Novel a‐Si:H TFT pixel circuit for electrically stable top‐anode light‐emitting AMOLEDs

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/92120/1/1.2770853.pd

Spectrophotometric Analysis of Phosphoric Acid Leakage in High-Temperature Phosphoric Acid-Doped Polybenzimidazole Membrane Fuel Cell Application

High-temperature proton exchange membrane fuel cells (HT-PEMFCs) utilize a phosphoric acid- (PA-) doped polybenzimidazole (PBI) membrane as a polymer electrolyte. The PA concentration in the membrane can affect fuel cell performance, as a significant amount of PA can leak from the membrane electrode assembly (MEA) by dissolution in discharged water, which is a byproduct of cell operation. Spectrophotometric analysis of PA leakage in PA-doped polybenzimidazole membrane fuel cells is described here. This spectrophotometric analysis is based on measurement of absorption of an ion pair formed by phosphomolybdic anions and the cationoid color reagent. Different color reagents were tested based on PA detection sensitivity, stability of the formed color, and accuracy with respect to the amount of PA measured. This method allows for nondestructive analysis and monitoring of PA leakage during HT-PEMFCs operation

A novel LTPO AMOLED pixel circuit and driving scheme for variable refresh rate

This paper proposes a novel pixel circuit and driving scheme that adopts low-temperature polycrystalline silicon and oxide thin-film transistors (LTPO TFTs) for mobile devices using active-matrix organic light-emitting diode (AMOLED) displays. The proposed pixel circuit and driving scheme provide uniform luminance and render flicker invisible at variable refresh rates (VRRs) from 1 to 120 Hz. Using the proposed pixel circuit with extended compensation time (tCOMP) improves the luminance uniformity at a high-frame rate. The proposed driving scheme applies a voltage to the driving TFTs (D-TFTs) higher than the programmed data voltage during the skip frame. This reduces the flicker caused by the hysteresis of D-TFTs during low-frame rate driving. A 6.0-inch quad high-definition (QHD) LTPO-based AMOLED display was fabricated using the new pixel circuit and driving scheme. Experimental results of the proposed pixel circuit show that the standard deviation of luminance was reduced from 0.056 to 0.008 by extending tCOMP from 2 to 8 µs. The flicker level was −51 dB, so there was no visual artifact during 1 Hz driving. A flicker-free LTPO-based AMOLED display with low power consumption is possible; driving can proceed in 1–120 Hz range

Effect of morphology of electrodeposited Ni catalysts on the behavior of bubbles generated during the oxygen evolution reaction in alkaline water electrolysis

We have investigated the release of active sites blocked by bubbles attached on the surface of catalysts during the oxygen evolution reaction (OER) in alkaline water electrolysis, via the modulation of the wetting properties of the four different morphologies of a nickel catalyst.11Nsciescopu

Electrodeposited Ni dendrites with high activity and durability for hydrogen evolution reaction in alkaline water electrolysis

Different shapes of various nickel structures, including dendrite, particle and film are fabricated by electrodeposition under various conditions. The shape of nickel structures is definitely dependent on the deposition potential, leading to different electrochemical surface area and edge facets. The nickel particle which has a polycrystalline center and edge is obtained at high negative potential. On the other hand, the nickel dendrite deposited by relatively low negative potential exhibits large electrochemical surface area and a particularly active facet for hydrogen evolution reaction (HER) in alkaline water electrolysis. In fact the nickel dendrite shows the highest catalytic activity and stability for HER among the various nickel structures.11Nsciescopu

Development of a galvanostatic analysis technique as an in-situ diagnostic tool for PEMFC single cells and stacks

A new galvanostatic analysis technique was developed for PEMFC single cells and stacks, while conventional potentiodynamic techniques, such as cyclic voltammetry for an electrochemical active surface area (EAS) and linear sweep voltammetry for a crossover current , cannot be directly utilized for stacks. Using a developed relationship for double-layer charging region, the and Cdl (double-layer capacitance) of a PEMFC single cell could be determined from the galvanostatic data under an atmosphere of nitrogen (cathodes) and hydrogen (anodes). Then, simply from the elapsed time in hydrogen adsorption/desorption region, EAS or roughness factors could be analyzed for a PEMFC single cell. For a 5-cell PEMFC stack, it was experimentally confirmed that the same analysis technique can be applied to analyze performance distribution in PEMFC stacks. As the characteristics of catalyst layers (EAS and Cdl) and polymer electrolyte membranes of individual cells can be analyzed without stack disassembly, the developed galvanostatic technique is expected to be utilized for the degradation study and performance monitoring of practical PEMFC stacks.11Nsciescopu