[EN] The rise of collaborative robots urges the consideration of them for different industrial tasks such as sanding. In this context, the purpose of this article is to demonstrate the feasibility of using collaborative robots in processing operations, such as orbital sanding. For the demonstration, the tools and working conditions have been adjusted to the capacity of the robot. Materials with different characteristics have been selected, such as aluminium, steel, brass, wood, and plastic. An inner/outer control loop strategy has been used, complementing the robot¿s motion control with an outer force control loop. After carrying out an explanatory design of experiments, it was observed that it is possible to perform the operation in all materials, without destabilising the control, with a mean force error of 0.32%. Compared with industrial robots, collaborative ones can perform the same sanding task with similar results. An important outcome is that unlike what might be thought, an increase in the applied force does not guarantee a better finish. In fact, an increase in the feed rate does not produce significant variation in the finish¿less than 0.02 m; therefore, the process is in a ¿saturation state¿ and it is possible to increase the feed rate to increase productivity.Rodrigo Perez-Ubeda is grateful to the Ph.D. Grant CONICYT PFCHA/Doctorado Becas Chile/2017-72180157 and the University of Antofagasta, Chile.Pérez Ubeda, R.; Gutiérrez, SC.; Zotovic Stanisic, R.; Perles, A. (2020). Behavioural Study of the Force Control Loop Used in a Collaborative Robot for Sanding Materials. Materials. 14(1):1-19. https://doi.org/10.3390/ma14010067S11914