Carbonate Apatite Containing Statin Enhances Bone Formation in Healing Incisal Extraction Sockets in Rats

The purpose of this study was to evaluate the feasibility of using apatite blocks fabricated by a dissolution–precipitation reaction of preset gypsum, with or without statin, to enhance bone formation during socket healing after tooth extraction. Preset gypsum blocks were immersed in a Na3PO4 aqueous solution to make hydroxyapatite (HA) low crystalline and HA containing statin (HAFS), or in a mixed solution of Na2HPO4 and NaHCO3 to make carbonate apatite (CO) and CO containing statin (COFS). The right mandibular incisors of four-week-old male Wistar rats were extracted and the sockets were filled with one of the bone substitutes or left untreated as a control (C). The animals were sacrificed at two and four weeks. Areas in the healing socket were evaluated by micro-computed tomography (micro-CT) and histological analyses. The bone volume, trabecular thickness, and trabecular separation were greatest in the COFS group, followed by the CO, HAFS, HA, and C groups. The bone mineral density of the COFS group was greater than that of the other groups when evaluated in the vertical plane. The results of this study suggest that COFS not only allowed, but also promoted, bone healing in the socket. This finding could be applicable for alveolar bone preservation after tooth extraction

Micro-computed tomography analysis of early stage bone healing using micro-porous titanium mesh for guided bone regeneration : preliminary experiment in a canine model.

The aim of this study was to evaluate the amount of bone formation beneath a defect area after treatment with titanium mesh membranes with different thicknesses and pore sizes alone or in combination with bone graft to induce bone formation during the early stage of healing time. The mandibular premolars were extracted bilaterally from three adult beagle dogs, and 8-mm-diameter bone defects were created on the buccal site of the premolar regions. Hydroxyapatite bone graft substitute was applied in the defect site unilaterally, and other site was left empty. Then, a novel micro-porous mesh (50 μm in pore diameter) or commercially available macro-porous titanium mesh (1700 μm in pore diameter) was placed on the defect and secured with screws. After 4 weeks, the mandibles were harvested, imaged using micro-computed tomography, and prepared for histological and morphometric evaluation. Higher new bone volumes (mm3), percentage of new bone volumes in the total defect volumes (bone ratio: %), and new bone area (mm2) through morphometric evaluation were found on the novel membranes with 50-μm-diameter pores compared to the commercial titanium mesh. Moreover, experiment sites without bone graft were observed with higher new bone volume and bone ratio compared with sites with bone graft. However, bone mineral density of novel mesh was observed to be lower compared with other experimental sites. Under the experimental condition, the result of this study suggests that titanium meshes with 50-μm-diameter pores were effective for guided bone regeneration in the early stage of healing

Soft Tissue Interface with Various Kinds of Implant Abutment Materials

Various materials, such as titanium, zirconia and platinum-gold (Pt-Au) alloy, have been utilized for dental implant trans-mucosal parts. However, biological understanding of soft tissue reaction toward these materials is limited. The aim of this study was to compare the response of cell lines and soft tissue to titanium, zirconia and Pt-Au substrata. The surface hydroxyl groups and protein adsorption capacities of the substrata were measured. Next, gingival epithelial-like cells (Sa3) and fibroblastic cells (NIH3T3) were cultured on the materials, and initial cell attachment was measured. Immuno-fluorescent staining of cell adhesion molecules and cytoskeletal proteins was also performed. In the rat model, experimental implants constructed from various materials were inserted into the maxillary tooth extraction socket and the soft tissue was examined histologically and immunohistochemically. No significant differences among the materials were observed regarding the amount of surface hydroxyl groups and protein adsorption capacity. Significantly fewer cells of Sa3 and NIH3T3 adhered to the Pt-Au alloy compared to the other materials. The expression of cell adhesion molecules and a well-developed cytoskeleton was observed, both Sa3 and NIH3T3 on each material. In an animal model, soft tissue with supracrestal tissue attachment was observed around each material. Laminin-5 immuno-reactivity was seen in epithelia on both titanium and zirconia, but only in the bottom of epithelia on Pt-Au alloy. In conclusion, both titanium and zirconia, but not Pt-Au alloy, displayed excellent cell adhesion properties