm cell tests. Electrolyte tiles containing selected carbonate compositions were prepared and tested at 650°C in cells containing standard Ni cathodes and anodes, unlike the studies by other developers of MCFCs with Li/Na electrolytes [5]. After an initial conditioning period of at least 500 h and under laboratory-standard oxidant, the current density in the cells was increased to at least 250 mA/cm2. The cells were quenched under electric load to maintain electrolyte constituent distribution. Results Strip “Gasket” Test. The fully-developed potential distributions after 72 h at 20 V from the strip tests with the four Lima compositions carbonate was obtained, Fig. 1. Composition (a) is a near eutectic composition of Li/Na carbonate. The potential distribution of off-eutectic Lima carbonate compositions equilibrate with less voltage variation than for composition (a). The strip samples were quenched under load and later examined by metallography. The trend is clear; the fully developed potential distribution becomes more uniform as Lima ratio is distanced from the eutectoid composition. Composition (c) provides the least electrolyte segregation. These strip samples were mounted in epoxy to permit sampling for chemical analysis. We are unable to determine Na content with energy-dispersive spectroscopy (EDS). An inductively coupled plasmdatomic emission spectroscopy (ICP/AES) analysis of these strip elements is under way to further support the non-segregating characteristics that have been determined from cell tests. ” 5 4.5 4 3.5 3 2.5 2 1.5 1 0.5 0 m s A ma r b  x c  a d  0 5 10 15 Seal Length, cm Figure 1. Fully developed potential distribution of 12-cm-long strips (20 V applied) for four Li/Na compositions. Bench Scale Cell Tests. Bench scale, 10 x 10-cm MCFC tests were assembled with standard Ni anodes (6% Cr) and Ni cathodes. The electrolyte tile was formed by hot-pressing. The anode wet seal was aluminized with aluminum foil. Four Li/Na carbonate compositions were tested. All cells were operated for at least 500 h at 650°C. For the purposes of investigating the electrolyte seg- regation phenomenon, the cells were operated at 400 mA/cm2 for at least 0.5 h at the end of the life test. The cells were rapidly quenched to fix compositional gradients. Metallographic and analncal methods (secondary ion mass spectroscopy [SIMS]) are used to determine composition and amount of carbonate in the MCFC components. Performance data of the bench scale tests were used to compare the performance of Lima electrolyte compositions. Data on cell impedance, cell voltage, electrode performance at various utilizations, and current density operation were collected as a function of time at 1 atm with laboratory standard oxidant (air + 28% CO,) and humidified fuel (80% H, + CO,). The Li/Na composition did affect the polarization curves of these four cells. These tests were conducted with fuel and oxidant flows for 60% and 40% utilizations, respectively, at 320 mA/cm2 and 650°C. Independent from the strip test, performance improved as non-segregating electrolyte property was enhanced. By comparison, high current density operation in Li/K carbonate cells leads to early cell shorting [6]. An electrolyte segregation phenomenon or electrolyte freezing would present problems for high current density operation. This phenomenon is not seen for the non-segregating Lima composition. Post-Test Observations in 100 cm2 Cells. The SIMS analysis for Li/Na was conducted on electrolyte tile cross sections of two 10 x 10 cm MCFC test cells, Fig. 2. Cell 2 has the eutectic Li/Na carbonate composition. The object of this analysis was to examine cation segregation across the electrolyte subsequent to the quench of the cell. Based on two point values, anodekathode, the off-eutectic deviation of the Li and Na content was suppressed with the Li/Na ratio exhibiting lesser electrolyte segregation in our strip tests. These results substantiate the findings of both the strip test and the cell performance at high current density for the development of non-segregating electrolytes. Anode Tile Cathode Cell No. a h  Ratio for Li a/b Ratio for Na 1 2.3k0.9 1.8k0.4 2 8.9k2.1 1.2k0.3 Figure 2. Position-related Li- and Na-cation ratio by SIMS analysis for the cross sections of two test cells having different Li/Na compositions. Future Activities With our progress in Li/Na evaluations, we have developed a baseline for examining other electrolytes. We will continue with the strip-element tests to include alkaline-earth carbonates. Cell tests will target long-term, high-current operation as a further indication of a non-segregating electrolyte . Acknowledgments This work is being conducted under the auspices of the U. S. Department of Energy, Contract No. W-31-109-Eng-38. This research was sponsored by the DOE Morgantown Energy Technology Center (METC), Project Manager, Richard Johnson; period of performance, 10/1/96 to 7/1/96, under contract number 49943/49946. Joseph R. Stapay, Kevin T. Byrne, Steve Nied, and Sarah Zelle provided technical assistance in the laboratory References 1. 2. 3. 4. 5. 6. Y. Miyazaki, et al., “Alternative Electrolyte Compositions for MCFC,” Proc. 3rd Int’l. Symp. on Molten Carbonate Fuel Cells, Vol. 93-3, The Electrochemical Society, NJ, 1993, p. 444. E. Pigeaud, et al., “Determination of Electrolyte Composition for MCFC,” Final Report to DOE, Contract No. AC21-86MC23264, June 1989. K. Ota, et al., “Solubilities of Materials for MCFC,” Proc. Int’l. Fuel Cell Conference, Makuhari, Japan, 1992, p. 165. H. R. Kunz, “Transport of Electrolyte in Molten Carbonate Fuel Cells,” J. Electrochem. SOC., 134 (1987) 105. E. T. Ong, et al., “Cell Testing of Lima Electrolyte,” Proceedings of the 1994 Fuel Cell Seminar, San Diego, CA, 1994, p. 404. H. R. Kunz and L. J. Bregoli, “Ionic Migration in MCFC,” Proc. Second Symp. on MCFC Technology, The Electrochemical Society, Vol. 90-16, NJ, 1990, p. 157. 

Non-segregating electrolytes for molten carbonate fuel cells

https://digital.library.unt.edu/ark:/67531/metadc686932/m2/1/high_res_d/434962.pdf

Non-segregating electrolytes for molten carbonate fuel cells

Abstract

Similar works

Full text

Available Versions

UNT Digital Library