65 research outputs found
Impact of Fuel Metal Impurities on the Durability of a Light-Duty Diesel Aftertreatment System
Alkali and alkaline earth metal impurities found in diesel fuels are potential poisons for diesel exhaust catalysts. A set of diesel engine production exhaust systems was aged to 150,000 miles. These exhaust systems included a diesel oxidation catalyst, selective catalytic reduction (SCR) catalyst, and diesel particulate filter (DPF). Four separate exhaust systems were aged, each with a different fuel: ultralow sulfur diesel containing no measureable metals, B20 (a common biodiesel blend) containing sodium, B20 containing potassium, and B20 containing calcium, which were selected to simulate the maximum allowable levels in B100 according to ASTM D6751. Analysis included Federal Test Procedure emissions testing, bench-flow reactor testing of catalyst cores, electron probe microanalysis (EPMA), and measurement of thermo-mechanical properties of the DPFs. EPMA imaging found that the sodium and potassium penetrated into the washcoat, while calcium remained on the surface. Bench-flow reactor experiments were used to measure the standard nitrogen oxide (NOx) conversion, ammonia storage, and ammonia oxidation for each of the aged SCR catalysts. Vehicle emissions tests were conducted with each of the aged catalyst systems using a chassis dynamometer. The vehicle successfully passed the 0.2 gram/mile NOx emission standard with each of the four aged exhaust systems
Lean NOx reduction over Ag/alumina catalysts via ethanol-SCR using ethanol/gasoline blends
This study focuses on the activity for lean NOx reduction over sol-gel synthesized silver alumina (Ag/Al2O3) catalysts, with and without platinum doping, using ethanol (EtOH), EtOH/C3H6 and EtOH/gasoline blends as reducing agents. The effect of ethanol concentration, both by varying the hydrocarbon-to-NOx ratio and by alternating the gasoline concentration in the EtOH/gasoline mixture, is investigated. High activity for NOx reduction is demonstrated for powder catalysts for EtOH and EtOH/C3H6 as well as for monolith coated catalysts (EtOH and EtOH/gasoline). The results show that pure Ag/Al2O3 catalysts display higher NOx reduction and lower light-off temperature as compared to the platinum doped samples. The 4 wt.% Ag/Al2O3 catalyst displays 100% reduction in the range 340-425 degrees C, with up to 37% selectivity towards NH3. These results are also supported by DRIFTS (Diffuse reflection infrared Fourier transform spectroscopy) experiments. The high ammonia formation could, in combination with an NH3-SCR catalyst, be utilized to construct a NOx reduction system with lower fuel penalty cf. stand alone HC-SCR. In addition, it would result in an overall decrease in CO2 emissions
Recommended from our members
Advanced Engine/Aftertreatment System R&D
Navistar and ORNL established this CRADA to develop diesel engine aftertreatment configurations and control strategies that could meet emissions regulations while maintaining or improving vehicle efficiency. The early years of the project focused on reducing the fuel penalty associated with lean NOx trap (LNT, also known as NOx adsorber catalyst) regeneration and desulfation. While Navistar pursued engine-based (in-cylinder) approaches to LNT regeneration, complementary experiments at ORNL focused on in-exhaust fuel injection. ORNL developed a PC-based controller for transient electronic control of EGR valve position, intake throttle position, and actuation of fuel injectors in the exhaust system of a Navistar engine installed at Oak Ridge. Aftertreatment systems consisting of different diesel oxidation catalysts (DOCs) in conjunction with a diesel particle filter and LNT were evaluated under quasi-steady-state conditions. Hydrocarbon (HC) species were measured at multiple locations in the exhaust system with Gas chromatograph mass spectrometry (GC-MS) and Fourier transform infrared (FTIR) spectroscopy
- …