Auto-spermatophore extrusion in male crickets

The reproductive cycle of the male cricket consists of the mating stage and the sexually refractory stage. The latter is further divided into the first refractory stage (RS1) from spermatophore extrusion in copulation to spermatophore preparation after copulation, and the second refractory stage (RS2) from spermatophore preparation to recommencement of a calling song. RS2 is time-fixed and unaffected by the female or by stress, hence RS2 is assumed to be controlled by the reproductive timer. Previously, we suggested that the timer is located in the terminal abdominal ganglion (TAG), because functional inactivation of the TAG by local cooling lengthened RS2 in proportion to cooling time. To obtain further evidence of timer localization and to examine the operation of the timer in dissected animals, we investigated the characteristics of auto-spermatophore extrusion, a phenomenon in which males eject the mature spermatophore themselves without any prior courtship. The occurrence of auto-spermatophore extrusion was 100% in dissected males with the TAG separated, compared to 1.7% in intact males. The time interval (SPaSE) between spermatophore preparation and autospermatophore extrusion was comparable to RS2 measured by the calling song. Spike recording from a genital motor neurone in the separated TAG indicated that burst discharge associated with auto-spermatophore extrusion occurred with a SPaSE comparable to RS2. Other efferent neurones, some of which were identified as dorsal unpaired median (DUM) neurones, showed a timedependent spike frequency increase during SPaSE. These results strengthen our previous conclusion that the reproductive timer is located within the TAG, and demonstrate that the timer functions normally even when the TAG is separated from the central nervous system.</p

The preparation of BP single crystals by high pressure flux method

Single crystals of BP, a III-V compound semiconductor, were obtained by the high pressure flux method. Cu3P and Ni12P5 powders were used as the flux, and mixed with BP powder. Two kinds of mixtures were prepared: (1) 1.8g (BP) + 35 G (Cu3P) and (2) 1.7 g (BP) + 25 g (Ni12P5). They were compressed into pellets, heated at 1300 C for 24 h in an induction furnace under a pressure of 1 MPa using Ar-P2 gas, and slowly cooled to room temperature. In case (1), BP single crystals grew along the (III) plane, and in case (2) they grew as an aggregate of crystallites. The cathodoluminescence spectra of the synthetic BP crystals showed peaks near 680 nm (1.82 eV) for case (1), and 500 nm (2.47 eV) for case (2). By using the high pressure flux method conventional sized crystals were obtained in a relatively short time