Facile synthesis of superhydrophobic surface of ZnO nanoflakes: chemical coating and UV-induced wettability conversion

This work reports an oriented growth process of two-dimensional (2D) ZnO nanoflakes on aluminum substrate through a low temperature hydrothermal technique and proposes the preliminary growth mechanism. A bionic superhydrophobic surface with excellent corrosion protection over a wide pH range in both acidic and alkaline solutions was constructed by a chemical coating treatment with stearic acid (SA) molecules on ZnO nanoflakes. It is found that the superhydrophobic surface of ZnO nanoflake arrays shows a maximum water contact angle (CA) of 157° and a low sliding angle of 8°, and it can be reversibly switched to its initial superhydrophilic state under ultraviolet (UV) irradiation, which is due to the UV-induced decomposition of the coated SA molecules. This study is significant for simple and inexpensive building of large-scale 2D ZnO nanoflake arrays with special wettability which can extend the applications of ZnO films to many other important fields

Morphology-dependent field emission properties and wetting behavior of ZnO nanowire arrays

The fabrication of three kinds of ZnO nanowire arrays with different structural parameters over Au-coated silicon (100) by facile thermal evaporation of ZnS precursor is reported, and the growth mechanism are proposed based on structural analysis. Field emission (FE) properties and wetting behavior were revealed to be strongly morphology dependent. The nanowire arrays in small diameter and high aspect ratio exhibited the best FE performance showing a low turn-on field (4.1 V/μm) and a high field-enhancement factor (1745.8). The result also confirmed that keeping large air within the films was an effective way to obtain super water-repellent properties. This study indicates that the preparation of ZnO nanowire arrays in an optimum structural model is crucial to FE efficiency and wetting behavior

Fabrication and ultraviolet photoresponse characteristics of ordered SnOx (x ≈ 0.87, 1.45, 2) nanopore films

Based on the porous anodic aluminum oxide templates, ordered SnOx nanopore films (approximately 150 nm thickness) with different x (x ≈ 0.87, 1.45, 2) have been successfully fabricated by direct current magnetron sputtering and oxidizing annealing. Due to the high specific surface area, this ordered nanopore films exhibit a great improvement in recovery time compared to thin films for ultraviolet (UV) detection. Especially, the ordered SnOx nanopore films with lower x reveal higher UV light sensitivity and shorter current recovery time, which was explained by the higher concentration of the oxygen vacancies in this SnOx films. This work presents a potential candidate material for UV light detector

Realization of broadband index-near-zero modes in nonreciprocal magneto-optical heterostructures

Epsilon-near-zero (ENZ) metamaterial with the relative permittivity approaching zero has been a hot research subject in the past decades. The wave in the ENZ region has infinite phase velocity ($v=1/\sqrt{\varepsilon\mu}$), whereas it cannot efficiently travel into the other devices or air due to the impedance mismatch or near-zero group velocity. In this paper, we demonstrate that the tunable index-near-zero (INZ) modes with vanishing wavenumbers ($k=0$) and nonzero group velocities ($v_\mathrm{g} \neq 0$) can be achieved in nonreciprocal magneto-optical systems. This kind of INZ modes has been experimentally demonstrated in the photonic crystals at Dirac point frequencies and that impedance-matching effect has been observed as well. Our theoretical analysis reveals that the INZ modes exhibit tunability when changing the parameter of the one-way (nonreciprocal) waveguides. Moreover, owing to the zero-phase-shift characteristic and decreasing $v_\mathrm{g}$ of the INZ modes, several perfect optical buffers (POBs) are proposed in the microwave and terahertz regimes. The theoretical results are further verified by the numerical simulations performed by the finite element method. Our findings may open the new avenues for research in the areas of ultra -strong or -fast nonlinearity, perfect cloaking, high-resolution holographic imaging and wireless communications

Combined transarterial chemoembolization and microwave ablation versus transarterial chemoembolization in BCLC stage B hepatocellular carcinoma

PURPOSE:We aimed to compare the clinical effectiveness of combination therapy of transarterial chemoembolization (TACE) and microwave ablation (MWA) with TACE monotherapy in BCLC stage B HCC patients with tumor size ≤7 cm and tumor number ≤5.METHODS:We retrospectively reviewed 150 BCLC stage B HCC patients who had received TACE monotherapy or TACE-MWA combination therapy in our hospital from March 2007 to April 2016. The patients were matched by propensity score at the ratio of 1:2 by optimal method. The median follow-up period was 16 months. The overall survival, tumor response and progression-free survival were compared between the two groups by Kaplan–Meier method and Log rank test.RESULTS:Tumor response (complete or partial response or stable disease) rates at 6, 12, 18, 24 months were 55.5%, 37.3%, 21.3%, 15.8% for TACE group, and 74%, 47.8%, 35%, 31.8% for TACE-MWA group, respectively. The survival rates at 1, 3, 5 years were 77.5%, 42.1%, 21% for TACE group and 93.1%, 79%, 67.7% for TACE-MWA group, respectively. Compared with TACE group, the TACE-MWA group had significantly improved progression-free survival (P = 0.044) and overall survival (P = 0.002).CONCLUSION:TACE-MWA combination therapy has better clinical effectiveness than TACE monotherapy in BCLC stage B patients with tumor size ≤7 cm and tumor number ≤5

Sound trapping in an open resonator

The ability of sound energy confinement with high-quality factor resonance is of vital importance for acoustic devices requiring high intensity and hypersensitivity in biological ultrasonics, enhanced collimated sound emission (i.e. sound laser) and high-resolution sensing. However, structures reported so far have been experimentally demonstrated with a limited quality factor of acoustic resonances, up to several tens in an open resonator. The emergence of bound states in the continuum makes it possible to realize high quality factor acoustic modes. Here, we report the theoretical design and experimental demonstration of acoustic bound states in the continuum supported by a single open resonator. We predicted that such an open acoustic resonator could simultaneously support three types of bound states in the continuum, including symmetry protected bound states in the continuum, Friedrich-Wintgen bound states in the continuum induced by mode interference, as well as a new type-mirror symmetry induced bound states in the continuum. We also experimentally demonstrated their existence with quality factor up to one order of magnitude greater than the highest quality factor reported in an open resonator

Topological Supercavity Resonances in the Finite System

Acoustic resonant cavities play a vital role in modern acoustical systems. The ultrahigh quality-factor resonances are highly desired for some applications such as high-resolution acoustic sensors and acoustic lasers. Here, a class of supercavity resonances is theoretically proposed and experimentally demonstrated in a coupled acoustic resonator system, arising from the merged bound states in the continuum (BICs) in geometry space. Their topological origin is demonstrated by explicitly calculating their topological charges before and after BIC merging, accompanied by charges annihilation. Compared with other types of BICs, they are robust to the perturbation brought by fabrication imperfection. Moreover, it is found that such supercavity modes can be linked with the Friedrich-Wintgen BICs supported by an entire rectangular (cuboid) resonator sandwiched between two rectangular (or circular) waveguides and thus more supercavity modes are constructed. Then, these coupled resonators are fabricated and such a unique phenomenon-moving, merging, and vanishing of BICs-is experimentally confirmed by measuring their reflection spectra, which show good agreement with the numerical simulation and theoretical prediction of mode evolution. The results may find exciting applications in acoustic and photonics, such as enhanced acoustic emission, filtering, and sensing

A General Framework of Bound States in the Continuum in an Open Acoustic Resonator

Bound states in the continuum (BICs) provide a viable way of achieving high-Q resonances in both photonics and acoustics. In this work, we proposed a general method of constructing Friedrich-Wintgen (FW) BICs and accidental BICs in a coupled acoustic waveguide-resonator system. We demonstrated that FW BICs can be achieved with arbitrary two degenerate resonances in a closed resonator regardless of whether they have the same or opposite parity. Moreover, their eigenmode profiles can be arbitrarily engineered by adjusting the position of attached waveguide. That suggests an effective way of continuous switching the nature of BIC from FW BIC to symmetry-protected BIC or accidental BICs. Also, such BICs are sustained in the coupled waveguide-resonator system with shapes such as rectangle, ellipse, and rhomboid. These interesting phenomena are well explained by the two-level effective non Hermitian Hamiltonian, where two strongly coupled degenerate modes play a major role in forming such FW BICs. Besides, we found that such an open system also supports accidental BICs in geometry space instead of momentum space via tuning the position of attached waveguide, which are attributed to the quenched coupling between the waveguide and eigenmodes of the closed cavity. Finally, we fabricated a series of 3D coupled-resonator-waveguide and experimentally verified the existence of FW BICs and accidental BICs by measuring the transmission spectra. Our results complement the current BIC library in acoustics and provide new routes for designing novel acoustic devices, such as in acoustic absorbers, filters and sensors.Comment: 20 pages, 6 figure

Heterosexual Rejection and Mate Choice: A Sociometer Perspective

Previous studies about the effects of social rejection on individuals’ social behaviors have produced mixed results and tend to study mating behaviors from a static point of view. However, mate selection in essence is a dynamic process, and therefore sociometer theory opens up a new perspective for studying mating and its underlying practices. Based on this theory and using self-perceived mate value in the relationship between heterosexual rejection and mate choice as a mediating role, this current study examined the effects of heterosexual rejection on mate choice in two experiments. Results showed that heterosexual rejection significantly reduced self-perceived mate value, expectation, and behavioral tendencies, while heterosexual acceptance indistinctively increased these measures. Self-perceived mate value did not serve as a mediator in the relationship between heterosexual rejection and mate expectation, but it mediated the relationship between heterosexual rejection and mating behavior tendencies towards potential objects. Moreover, individuals evaded both rejection and irrelevant people when suffering from rejection