Gain, Rate and Position Resolution Limits of Micropattern Gaseous Detectors

In this study we report the results of a systematic study of the gain, rate and the position resolution limits of various micropattern gaseous detectors. It was found that at low rates (<1 Hz/mm^2) each detector has it own gain limit, which depends on the size and design features, as well as on gas composition and pressure. However, in all cases the maximum achievable gain is less than or equal to the classical Raether limit. It also was found that for all detectors tested the maximum achievable gain drops sharply with the counting rate. The position resolution of micropattern detectors for detection of X-rays (6 to 35 kV) was also studied, being demonstrated that with solid converters one could reach a position resolution better than 30 micrometers at 1 atm in a simple counting mode.Comment: 10 pages, 3 figures, Presented at the PSD99-5th International Conference on Position-Sensitive Detectors, 13-17 th September 1999, University College, Londo

High-resolution THz gain measurements in optically pumped ammonia

This study is aimed at the evaluation of THz gain properties in an optically pumped NH3 gas. NH3 molecules undergo rotational-vibrational excitation by mid-infrared (MIR) optical pumping provided by a MIR quantum cascade laser (QCL) which enables precise tuning to the NH3 infrared transition around 10.3 mu m. Pure inversion transitions, (J = 3, K = 3) at 1.073 THz and (J = 4, K = 4) at 1.083 THz were selected. The THz measurements were performed using a THz frequency multiplier chain. The results show line profiles with and without optical pumping at different NH3 pressures, and with different MIR tuning. The highest gain at room temperature under the best conditions obtained during single pass on the (3,3) line was 10.1 dBxm(-1) at 26 mu bar with a pumping power of 40 mW. The (4,4) line showed lower gain of 6.4 dBxm(-1) at 34 mu bar with a pumping power of 62 mW. To our knowledge these THz gains are the highest measured in a continuous-wave MIR pumped gas.Web of Science2616212482124

Analytic approximation of energy resolution in cascaded gaseous detectors

An approximate formula has been derived for gain fluctuations in cascaded gaseous detectors such as GEM-s, based on the assumption that the charge collection, avalanche formation and extraction steps are independent cascaded processes. In order to test the approximation experimentally, a setup involving a standard GEM layer has been constructed to measure the energy resolution for 5.9 keV gamma particles. The formula reasonably traces both the charge collection as well as the extraction process dependence of the energy resolution. Such analytic approximation for gain fluctuations can be applied to multi-GEM detectors where it aids the interpretation of measurements as well as simulations.Comment: 6 pages, 10 figures, submitted to Adv. in High Energy Phy

Experimental study of THGEM detector with mini-rim

The gas gain and energy resolution of single and double THGEM detectors (5{\times}5cm2 effective area) with mini-rims (rim is less than 10{\mu}m) were studied. The maximum gain can reach 5{\times}103 and 2{\times}105 for single and double THGEM respectively, while the energy resolution of 5.9 keV X-ray varied from 18% to 28% for both single and double THGEM detectors of different hole sizes and thicknesses.All the experiments were investigated in mixture of noble gases(argon,neon) and small content of other gases(iso-butane,methane) at atmospheric pressure.Comment: 4pages,6figures, it has been submitted to Chinese Physics

A Prismatic Analyser concept for Neutron Spectrometers

A development in modern neutron spectroscopy is to avoid the need of large samples. We demonstrate how small samples together with the right choice of analyser and detector components makes distance collimation an important concept in crystal analyser spectrometers. We further show that this opens new possibilities where neutrons with different energies are reflected by the same analyser but counted in different detectors, thus improving both energy resolution and total count rate compared to conventional spectrometers. The technique can be combined with advanced focusing geometries and with multiplexing instrument designs. We present a combination of simulations and data with 3 energies from one analyser. The data was taken on a prototype installed at PSI, Switzerland, and shows excellent agreement with the predictions. Typical improvements will be 2 times finer resolution and a factor 1.9 in flux gain compared to a Rowland geometry or 3 times finer resolution and a factor 3.2 in flux gain compared to a single flat analyser slab

Noise and thermal stability of vibrating micro-gyrometers preamplifiers

The preamplifier is a critical component of gyrometer's electronics. Indeed the resolution of the sensor is limited by its signal to noise ratio, and the gyrometer's thermal stability is limited by its gain drift. In this paper, five different kinds of preamplifiers are presented and compared. Finally, the design of an integrated preamplifier is shown in order to increase the gain stability while reducing its noise and size.Comment: Submitted on behalf of EDA Publishing Association (http://irevues.inist.fr/EDA-Publishing