480 research outputs found
Lead to Elevate the Temperature and Speed of Emergency Rescue and Nursing Care of Common Carotid Artery Rupture and Massive Hemorrhage after Operation of Typical Esophageal Cancer
Objective: Objective To explore the first aid and nursing of patientswith anastomotic fistula after radical resection of esophagus carcinomacomplicated with major carotid hemorrhage. Methods: The clinical dataof anastomotic fistula complicated with carotid artery rupture and massivehemorrhage after radical resection of typical esophageal carcinoma wereanalyzed and summarized. Results: Through the close cooperation ofmedical care, the rescue was successful. Conclusion: Earlier preventionobservation, raising first aid consciousness and actively cooperating withdoctors can improve the success rate of rescue
High performance building blocks for wireless receiver: multi-stage amplifiers and low noise amplifiers
Different wireless communication systems utilizing different standards and for multiple
applications have penetrated the normal people's life, such as Cell phone, Wireless LAN,
Bluetooth, Ultra wideband (UWB) and WiMAX systems. The wireless receiver normally
serves as the primary part of the system, which heavily influences the system performance.
This research concentrates on the designs of several important blocks of the receiver;
multi-stage amplifier and low noise amplifier.
Two novel multi-stage amplifier typologies are proposed to improve the bandwidth and
reduce the silicon area for the application where a large capacitive load exists. They were
designed using AMI 0.5 m µ CMOS technology. The simulation and measurement results
show they have the best Figure-of-Merits (FOMs) in terms of small signal and large signal
performances, with 4.6MHz and 9MHz bandwidth while consuming 0.38mW and 0.4mW
power from a 2V power supply. Two Low Noise Amplifiers (LNAs) are proposed, with one designed for narrowband
application and the other for UWB application. A noise reduction technique is proposed for
the differential cascode Common Source LNA (CS-LNA), which reduces the LNA Noise
Figure (NF), increases the LNA gain, and improves the LNA linearity. At the same time, a
novel Common Gate LNA (CG-LNA) is proposed for UWB application, which has better
linearity, lower power consumption, and reasonable noise performance.
Finally a novel practical current injection built-in-test (BIT) technique is proposed for the
RF Front-end circuits. If the off-chip component Lg and Rs values are well controlled, the
proposed technique can estimate the voltage gain of the LNA with less than 1dB (8%) error
Surface Modification of Silicone Rubber by Ion Implantation to Improve Biocompatibility
Silicone Rubber (SR) and SR-based materials have been used as medical tissue implants in the field of plastic surgery for many years, but there are still some reports of adverse reactions to long-term implants. In our study, three types of carbon ion silicone rubber were obtained by implanting three doses of carbon ions. Then, the surface characteristics, the antibacterial adhesion properties and in vivo host responses were evaluated. These study shown that ion implantation change the surface roughness and zeta potential of virgin SR; it also inhibit bacterial adhesion. At the same time, ion implantation enhance the cell proliferation, adhesion and tissue compatibility. These data indicate that carbon ion implanted silicone rubber exhibits good antibacterial adhesion properties, cytocompatibility and triggers thinner and weaker tissue capsules. In addition, according to the surface characteristics, we speculate that high surface roughness and high zeta potential may be the main factors that induce the unique biocompatibility of carbon ion implanted silicone rubber. In this chapter, we will review these results above and propose that ion implantation should be considered for further investigation and application, and carbon ion silicone rubber could be a better biomaterial to decrease silicone rubber–initiated complications
Detecting multiple cracks in beams using hierarchical genetic algorithms
This study deals with a method to identify multiple cracks in a beam. The novelty of this study is the use of a hierarchical genetic algorithm to detect the number, location, and the extent of multiple cracks. To demonstrate the feasibility of the present method, this algorithm is applied to the identification of double or triple cracks in a beam as well as four cracks. The detected crack locations and sizes are in excellent agreement with the actual ones. The numerical simulation reveal the HGA substantially reduces the total number of FE computation required and they are many orders smaller compared to conventional GA. The results also demonstrate the advantages of HGA from the viewpoints of its ability to avoid premature convergence
Analysis of Alphalactalbumin and Betalactoglobulin from the Rehydration of Bovine Colostrum Powder Using Cloud Point Extraction and Mass Spectrometry
Alphalactalbumin (α-La) and betalactoglobulin (β-Lg) in the rehydration of bovine colostrum powder were successfully separated by cloud point extraction using a nonionic surfactant Triton X-114. The effects of different factors, including the surfactant concentration, sample volume, electrolyte, and pH were discussed. The optimized conditions for cloud point extraction of alphalactalbumin (α-La) and betalactoglobulin (β-Lg) can be concluded that the best surfactant is 1% (w/v) Triton X-114, 200 μL of sample volume, 150 mmol/L NaCl, and 6% (w/v) sucrose. After cloud point extraction, the capillary electrophoresis is used to check the efficiency of the extraction procedure. The results had been effectively confirmed by the characterization with matrix-assisted laser desorption ionization time of flight mass spectrometry (MALDI-TOF MS)
A penalty ADMM with quantized communication for distributed optimization over multi-agent systems
summary:In this paper, we design a distributed penalty ADMM algorithm with quantized communication to solve distributed convex optimization problems over multi-agent systems. Firstly, we introduce a quantization scheme that reduces the bandwidth limitation of multi-agent systems without requiring an encoder or decoder, unlike existing quantized algorithms. This scheme also minimizes the computation burden. Moreover, with the aid of the quantization design, we propose a quantized penalty ADMM to obtain the suboptimal solution. Furthermore, the proposed algorithm converges to the suboptimal solution with an convergence rate for general convex objective functions, and with an R-linear rate for strongly convex objective functions
- …