Unsteady disturbances in a swept wing boundary layer due to plasma forcing

This work investigates the response of a transitional boundary layer to spanwise-invariant dielectric barrier discharge plasma actuator (PA) forcing on a 45 swept wing at a chord Reynolds number of 2:17 106. Two important parameters of the PA operation are scrutinized, namely, the forcing frequency and the streamwise location of forcing. An array of passive discrete roughness elements is installed near the leading edge to promote and condition a set of critical stationary crossflow (CF) instability modes. Numerical solutions of the boundary layer equations and linear stability theory are used in combination with the experimental pressure distribution to provide predictions of critical stationary and traveling CF instabilities. The laminar–turbulent transition front is visualized and quantified by means of infrared thermography. Measurements of velocity fields are performed using hotwire anemometry scans at specific chordwise locations. The results demonstrate the inherent introduction of unsteady velocity disturbances by the plasma forcing. It is shown that, depending on actuator frequency and location, these disturbances can evolve into typical CF instabilities. Positive traveling low-frequency type III modes are generally amplified by PA in all tested cases, while the occurrence of negative traveling high-frequency type I secondary modes is favored when PA is operating at high frequency and at relatively downstream locations, with respect to the leading edg

Aeroacoustics of sawtooth trailing-edge serrations under aerodynamic loading

The impact of aerodynamic loading on a serrated trailing edge is studied experimentally. Aerodynamic and acoustic measurements are conducted on a sawtooth-shaped trailing edge, retrofitted to a flat plate featuring a trailing-edge flap, and placed at incidence to the free-stream flow. The turbulent flow across the trailing edge is inspected by time-resolved three-dimensional velocity field measurements obtained from 4D-PIV, while the wall-pressure fluctuations are measured with surface-embedded microphones. Results discuss the relation between the velocity fluctuations over the serrations, the surface pressure fluctuations, and the far-field noise spectra. The aerodynamic analysis discusses the effect of counter-rotating vortex pairs, generated by the pressure imbalance across the edges of the serrations under loading. It is shown that the interaction of these vortices with the incoming turbulence affects the intensity of the wall-pressure spectrum at the outer rim of the serration surface. On the suction side, the intensity of the pressure fluctuations from the incoming boundary layer dominates over that induced by the vortex pairs. On the pressure side, instead, the velocity gradient prescribed by the vortex pairs produces a significant increase of the pressure fluctuations around the edges. The resulting spatial distribution of the wall-pressure fluctuations directly affects the far-field noise. Scattering predictions carried out with the wall-pressure fluctuations in the centre and root (on the suction side) exhibit good agreement with the measured noise in the low-frequency range, whereas using the surface pressure data at the tip of the serration (on the pressure side) yields a better prediction in the high-frequency range

The Ampullae of the Inner Ear in the Lizard Podarcis S. Sicula. Ultrastructural Aspects

The inner ear ampullae of the lizard Podarcis s. sicula were studied to determine better the ultrastructure of ampullar epithelial cells. Our study confirmed that the ampullae of the membranous labyrinth of this lizard are similar to those of other vertebrates in their ultrastructural aspect. Moreover, our observations revealed a special type of dark cells, restricted to a small area of the crista. They appeared similar to type II sensory cells and showed a dark, finely granular cytoplasm, containing numerous mitochondria and ribosomes, extensive Golgi apparatus and abundant glycogen. The morphology of these cells suggests that they may be special sensory cells, or different stages of sensory cells, probably implied in the crista cell turn-over described for some vertebrate groups

Effects of yawed inflow on the aerodynamic and aeroacoustic performance of ducted wind turbines

Ducted Wind Turbines (DWTs) can be used for energy harvesting in urban areas where non-uniform inflows might be the cause of aerodynamic and acoustic performance degradation. For this reason, an aerodynamic and aero-acoustic analysis of DWTs in yawed inflow condition is performed for two duct geometries: a baseline commercial DWT model, DonQi®, and one with a duct having a higher cross-section camber with respect to the baseline, named DonQi D5. The latter has been obtained from a previous optimization study. A numerical investigation using Lattice-Boltzmann Very-Large-Eddy Simulations is presented. Data confirm that the aerodynamic performance improvement, i.e. increase of the power coefficient, is proportional to the increase of the duct thrust force coefficient. It is found that, placing the DWT at a yaw angle of 7.5 , the aerodynamic performances of the DonQi D5 DWT model are less affected by the yaw angle. On the other hand, this configuration shows an increase of broadband noise with respect to the baseline DonQi® one, both in non-yawed and yawed inflow conditions. This is associated to turbulent boundary layer trailing edge noise due to the turbulent flow structures developing along the surface of the duct

Antiproliferative effects of Ceratonia siliqua L. on mouse hepatocellular carcinoma cell line

Extracts from pods and leaves of carob (Ceratonia siliqua L.) were tested for their ability to inhibit cell proliferation of mouse hepatocellular carcinoma cell line (T1). The two extracts showed a marked alteration of T1 cell proliferation in a dose-related fashion reaching the maximal effect at 1 mg/ml. Moreover, we demonstrated that leaf and pod extracts were able to induce apoptosis in T1 cell lines after 24-h treatment mediating a direct activation of the caspase 3 pathway. HPLC analysis revealed the presence of gallic acid, epigallocatechin-3-gallate and (-) epi catechin - 3 -gallate in pod and leaf extracts, compounds well known to exert antiproliferative effects. Their concentration reached 6.28 mg/g in carob leaves and 1.36 mg/g in carob pods extract. The discovery that carob pod and leaf extracts contained antiproliferative agents could be of practical importance in the development of functional foods and/or chemopreventive drugs

Definition of a benchmark for low Reynolds number propeller aeroacoustics

Experimental and numerical results of a propeller of 0.3 m diameter operated at 5000 RPM and axial velocity ranging from 0 to 20 m/s and advance ratio ranging from 0 to 0.8 are presented as a preliminary step towards the definition of a benchmark configuration for low Reynolds number propeller aeroacoustics. The corresponding rotational tip Mach number is 0.23 and the Reynolds number based on the blade sectional chord and flow velocity varies from about 46000 to 106000 in the operational domain and in the 30% to 100% blade radial range. Force and noise measurements carried out in a low-speed semi-anechoic wind-tunnel are compared to scale-resolved CFD and low-fidelity numerical predictions. Results identify the experimental and numerical challenges of the benchmark and the relevance of fundamental research questions related to transition and other low Reynolds number effects

Acoustic wall treatments for wind tunnel aeroacoustic measurements

Sound absorbing porous materials are used to line a wind tunnel wall, in order to reduce reflections. However, the lining can have a detrimental effect on the acoustic measurements due to an increase in the noise radiated from the walls. In addition, the aerodynamic fidelity of the tunnel can be affected. In the present study, the influence of the porous materials on the boundary layer aerodynamic characteristics is assessed. The consequent aerodynamic noise scattering is also studied, and compared against the acoustic benefit from absorbing reflections in the test section. Geometric modelling is used to understand the influence of varying absorbing materials in reducing the acoustic interference caused by the reflections. The aerodynamic and acoustic results are related to the roughness, and to the viscous and inertial resistivities of the three porous materials studied. The material with highest roughness (polyester wool) is found to result in the strongest turbulent fluctuations in the boundary layer. However, it is the material with the thickest fibre diameter (PU foam), and consequent highest inertial resistivity, which generates the strongest surface noise scattering. Materials with high viscous resistivity, together with low inertial resistivity, are found to provide good sound absorbing capabilities. The results therefore indicate that the best choice of sound absorbing wall treatment for wind tunnel applications results from minimizing roughness and inertial resistivity, while maximizing viscous resistivity

Effect of Vortex Generators on NREL Wind Turbine: Aerodynamic Performance and Far-Field Noise

Passive flow separation control with vortex generators (VG) is actively used over the wind turbine blade. In this paper, the effect of vortex generators is simulated on a full-scale 2-blade wind-turbine tested at the National Renewable Energy Laboratory. The simulation is performed using Very-Large-Eddy/Lattice-Boltzmann method (VLES/LBM). The analysis focuses on the effect of vortex generators on the aerodynamic performance and far-field noise. The simulation results without vortex generators are compared with the experimental results, reaching good agreement. The vortex generators produce counter-rotating vortices in the wake which effectively delay flow separation, leading to better aerodynamic performance. The acoustic analysis indicates that the dominant noise sources are the tonal noise produced by the flow separation and the turbulent-boundary-layer trailing-edge noise. Similar noise levels are obtained for the configurations with and without vortex generators

Towards the definition of a benchmark for low Reynolds number propeller aeroacoustics

Experimental and numerical results of a propeller of 0.3 m diameter operated in quiescent standard ambient conditions at 5000 RPM and axial velocity ranging from 0 to 20 m/s and advance ratio ranging from 0 to 0.8 are presented as a preliminary step towards the definition of a benchmark configuration for low Reynolds number propeller aeroacoustics. The corresponding rotational tip Mach number is 0.231 and the Reynolds number based on the blade sectional chord and flow velocity in the whole radial and operational domain ranges from about 54000 to 106000. Force and noise measurements carried out in a low-speed semi-anechoic windtunnel are compared with scale-resolved CFD and low-fidelity numerical results. Results identify the experimental and numerical challenges of the benchmark and the relevance of fundamental research questions related to transition and other low Reynolds number effects