149 research outputs found

    Aqueous extraction of residual oil from sunflower press cake using a twin-screw extruder: Feasibility study

    Get PDF
    The objective of this study was to evaluate the feasibility of an aqueous process to extract the residual oil from sunflower press cakes using a co-rotating twin-screw extruder. Two different configurations were tested: the expression from whole seeds followed by the aqueous extraction, in two successive apparatus or in the same one. For the aqueous extraction stage, the oil yield depended on the operating conditions including screw rotation speed, screw profile, and inlet flow rates of press cakes and water. Liquid/solid separation required the addition of a lignocellulosic residue (wheat straw), upstream from the filtration zone. However, even with maximum fiber inlet flow (around 20% of the inlet flow rate of the solid matters for the highest amount of wheat straw), drying of the cake meal did not improve. The lixiviation of the material was also incomplete. Oil yield was better when the expression and the aqueous extraction were conducted in the same extruder. For all the trials carried out using such a configuration, the corresponding cake meal contained less than 10% residual oil, and the total oil yield was 78% in the best operating conditions. Nevertheless, the contribution of the aqueous extraction stage was extremely limited, less than 5% in the best trial, partly due to a ratio of the water to the press cake too low. For the aqueous extraction stage, the oil was extracted in the form of an oil-in-water emulsion whose stability was minimized because of its low proteins content due to their thermomechanical denaturation during the expression stage

    Direct extraction of oil from sunflower seeds by twin-screw extruder according to an aqueous extraction process: Feasibility study and influence of operating conditions

    Get PDF
    The objective of this study was to evaluate the feasibility of an aqueous process to extract sunflower seed oil using a co-rotating twin-screw extruder. Aqueous extraction was carried out using whole seeds and the influence of the operating conditions on oil yield was examined. Operating conditions included screw profile, screw rotation speed, and input flow rates of sunflower seeds and water. Liquid/solid separation required the addition of a lignocellulosic residue upstream from the filtration zone. However, even with maximum fiber input flow, drying of the cake meal did not improve. The lixiviation of the sunflower seeds was also incomplete. The aqueous extraction of the oil was more efficient in the twin-screw extruder than the reference trial conducted in a batch reactor. The best oil extraction yield obtained was approximately 55% and the residual oil content of the cake meal was approximately 30%. The hydrophobic phases produced were oil-in-water emulsions. These emulsions were stabilized by phospholipids and proteins at the interface, which are natural surface-active agents co-extracted during the process

    Direct Calophyllum oil extraction and resin separation with a binary solvent of n-hexane and methanol mixture

    Get PDF
    This study investigated the use of a mixture of n-hexane and methanol as a binary solvent for the direct oil extraction and resin separation from Calophyllum seeds, in a single step. Optimal oil and resin yields and physicochemical properties were determined by identifying the best extraction conditions. The solvent mixture tested extracted oil and resin effectively from Calophyllum seeds, and separated resin from oil. Extraction conditions affected oil and resin yields and their physicochemical properties, with the n-hexane-to-methanol ratio being the most critical factor. Oil yield improved as n-hexane-to-methanol ratio increased from 0.5:1 to 2:1, and resin yield increased as methanol-to-n-hexane ratio increased from 0.5:1 to 2:1. Physicochemical properties of oil and resin, particularly for acid value and impurity content, improved as the n-hexane-to-methanol ratio decreased from 2:1 to 0.5:1. The best oil (51% with more than 95% triglycerides) and resin (18% with more than 5% polyphenols) yields were obtained with n-hexane-to-methanol ratios of 2:1 and 0.5:1, respectively, at a temperature of 50 °C, with an extraction time of 5 h. The best values for physicochemical property of oil were a density of 0.885 g/cm3, a viscosity of 26.0 mPa.s, an acid value of 13 mg KOH/g, an iodine value of 127 g/100 g, an unsaponifiable content of 1.5%, a moisture content of 0.8% and an ash content of 0.04%

    Evolution of laparoscopic left lateral sectionectomy without the Pringle maneuver: through resection of benign and malignant tumors to living liver donation

    Get PDF
    BACKGROUND: Laparoscopic left lateral sectionectomy (LLS) has gained popularity in its use for benign and malignant tumors. This report describes the evolution of the authors' experience using laparoscopic LLS for different indications including living liver donation. METHODS: Between January 2004 and January 2009, 37 consecutive patients underwent laparoscopic LLS for benign, primary, and metastatic liver diseases, and for one case of living liver donation. Resection of malignant tumors was indicated for 19 (51%) of the 37 patients. RESULTS: All but three patients (deceased due to metastatic cancer disease) are alive and well after a median follow-up period of 20 months (range, 8-46 months). Liver cell adenomas (72%) were the main indication among benign tumors, and colorectal liver metastases (84%) were the first indication of malignancy. One case of live liver donation was performed. Whereas 16 patients (43%) had undergone a previous abdominal surgery, 3 patients (8%) had LLS combined with bowel resection. The median operation time was of 195 min (range, 115-300 min), and the median blood loss was of 50 ml (range, 0-500 ml). Mild to severe steatosis was noted in 7 patients (19%) and aspecific portal inflammation in 11 patients (30%). A median free margin of 5 mm (range, 5-27 mm) was achieved for all cancer patients. The overall recurrence rate for colorectal liver metastases was of 44% (7 patients), but none recurred at the surgical margin. No conversion to laparotomy was recorded, and the overall morbidity rate was 8.1% (1 grade 1 and 2 grade 2 complications). The median hospital stay was 6 days (range, 2-10 days). CONCLUSIONS: Laparoscopic LLS without portal clamping can be performed safely for cases of benign and malignant liver disease with minimal blood loss and overall morbidity, free resection margins, and a favorable outcome. As the ultimate step of the learning curve, laparoscopic LLS could be routinely proposed, potentially increasing the donor pool for living-related liver transplantation

    New ideas for non-animal approaches to predict repeated-dose systemic toxicity: Report from an EPAA Blue Sky Workshop

    Get PDF
    © 2020 The Authors The European Partnership for Alternative Approaches to Animal Testing (EPAA) convened a ‘Blue Sky Workshop’ on new ideas for non-animal approaches to predict repeated-dose systemic toxicity. The aim of the Workshop was to formulate strategic ideas to improve and increase the applicability, implementation and acceptance of modern non-animal methods to determine systemic toxicity. The Workshop concluded that good progress is being made to assess repeated dose toxicity without animals taking advantage of existing knowledge in toxicology, thresholds of toxicological concern, adverse outcome pathways and read-across workflows. These approaches can be supported by New Approach Methodologies (NAMs) utilising modern molecular technologies and computational methods. Recommendations from the Workshop were based around the needs for better chemical safety assessment: how to strengthen the evidence base for decision making; to develop, standardise and harmonise NAMs for human toxicity; and the improvement in the applicability and acceptance of novel techniques. “Disruptive thinking” is required to reconsider chemical legislation, validation of NAMs and the opportunities to move away from reliance on animal tests. Case study practices and data sharing, ensuring reproducibility of NAMs, were viewed as crucial to the improvement of non-animal test approaches for systemic toxicity.U.S.Environmental Protection Agency (EPA); Agency for Science, Technology and Research ( A*STAR), Singapor
    corecore