Experimentally observed effects of yaw misalignment on the inflow in the rotor plane

Aerospace Engineerin

Comparison of CFD simulations to non-rotating MEXICO blades experiment in the LTT wind tunnel of TUDelft

In this paper, three dimensional flow over non-rotating MEXICO blades is simulated by CFD methods. The numerical results are compared with the latest MEXICO wind turbine blades measurements obtained in the low speed low turbulence (LTT) wind tunnel of Delft University of Technology. This study aims to validate CFD codes by using these experimental data measured in well controlled conditions. In order to avoid use of wind tunnel corrections, both the blades and the wind tunnel test section are modelled in the simulations. The ability of Menter's k-w shear stress transport (SST) turbulence model is investigated at both attached flow and massively separated flow cases. Steady state Reynolds averaged Navier Stokes (RANS) equations are solved in these computations. The pressure distribution at three measured sections are compared under the conditions of different in flow velocities and a range of angles of attack. The comparison shows that at attached flow condition, good agreement can be obtained for all three airfoil sections. Even with massively separated flow, still fairly good pressure distribution comparison can be found for the DU and NACA airfoil sections, although the RIS¬ section shows poor comparison. At the near stall case, considerable deviations exists on the forward half part of the upper surface for all three sections.Aerodynamics, Wind Energy & PropulsionAerospace Engineerin

Towards spatially constrained gust models

With the trend of moving towards 10-20MW turbines, rotor diameters are growing beyond the size of the largest turbulent structures in the atmospheric boundary layer. As a consequence, the fully uniform transients that are commonly used to predict extreme gust loads are losing their connection to reality and may lead to gross over dimensioning. More suiting would be to represent gusts by advecting air parcels and posing certain physical constraints on size and position. However, this would introduce several new degrees of freedom that significantly increase the computational burden of extreme load prediction. In an attempt to elaborate on the costs and benefits of such an approach, load calculations were done on the DTU 10 MW reference turbine where a single uniform gust shape was given various spatial dimensions with the transverse wavelength ranging up to twice the rotor diameter (357 m). The resulting loads displayed a very high spread, but remained well under the level of a uniform gust. Moving towards spatially constrained gust models would therefore yield far less conservative, though more realistic predictions at the cost of higher computation time.Aerodynamics, Wind Energy & PropulsionAerospace Engineerin

Suppression of classical flutter using a 'smart blade'

Aerospace Engineerin

Experimental and numerical investigation of the 3D VAWT wake

Aerospace Design, Integration and OperationsAerospace Engineerin

Experimental and Numerical Investigation of the Effect of Rotor Blockage on Wake Expansion

A detailed quantitative description of the aerodynamics of a horizontal axis wind turbine (HAWT) is difficult due to complexity of the flow field. Several methods from experimental to analytical are used to investigate the aerodynamics of a HAWT. In the present study, a wind tunnel experiment and computational fluid dynamics (CFD) simulations are used to explore the expansion of the wake. 2D actuator disc (AD) simulations are compared with the wind tunnel experiments. To understand the aerodynamic behavior of a model wind turbine blade, a detail flow field measurements in chordwise-spanwise directions and in the wake have been done. The measurements are performed on a 2 bladed rotor by means of Stereo Particle Image Velocimetry (Stereo PIV) in an open jet wind tunnel. In this paper, the velocity measurements performed in the wake region of the blade is presented. Actuator disc simulations are performed by applying a constant pressure jump on a permeable disc of zero thickness. Actuator disc simulations are carried out by using FLUENT 6.3.26 with the incompressible version of the Reynolds Averaged Navier-Stokes (RANS) equations. By validating the simulations with the experimental results, one may conclude that the unsteady CFD modeling works correctly and the wake expansion of the prescribed model is affected by the geometry of the Open Jet Facility (OJF).Aerodynamics, Wind Energy & PropulsionAerospace Engineerin

IEA wind annex XX: HAWT aerodynamic and models from wind tunnel measurements - final report

Aerospace Engineerin