Observation of an incoherent thermally activated proton hopping process in calix-[4]-arene by means of anelastic spectroscopy

The anelastic spectrum of calix[4]arene was measured at two different vibrational frequencies. Three thermally activated peaks were detected. The lowest temperature peak can be described considering a continous distribution function of activation energies for the relaxation. This anelastic peak can be ascribed to a thermally activated hopping process of H atoms of the OH groups, corresponding to a flip-flop of the OH bond. From the results of the present study, it seems that anelastic spectroscopy is a good experimental technique to study atomic motion inside molecules at a mesoscopic (few molecules) level.Comment: 5 pages, 4 figures, submitted to Phys. Rev.

Communications Biophysics

Contains research objectives and reports on one research project.U.S. Air Force under Contract AF19(604)-411

Coordination between plant and apex development in Hordeum vulgare ssp. distichum

Developmental scales for cereals describe apex and plant morphology separately. In order to link crucial steps of internal and external development, in three varieties of Hordeum vulgare spp. distichum L., sown in autumn and in spring, we recorded plant, leaf and apex stage, following the scales of Zadoks, Haun, and Banerjee and Wienhues, the number of primordia, culm and spike length, and the final number of leaves and spikelets. Primordia initiation was coordinated with leaf appearance and the relative rate was constant for the initiation of productive primordia. The maximum number of primordia was achieved just before the first node became detectable, but development was completed only by those initiated before floret differentiation and internode distension started. The first spikelet was initiated when the third leaf tip became visible, and the last one when plants were at the pseudo stem erection stage and five leaves had still to appear

Optics Measurements and Matching of TT2-TT10 Line for Injection of the LHC Beam in the SPS

A well matched injection in the SPS is very important for preserving the emittance of the LHC beam. The paper presents the algorithms used for the analysis and the results of the optics measurements done in the transfer line TT2-TT10 and in the SPS. The dispersion is computed by varying the beam momentum and recording the offsets at the BPMs, while the Twiss parameters and emittance measurements in TT2-TT10 are performed with beam profile monitors equipped with OTR screens. These results are completed by those obtained with a matching monitor installed in the SPS as a prototype for the LHC. This device makes use of an OTR screen and a fast acquisition system, to get the turn by turn beam profiles right at injection in the ring, from which the beam mismatch is computed and compared with the results obtained in the line. Finally, on the basis of such measurements, a betatron and dispersion matching of TT2-TT10 for injection in the SPS has been performed and successfully put in operation