Metatranscriptome Revealed the Efficacy and Safety of a Prospective Approach for Agricultural Wastewater Reuse: Achieving Ammonia Retention during Biological Treatment by a Novel Natural Inhibitor Epsilon-Poly‑l‑Lysine

Appropriate inhibitors might play important roles in achieving ammonia retention in biological wastewater treatment and its reuse in agriculture. In this study, the feasibility of epsilon-poly-l-lysine (ε-PL) as a novel natural ammonia oxidation inhibitor was investigated. Significant inhibition (ammonia oxidation inhibition rate was up to 96.83%) was achieved by treating the sludge with ε-PL (400 mg/L, 12 h soaking) only once and maintaining for six cycles. Meanwhile, the organic matter and nitrite removal was not affected. This method was effective under the common environmental conditions of biological wastewater treatment. Metatranscriptome uncovered the possible action mechanisms of ε-PL. The ammonia oxidation inhibition was due to the co-decrease of Nitrosomonas abundance, ammonia oxidation genes, and the cellular responses of Nitrosomonas. Thauera and Dechloromonas could adapt to ε-PL by stimulating stress responses, which maintained the organic matter and nitrite removal. Importantly, ε-PL did not cause the enhancement of antibiotic resistance genes and virulent factors. Therefore, ε-PL showed a great potential of ammonia retention, which could be applied in the biological treatment of wastewater for agricultural reuse

Association of knowledge and belief with self-efficacy in osteoporosis prevention among middle-aged and older community residents in urban Shanghai

<p>This study aimed to determine the factors associated with self-efficacy in osteoporosis prevention, and support further intervention. </p

High-Efficiency Nanowire Solar Cells with Omnidirectionally Enhanced Absorption Due to Self-Aligned Indium–Tin–Oxide Mie Scatterers

Photovoltaic cells based on arrays of semiconductor nanowires promise efficiencies comparable or even better than their planar counterparts with much less material. One reason for the high efficiencies is their large absorption cross section, but until recently the photocurrent has been limited to less than 70% of the theoretical maximum. Here we enhance the absorption in indium phosphide (InP) nanowire solar cells by employing broadband forward scattering of self-aligned nanoparticles on top of the transparent top contact layer. This results in a nanowire solar cell with a photovoltaic conversion efficiency of 17.8% and a short-circuit current of 29.3 mA/cm² under 1 sun illumination, which is the highest reported so far for nanowire solar cells and among the highest reported for III–V solar cells. We also measure the angle-dependent photocurrent, using time-reversed Fourier microscopy, and demonstrate a broadband and omnidirectional absorption enhancement for unpolarized light up to 60° with a wavelength average of 12% due to Mie scattering. These results unambiguously demonstrate the potential of semiconductor nanowires as nanostructures for the next generation of photovoltaic devices

Photoelectrochemical Hydrogen Production on InP Nanowire Arrays with Molybdenum Sulfide Electrocatalysts

Semiconductor nanowire arrays are expected to be advantageous for photoelectrochemical energy conversion due to their reduced materials consumption. In addition, with the nanowire geometry the length scales for light absorption and carrier separation are decoupled, which should suppress bulk recombination. Here, we use vertically aligned p-type InP nanowire arrays, coated with noble-metal-free MoS₃ nanoparticles, as the cathode for photoelectrochemical hydrogen production from water. We demonstrate a photocathode efficiency of 6.4% under Air Mass 1.5G illumination with only 3% of the surface area covered by nanowires

Efficiency Enhancement of InP Nanowire Solar Cells by Surface Cleaning

We demonstrate an efficiency enhancement of an InP nanowire (NW) axial p–n junction solar cell by cleaning the NW surface. NW arrays were grown with <i>in situ</i> HCl etching on an InP substrate patterned by nanoimprint lithography, and the NWs surfaces were cleaned after growth by piranha etching. We find that the postgrowth piranha etching is critical for obtaining a good solar cell performance. With this procedure, a high diode rectification factor of 10⁷ is obtained at ±1 V. The resulting NW solar cell exhibits an open-circuit voltage (<i>V</i>_oc) of 0.73 V, a short-circuit current density (<i>J</i>_sc) of 21 mA/cm², and a fill factor (FF) of 0.73 at 1 sun. This yields a power conversion efficiency of up to 11.1% at 1 sun and 10.3% at 12 suns