41 research outputs found

    Magnetic phenomena in 5d transition metal nanowires

    Full text link
    We have carried out fully relativistic full-potential, spin-polarized, all-electron density-functional calculations for straight, monatomic nanowires of the 5d transition and noble metals Os, Ir, Pt and Au. We find that, of these metal nanowires, Os and Pt have mean-field magnetic moments for values of the bond length at equilibrium. In the case of Au and Ir, the wires need to be slightly stretched in order to spin polarize. An analysis of the band structures of the wires indicate that the superparamagnetic state that our calculations suggest will affect the conductance through the wires -- though not by a large amount -- at least in the absence of magnetic domain walls. It should thus lead to a characteristic temperature- and field dependent conductance, and may also cause a significant spin polarization of the transmitted current.Comment: 7 pages, 5 figure

    Tunneling broadening of vibrational sidebands in molecular transistors

    Full text link
    Transport through molecular quantum dots coupled to a single vibration mode is studied in the case with strong coupling to the leads. We use an expansion in the correlation between electrons on the molecule and electrons in the leads and show that the tunneling broadening is strongly suppressed by the combination of the Pauli principle and the quantization of the oscillator. As a consequence the first Frank-Condon step is sharper than the higher order ones, and its width, when compared to the bare tunneling strength, is reduced by the overlap between the groundstates of the displaced and the non-displaced oscillator.Comment: 8 pages, 3 figures. PRB, in pres

    Conductance of single-atom platinum contacts: Voltage-dependence of the conductance histogram

    Get PDF
    The conductance of a single-atom contact is sensitive to the coupling of this contact atom to the atoms in the leads. Notably for the transition metals this gives rise to a considerable spread in the observed conductance values. The mean conductance value and spread can be obtained from the first peak in conductance histograms recorded from a large set of contact-breaking cycles. In contrast to the monovalent metals, this mean value for Pt depends strongly on the applied voltage bias and other experimental conditions, ranging from about 1 to 2.5 times 2e^2/h. We propose that the different results in part can be explained by the inclusion of hydrogen in the contacts. The bias dependence of the conductance is on the other hand due to the electron current that destabilizes monatomic Pt chains at high bias.Comment: 4 pages, 4 figure

    Electronic transport and vibrational modes in the smallest molecular bridge: H2 in Pt nanocontacts

    Full text link
    We present a state-of-the-art first-principles analysis of electronic transport in a Pt nanocontact in the presence of H2 which has been recently reported by Smit et al. in Nature 419, 906 (2002). Our results indicate that at the last stages of the breaking of the Pt nanocontact two basic forms of bridge involving H can appear. Our claim is, in contrast to Smit et al.'s, that the main conductance histogram peak at G approx 2e^2/h is not due to molecular H2, but to a complex Pt2H2 where the H2 molecule dissociates. A first-principles vibrational analysis that compares favorably with the experimental one also supports our claim .Comment: 5 pages, 3 figure

    Electron transport across a quantum wire in the presence of electron leakage to a substrate

    Full text link
    We investigate electron transport through a mono-atomic wire which is tunnel coupled to two electrodes and also to the underlying substrate. The setup is modeled by a tight-binding Hamiltonian and can be realized with a scanning tunnel microscope (STM). The transmission of the wire is obtained from the corresponding Green's function. If the wire is scanned by the contacting STM tip, the conductance as a function of the tip position exhibits oscillations which may change significantly upon increasing the number of wire atoms. Our numerical studies reveal that the conductance depends strongly on whether or not the substrate electrons are localized. As a further ubiquitous feature, we observe the formation of charge oscillations.Comment: 7 pages, 7 figure

    A Current Induced Transition in atomic-sized contacts of metallic Alloys

    Get PDF
    We have measured conductance histograms of atomic point contacts made from the noble-transition metal alloys CuNi, AgPd, and AuPt for a concentration ratio of 1:1. For all alloys these histograms at low bias voltage (below 300 mV) resemble those of the noble metals whereas at high bias (above 300 mV) they resemble those of the transition metals. We interpret this effect as a change in the composition of the point contact with bias voltage. We discuss possible explanations in terms of electromigration and differential diffusion induced by current heating.Comment: 5 pages, 6 figure

    Conductance and persistent current of a quantum ring coupled to a quantum wire under external fields

    Full text link
    The electronic transport of a noninteracting quantum ring side-coupled to a quantum wire is studied via a single-band tunneling tight-binding Hamiltonian. We found that the system develops an oscillating band with antiresonances and resonances arising from the hybridization of the quasibound levels of the ring and the coupling to the quantum wire. The positions of the antiresonances correspond exactly to the electronic spectrum of the isolated ring. Moreover, for a uniform quantum ring the conductance and the persistent current density were found to exhibit a particular odd-even parity related with the ring-order. The effects of an in-plane electric field was also studied. This field shifts the electronic spectrum and damps the amplitude of the persistent current density. These features may be used to control externally the energy spectra and the amplitude of the persistent current.Comment: Revised version, 7 pages and 9 figures. To appear in Phys. Rev.

    Calibration of the length of a chain of single gold atoms

    Get PDF
    Using a scanning tunneling microscope or mechanically controllable break junctions it has been shown that it is possible to control the formation of a wire made of single gold atoms. In these experiments an interatomic distance between atoms in the chain of ~3.6 Angstrom was reported which is not consistent with recent theoretical calculations. Here, using precise calibration procedures for both techniques, we measure length of the atomic chains. Based on the distance between the peaks observed in the chain length histogram we find the mean value of the inter-atomic distance before chain rupture to be 2.6 +/- 0.2 A . This value agrees with the theoretical calculations for the bond length. The discrepancy with the previous experimental measurements was due to the presence of He gas, that was used to promote the thermal contact, and which affects the value of the work function that is commonly used to calibrate distances in scanning tunnelling microscopy and mechanically controllable break junctions at low temperatures.Comment: 6 pages, 6 figure

    Decoherence in elastic and polaronic transport via discrete quantum states

    Full text link
    Here we study the effect of decoherence on elastic and polaronic transport via discrete quantum states. The calculations are performed with the help of nonperturbative computational scheme, based on the Green's function theory within the framework of polaron transformation (GFT-PT), where the many-body electron-phonon interaction problem is mapped exactly into a single-electron multi-channel scattering problem. In particular, the influence of dephasing and relaxation processes on the shape of the electrical current and shot noise curves is discussed in detail under the linear and nonlinear transport conditions.Comment: 11 pages, 3 figure

    Towards unified understanding of conductance of stretched monatomic contacts

    Full text link
    When monatomic contacts are stretched, their conductance behaves in qualitatively different ways depending on their constituent atomic elements. Under a single assumption of resonance formation, we show that various conductance behavior can be understood in a unified way in terms of the response of the resonance to stretching. This analysis clarifies the crucial roles played by the number of valence electrons, charge neutrality, and orbital shapes.Comment: 2 figure
    corecore