Direct thermal management of windings enabled by additive manufacturing

Abstract

This is an accepted manuscript of an article published by IEEE in IEEE Transactions on Industry Applications on 27/09/2022, available online: https://doi.org/10.1109/TIA.2022.3209171 The accepted version of the publication may differ from the final published version.The electrification and hybridization of ground- and air-transport, in pursuit of Carbon Net Zero targets, is driving demand for high power-density electrical machines. The power-density and reliability of electrical machines is ultimately limited by their ability to dissipate internally generated losses within the temperature constraints of the electrical insulation system. As the electrical windings are typically the dominant source of loss, their enhanced design is in the critical path to improvements in power-density. Application of metal additive manufacturing has the potential to disrupt conventional winding design by removing restrictions on conductor profiles, topologies and embedded thermal management. In this paper, a modular end-winding heat exchanger concept is presented, which enables effective direct cooling without occupying valuable stator slot cross-section. In addition, this arrangement eliminates the need for a good stator-winding thermal interface, thereby allowing mechanical or other less permanent winding retention methods to be used, facilitating non-destructive disassembly and repair. A prototype winding is fabricated and experimentally tested to demonstrate the feasibility of the concept, yielding promising results.This work has been funded by EPSRC Grant Number EP/f02125X/1 and EP/S018034/1 as part of a Future Electrical Machines Manufacturing (FEMM) Hub feasibility study.Published versio