527 research outputs found
Evolution of the Density of States Gap in a Disordered Superconductor
It has only recently been possible to study the superconducting state in the
attractive Hubbard Hamiltonian via a direct observation of the formation of a
gap in the density of states N(w). Here we determine the effect of random
chemical potentials on N(w) and show that at weak coupling, disorder closes the
gap concurrently with the destruction of superconductivity. At larger, but
still intermediate coupling, a pseudo-gap in N(w) remains even well beyond the
point at which off-diagonal long range order vanishes. This change in the
elementary excitations of the insulating phase corresponds to a crossover
between Fermi- and Bose-Insulators. These calculations represent the first
computation of the density of states in a finite dimensional disordered fermion
model via the Quantum Monte Carlo and maximum entropy methods.Comment: 4 pages, 4 figure
Model for initiation of quality factor degradation at high accelerating fields in superconducting radio-frequency cavities
A model for the onset of the reduction in SRF cavity quality factor, the
so-called Q-drop, at high accelerating electric fields is presented. Breakdown
of the surface barrier against magnetic flux penetration at the cavity equator
is considered to be the critical event that determines the onset of Q-drop. The
worst case of triangular grooves with low field of first flux penetration Hp,
as analyzed previously by Buzdin and Daumens, [1998 Physica C 294: 257], was
adapted. This approach incorporates both the geometry of the groove and local
contamination via the Ginzburg-Landau parameter kappa, so the proposed model
allows new comparisons of one effect in relation to the other. The model
predicts equivalent reduction of Hp when either roughness or contamination were
varied alone, so smooth but dirty surfaces limit cavity performance about as
much as rough but clean surfaces do. When in combination, contamination
exacerbates the negative effects of roughness and vice-versa. To test the model
with actual data, coupons were prepared by buffered chemical polishing and
electropolishing, and stylus profilometry was used to obtain distributions of
angles. From these data, curves for surface resistance generated by simple flux
flow as a function of magnetic field were generated by integrating over the
distribution of angles for reasonable values of kappa. This showed that
combined effects of roughness and contamination indeed reduce the Q-drop onset
field by ~30%, and that that contamination contributes to Q-drop as much as
roughness. The latter point may be overlooked by SRF cavity research, since
access to the cavity interior by spectroscopy tools is very difficult, whereas
optical images have become commonplace. The model was extended to fit cavity
test data, which indicated that reduction of the superconducting gap by
contaminants may also play a role in Q-drop.Comment: 15 pages with 7 figure
Superconductor-Insulator Transition in a Disordered Electronic System
We study an electronic model of a 2D superconductor with onsite randomness
using Quantum Monte Carlo simulations. The superfluid density is used to track
the destruction of superconductivity in the ground state with increasing
disorder. The non-superconducting state is identified as an insulator from the
temperature dependence of its d.c. resistivity. The value of
at the superconductor-insulator transition appears to be non-universal.Comment: PostScript, 4 pages, figures include
Disorder and chain superconductivity in YBa_2Cu_3O_{7-\delta}
The effects of chain disorder on superconductivity in YBa_2Cu_3O_{7-\delta}
are discussed within the context of a proximity model. Chain disorder causes
both pair-breaking and localization. The hybridization of chain and plane
wavefunctions reduces the importance of localization, so that the transport
anisotropy remains large in the presence of a finite fraction of
oxygen vacancies. Penetration depth and specific heat measurements probe the
pair-breaking effects of chain disorder, and are discussed in detail at the
level of the self-consistent T-matrix approximation. Quantitative agreement
with these experiments is found when chain disorder is present.Comment: 4 pages, 2 figures, submitted to PRB rapid communication
The Superconductor-Insulator Transition in a Tunable Dissipative Environment
We study the influence of a tunable dissipative environment on the dynamics
of Josephson junction arrays near the superconductor-insulator transition. The
experimental realization of the environment is a two dimensional electron gas
coupled capacitively to the array. This setup allows for the well-controlled
tuning of the dissipation by changing the resistance of the two dimensional
electron gas. The capacitive coupling cuts off the dissipation at low
frequencies. We determine the phase diagram and calculate the temperature and
dissipation dependence of the array conductivity. We find good agreement with
recent experimental results.Comment: 4 pages, 4 .eps figures, revte
The Field-Tuned Superconductor-Insulator Transition with and without Current Bias
The magnetic-field-tuned superconductor-insulator transition has been studied
in ultrathin Beryllium films quench-condensed near 20 K. In the zero-current
limit, a finite-size scaling analysis yields the scaling exponent product vz =
1.35 +/- 0.10 and a critical sheet resistance R_{c} of about 1.2R_{Q}, with
R_{Q} = h/4e^{2}. However, in the presence of dc bias currents that are smaller
than the zero-field critical currents, vz becomes 0.75 +/- 0.10. This new set
of exponents suggests that the field-tuned transitions with and without dc bias
currents belong to different universality classes.Comment: RevTex 4 pages, 4 figures, and 1 table minor change
Anisotropic Magnetoconductance in Quench-Condensed Ultrathin Beryllium Films
Near the superconductor-insulator (S-I) transition, quench-condensed
ultrathin Be films show a large magnetoconductance which is highly anisotropic
in the direction of the applied field. Film conductance can drop as much as
seven orders of magnitude in a weak perpendicular field (< 1 T), but is
insensitive to a parallel field in the same field range. We believe that this
negative magnetoconductance is due to the field de-phasing of the
superconducting pair wavefunction. This idea enables us to extract the finite
superconducting phase coherence length in nearly superconducting films. Our
data indicate that this local phase coherence persists even in highly
insulating films in the vicinity of the S-I transition.Comment: 4 pages, 4 figure RevTex, Typos Correcte
Absence of a Zero Temperature Vortex Solid Phase in Strongly Disordered Superconducting Bi Films
We present low temperature measurements of the resistance in magnetic field
of superconducting ultrathin amorphous Bi films with normal state sheet
resistances, , near the resistance quantum, . For
, the tails of the resistive transitions show the thermally activated
flux flow signature characteristic of defect motion in a vortex solid with a
finite correlation length. When exceeds , the tails become
non-activated. We conclude that in films where there is no vortex
solid and, hence, no zero resistance state in magnetic field. We describe how
disorder induced quantum and/or mesoscopic fluctuations can eliminate the
vortex solid and also discuss implications for the magnetic-field-tuned
superconductor-insulator transition.Comment: REVTEX, 4 pages, 3 figure
Infrared Studies of the Onset of Conductivity in Ultra-Thin Pb Films
In this paper we report the first experimental measurement of the infrared
conductivity of ultra-thin quenched-condensed Pb films. For dc sheet
resistances such that the ac conductance increases with
frequency but is in disagreement with the predictions of weak localization. We
attribute this behavior to the effects of an inhomogeneous granular structure
of these films, which is manifested at the very small probing scale of infrared
measurements. Our data are consistent with predictions of two-dimensional
percolation theory.Comment: Submitted to Physical Review Letter
- …