Generation of frequency multiplexed entangled single photons assisted by the entanglement

We present a scheme to generate the frequency multiplexed entangled (FME) single photons based on the entanglement between two species atomic mixture ensemble. The write and reads fields driven according to a certain timing sequence, the generation of FME single photons can be repeated until success is achieved. The source might have significant applications in wavelength division multiplexing quantum key distribution.Comment: 4 pages, 4 figures, submitted to PR

Combined fit to BaBar and Belle data on e+e- to pi+pi- psi(2S)

A combined fit is performed to the BaBar and Belle measurements of the e+e- to pi+pi-psi(2S) cross sections for center-of-mass energy between threshold and 5.5 GeV. The resonant parameters of the Y(4360) and Y(4660) are determined. The mass is 4355^{+9}_{-10}\pm 9 MeV/c^2 and the width is 103^{+17}_{-15}\pm 11 MeV/c^2 for the Y(4360), and the mass is 4661^{+9}_{-8}\pm 6 MeV/c^2 and the width is 42^{+17}_{-12}\pm 6 MeV/c^2 for the Y(4660). The production of the Y(4260) in pi+pi-psi(2S) mode is found to be at 2\sigma level, and B(Y(4260) to pi+pi-psi(2S))\Gamma_{e+e-} is found to be less than 4.3 eV/c^2 at the 90% confidence level, or equal to 7.4^{+2.1}_{-1.7} eV/c^2 depending on it interferes with the Y(4360) constructively or destructively. These information will shed light on the understanding of the nature of the Y states observed in initial state radiation processes.Comment: 8 pages, 4 figure

Non-damping oscillations at flaring loops

Context. QPPs are usually detected as spatial displacements of coronal loops in imaging observations or as periodic shifts of line properties in spectroscopic observations. They are often applied for remote diagnostics of magnetic fields and plasma properties on the Sun. Aims. We combine imaging and spectroscopic measurements of available space missions, and investigate the properties of non-damping oscillations at flaring loops. Methods. We used the IRIS to measure the spectrum over a narrow slit. The double-component Gaussian fitting method was used to extract the line profile of Fe XXI 1354.08 A at "O I" window. The quasi-periodicity of loop oscillations were identified in the Fourier and wavelet spectra. Results. A periodicity at about 40 s is detected in the line properties of Fe XXI, HXR emissions in GOES 1-8 A derivative, and Fermi 26-50 keV. The Doppler velocity and line width oscillate in phase, while a phase shift of about Pi/2 is detected between the Doppler velocity and peak intensity. The amplitudes of Doppler velocity and line width oscillation are about 2.2 km/s and 1.9 km/s, respectively, while peak intensity oscillate with amplitude at about 3.6% of the background emission. Meanwhile, a quasi-period of about 155 s is identified in the Doppler velocity and peak intensity of Fe XXI, and AIA 131 A intensity. Conclusions. The oscillations at about 40 s are not damped significantly during the observation, it might be linked to the global kink modes of flaring loops. The periodicity at about 155 s is most likely a signature of recurring downflows after chromospheric evaporation along flaring loops. The magnetic field strengths of the flaring loops are estimated to be about 120-170 G using the MHD seismology diagnostics, which are consistent with the magnetic field modeling results using the flux rope insertion method.Comment: 9 pages, 9 figures, 1 table, accepted by A&

Residual compressive strength of cement-based grouting material with early ages after fire

In this paper a comprehensive experimental investigation on the residual compressive strength of cement-based grouting materials after exposed to high temperature is presented. The research focused on the influences of different temperatures, curing ages before and after heating and water mixing ratios on the residual compressive strength of the material. The research indicates that the residual compressive strength of cement-based grouting material reduces significantly after heating. The reduction of the residual compressive strength of the material increases with increasing water mixing ratio. For the specimens exposed to higher temperature, such as 550 0C, the residual compressive strength cannot recover after heating. The research generated a set of reliable and valuable test data for the researches and practical structural engineers in the field of structural fire engineering

Multicontact Motion Retargeting Using Whole-Body Optimization of Full Kinematics and Sequential Force Equilibrium

This article presents a multicontact motion adaptation framework that enables teleoperation of high degree-of-freedom robots, such as quadrupeds and humanoids, for loco-manipulation tasks in multicontact settings. Our proposed algorithms optimize whole-body configurations and formulate the retargeting of multicontact motions as sequential quadratic programming, which is robust and stable near the edges of feasibility constraints. Our framework allows real-time operation of the robot and reduces cognitive load for the operator because infeasible commands are automatically adapted into physically stable and viable motions on the robot. The results in simulations with full dynamics demonstrated the effectiveness of teleoperating different legged robots interactively and generating rich multicontact movements. We evaluated the computational efficiency of the proposed algorithms, and further validated and analyzed multicontact loco-manipulation tasks on humanoid and quadruped robots by reaching, active pushing, and various traversal on uneven terrains