325 research outputs found
Acoustic emission characteristics of instability process of a rock plate under concentrated loading
It can facilitate the understanding of the mechanical properties and failure laws of rocks to research on the rock failure mechanism and evolution characteristics of Acoustic Emission (AE). Under the concentrated loading condition, the fracture and instability test of a rock plate was conducted by using the rock Mechanics Testing System (MTS), meanwhile, these AE events were recorded through the AE recording system. Based on the laboratory test, the numerical simulation was completed by using FLAC3D technique under the criterion that the rupture of a cell or several adjacent cells was regarded as an AE event. The results show that the process of the fracture and instability of the rock plate can be divided into four stages, such as the stress adjusting stage, the brittle fracture stage, the rock-arch bearing load stage and the rock-arch instability stage. And the acoustic emissions display the different characteristics in each one of the four stages. The temporal and spatial distribution characteristics of the AE events with large magnitudes are very similar to those of the natural earthquakes
The pole in
Using a sample of 58 million events recorded in the BESII detector,
the decay is studied. There are conspicuous
and signals. At low mass, a large
broad peak due to the is observed, and its pole position is determined
to be - MeV from the mean of six analyses.
The errors are dominated by the systematic errors.Comment: 15 pages, 6 figures, submitted to PL
Study of
New data are presented on from a sample of 58M
events in the upgraded BES II detector at the BEPC. There is a
conspicuous signal for and a peak at higher mass which
may be fitted with . From a combined analysis with
data, the branching ratio
is at the 95%
confidence level.Comment: 11 pages, 5 figures. Submitted to Phys. Lett.
Direct Measurements of the Branching Fractions for and and Determinations of the Form Factors and
The absolute branching fractions for the decays and
are determined using singly
tagged sample from the data collected around 3.773 GeV with the
BES-II detector at the BEPC. In the system recoiling against the singly tagged
meson, events for and events for decays are observed. Those yield
the absolute branching fractions to be and . The
vector form factors are determined to be
and . The ratio of the two form
factors is measured to be .Comment: 6 pages, 5 figure
Measurements of J/psi Decays into 2(pi+pi-)eta and 3(pi+pi-)eta
Based on a sample of 5.8X 10^7 J/psi events taken with the BESII detector,
the branching fractions of J/psi--> 2(pi+pi-)eta and J/psi-->3(pi+pi-)eta are
measured for the first time to be (2.26+-0.08+-0.27)X10^{-3} and
(7.24+-0.96+-1.11)X10^{-4}, respectively.Comment: 11 pages, 6 figure
BESII Detector Simulation
A Monte Carlo program based on Geant3 has been developed for BESII detector
simulation. The organization of the program is outlined, and the digitization
procedure for simulating the response of various sub-detectors is described.
Comparisons with data show that the performance of the program is generally
satisfactory.Comment: 17 pages, 14 figures, uses elsart.cls, to be submitted to NIM
Measurement of branching fractions for the inclusive Cabibbo-favored ~K*0(892) and Cabibbo-suppressed K*0(892) decays of neutral and charged D mesons
The branching fractions for the inclusive Cabibbo-favored ~K*0 and
Cabibbo-suppressed K*0 decays of D mesons are measured based on a data sample
of 33 pb-1 collected at and around the center-of-mass energy of 3.773 GeV with
the BES-II detector at the BEPC collider. The branching fractions for the
decays D+(0) -> ~K*0(892)X and D0 -> K*0(892)X are determined to be BF(D0 ->
\~K*0X) = (8.7 +/- 4.0 +/- 1.2)%, BF(D+ -> ~K*0X) = (23.2 +/- 4.5 +/- 3.0)% and
BF(D0 -> K*0X) = (2.8 +/- 1.2 +/- 0.4)%. An upper limit on the branching
fraction at 90% C.L. for the decay D+ -> K*0(892)X is set to be BF(D+ -> K*0X)
< 6.6%
Search for the Lepton Flavor Violation Processes and
The lepton flavor violation processes and are
searched for using a sample of 5.8 events collected with
the BESII detector. Zero and one candidate events, consistent with the
estimated background, are observed in and
decays, respectively. Upper limits on the branching ratios are determined to be
and at the 90% confidence level (C.L.).Comment: 9 pages, 2 figure
Early Carnian conodont fauna at Yongyue, Zhenfeng area and its implication for Ladinian-Carnian subdivision in Guizhou, South China
The subdivision of Ladinian and Carnian strata in Guizhou, South China has been a matter of intense debate because of the paucity of age-diagnostic faunas. Here we have carried out a detailed conodont biostratigraphic investigation on the Yangliujing, Zhuganpo and Wayao formations in the Yongyue section of western Guizhou Province. Conodonts are only prolific in the Zhuganpo and Wayao formations. Three genera and twenty species are identified, including two new species Quadralella wanlanensis n. sp. and Quadralella yongyueensis n. sp. They represent a rather endemic fauna of latest Ladinian to early Carnian age. Four conodont zones are established. They are, in the ascending order, the Paragondolella foliata, Quadralella polygnathiformis, Quadralella tadpole, and Quadralella aff. praelindae zones. Thus in the study area, the Zhuganpo Formation is generally of early Carnian (Julian 1) age whilst the Wayao Formation probably extends from the Julian 2 into the late Carnian (Tuvalian substage). The Ladinian–Carnian boundary (LCB) cannot be precisely defined due to the absence of the ammonoid Daxatina Canadensis and the paucity of conodonts. However, the LCB is unlikely lower than the Yangliujing–Zhuganpo formation contact. The Julian 1–Julian 2 (early Carnian) substages boundary is defined in the uppermost Zhuganpo Formation by the occurrence of basal Julian 2 ammonoid Austrotrachyceras ex gr. A. austriacum and is also evidenced by the disappearance of most short-range Julian 1 conodonts in the overlying Wayao Formation
- …