Steering of fogging: control of humidity: temperature or transpiration

Fogging systems are increasingly used to cool greenhouses and prevent water stress. More recently, fogging systems are applied also in relatively low radiation environments (such as The Netherlands), for a better control of product quality than whitewashing and to reduce need for natural ventilation ¿ thus allowing for higher CO2 concentrations to be maintained in the greenhouse. Most commonly the steering of such systems is done by setting an upper limit to the deficit of specific humidity that, whenever exceeded, triggers the fogging system. In both cases, however, one may wonder whether static and pre-fixed set points are the most effective choice. In the experiment presented in this paper, fogging and venting were controlled with the purpose of steering crop transpiration. The desired transpiration rate was the input of an algorithm that calculated on-line the required humidity and air temperature set points in view of the current weather factors. The set points were then the input of a standard P-controller that calculated vent opening and time of operation of the fogging system. In this paper, the resulting climate and actuator control operations are discussed and compared with a similar greenhouse controlled in a traditional fashion. The study concluded that a desired crop transpiration rate (an all-round indicator of crop well-being) could be used to select dynamic set points for the climate control in a greenhouse equipped with a fogging system

Cooling Strategies for Greenhouses in Summer: Control of Fogging by Pulse Width Modulation

The possibilities for improving the control of greenhouse fogging systems, were studied by comparing several combinations of ventilation cooling techniques, shade screening and low-pressure fogging. The study was divided into three parts: experiments, modelling and simulations. In the first part of the paper, ten combinations of five cooling techniques were tested during the summers of 2002 and 2003 in a 132m2 greenhouse with a steel structure and a single-layer methacrylate cover located in Madrid, Spain. An analysis of variance of the climatic parameters was carried out to determine which combinations produced significant differences in inside temperature or relative humidity. Comparing the values for the inside to outside temperature difference, the combination of a shade screen and above-screen fogging achieved a difference in temperature almost the same as that for under-screen fogging, but the relative humidity was significantly lower. In the second part of the study a dynamic model was developed (2002) and validated (2003). The mean absolute error obtained for inside temperature was similar in the fit and the validation and it was less than 1.5 1C in both cases. The model was used to simulate the inside air temperature for a fog system working without shading, and above and under a shade screen. Control algorithms were developed for reducing system water consumption. In the three cases a simple on/off control with a fixed fogging cycle was compared with a pulse width modulation (PWM) strategy, in which the duration of the fogging pulse was increased as a function of inside temperature. The strategies with PWM applied to the fog system were able to reduce water consumption by 8–15% with respect to the strategies with a fixed fogging cycle

Fogging technique used to coat magnesium with plastic

Cleaning process and a fogging technique facilitate the application of a plastic coating to magnesium plates. The cleaning process removes general organic and inorganic surface impurities, oils and greases, and oxides and carbonates from the magnesium surfaces. The fogging technique produces a thin-filmlike coating in a clean room atmosphere

Double window viewing chamber assembly

A viewing chamber which permits observation of a sample retained therein includes a pair of double window assemblies mounted in opposed openings in the walls thereof so that a light beam can directly enter and exit from the chamber. A flexible mounting arrangement for the outer windows of the window assemblies enables the windows to be brought into proper alignment. An electrical heating arrangement prevents fogging of the outer windows whereas desiccated air in the volume between the outer and inner windows prevents fogging of the latter

Anti-fog composition

An anti-fog composition is described for the prevention of fogging on surfaces such as space helmet visors, spacecraft windows, and windshields. It is composed of a surface active agent, water, and an oil time extender

The impact of preventive fogging on entomological parameters in a university campus in Malaysia

Preventive fogging is defined as space spraying of insecticide against mosquitoes in order to prevent outbreak of mosquito borne infection. Despite provision of various preventive andcontrol activities against dengue and chikungunya infection by Ministry of Health Guideline, the detail on preventive fogging has not yet specified. However, this has been adopted by certain institutions as part of the routine strategies against dengue outbreak. A study on preventive fogging was conducted in one of the hostels in Universiti Putra Malaysia. The research was done for 16 weeks in which one routine fogging activity was done at the mid period of study. The main objectives of this study were to determine the effectiveness of preventive fogging activities against Aedes mosquitoes and to identify the distribution and abundance of Aedes mosquitoes in the area. Method: The fogging activity was carried out by the management staff as part of their preventive measures in the student hostels. Ovitrap was used as an indicator to monitor the impact of fogging activity and its continuous surveillance was monitored weekly. The ovitraps were placed indoors and outdoors. Species identification was carried out in the laboratory. The SPSS program was used to analyse the statistical data on the effectiveness of fogging activity. Larval count (indoors and outdoors) and ovitrap index (OI) readings were identified as ovitrap surveillance data for statistical analysis. Results: The results showed that Aedes albopictus was the only species of the genus Aedes found in this hostel. The area had been highly infested by Ae. Albopictus as indicated by high Ovitrap Index ranging between 48.33% to 90.00%. The mean (SD) of Ovitrap Index was reduced from 71.67% (12.73%) (before the preventive fogging), to 69.42% (14.40%) (after the fogging). Overall reduction in mosquito and larval density was also observed between pre and post fogging activity in this study. Conclusion: The implementation of preventive fogging has favourably reduced the dengue vector population up to 5 weeks after the introduction of preventive fogging. However, sole dependency on preventive fogging may lead to insecticide resistance. Revisiting the policy on preventive fogging; and identifying it as an additional tool for preventing dengue infection in higher learning institutions are recommended

Study of the Influence the Acidity Level of Sulphuric Acid to Thermal Cracking and Triglyceride Saturation of Crude Palm Oil by Using Two Stages Electrochemical Thermal Cracking

Crude Palm Oil (CPO) was experienced with electrolyze by using two stages electrochemical thermal cracking reactor, zeolyte as catalyst, silver as cathode and cuprum as anode. In this research, we used electrolyte solution for 2 kinds of concentrate which was 40 and 60% of sulphuric acid (H2SO4). It worked in 1 atm with electrolyze for 1 hour, heating till reaching temperature 80oC for 1 hr, fogging process for 1 hr, and heating without electrolyze nor fogging about 30 minutes. From lubricity analyze, this product is a fuel with high lubricity. The analyzer showing that cracking of triglyceride of crude palm oil has same characteristics with diesel

Die Baumkronenspinnen (Araneae) des Leipziger Auwaldes

The canopy spiders of the floodplain forest in Leipzig have become a focus of ecological studies in recent years. In 2006 we sampled 30 tree canopies in the ‘Burgaue’ nature reserve with pyrethrum knock-down fogging, recording 502 adult spiders belonging to 48 species and 11 families. Based on these data and the results of a previous fogging study, the studied spider community was dominated by forest and forest-edge species with a preference for the shrub and canopy strata as well as by spiders of the web spider feeding guild. The community structure was typical for arboreal spider communities from northern temperate forests but very different from communities in the tropics. Species richness and evenness were similar to the old growth near-primary Białowieża Forest in Poland. The checklist of 96 canopy spider species of the floodplain forest of Leipzig includes 54 additions to the spider fauna of Leipzig and vicinity by recent canopy studies and eight first canopy records for Leipzig from our field work. The theridiid Dipoena torva (Thorell, 1875) was recorded for the first time in Saxony. The floodplain forest of Leipzig sustains a large and species-rich arboreal spider community and is thus a valuable habitat for a large proportion of endangered species (12%).Die Spinnen der Baumkronen des Leipziger Auwaldes wurden in den vergangenen Jahren ein Schwerpunkt ökologischer Forschung. Im Jahr 2006 untersuchten wir 30 Baumkronen im Naturschutzgebiet „Burgaue“ mithilfe der Insektizid-Baumkronenbenebelung und erhielten dabei 502 adulte Spinnen aus 48 Arten und 11 Familien. Basierend auf diesen Daten und Ergebnissen einer früheren Benebelungsstudie fanden wir, dass die untersuchte Spinnengemeinschaft von Wald- und Waldrandarten mit Präferenz für die Strauch- und Kronenschicht dominiert war. Auf Gildenniveau dominierten die Netzspinnen. Die Gemeinschaftsstruktur war typisch für eine arboreale Spinnengemeinschaft der nördlichen temperaten Wälder aber sehr verschieden von Gemeinschaften in den Tropen. Artenvielfalt und Evenness waren ähnlich dem Urwald von Białowieża in Polen. Aufgrund der Baumkronenforschungen in Leipzig beinhaltet die Baumkronen-Checkliste der 96 Spinnenarten des Leipziger Auwaldes 54 Erstnachweise für Leipzig und Umgebung. Acht Arten wurden erstmals durch unsere neuen Feldarbeiten in Leipzig nachgewiesen, die Kugelspinne Dipoena torva (Thorell, 1875) dabei erstmals in Sachsen. Der Leipziger Auwald beherbergt eine große und artenreiche arboreale Spinnengemeinschaft und ist ein wertvolles Habitat für einen großen Anteil gefährdeter Arten (12 %)

A novel one-step lens cleaning device using air and water flow for endoscopic surgery

学位記番号：医博甲173

Synopsis of the genus Empicoris (Hemiptera: Heteroptera: Reduviidae) in Chile

The species of Empicoris Wolff, 1811 recorded from Chile are listed, and an identification key for all four species is provided. New distributional records from Chile are added: E. errabundus (Say, 1832) and E. vagabundus (Linnaeus, 1758), the last species is recorded for the first time from the Neotropical Region.Fil: Melo, María Cecilia. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico Conicet - La Plata. Instituto de Limnología "Dr. Raúl A. Ringuelet". Universidad Nacional de La Plata. Facultad de Ciencias Naturales y Museo. Instituto de Limnología; ArgentinaFil: Faundez, Eduardo Iván. Universidad de Magallanes. Instituto de la Patagonia. Laboratorio de Entomología; Chil