37 research outputs found
Recommended from our members
Polystyrene plastic: a source and sink for polycyclic aromatic hydrocarbons in the marine environment
Polycyclic aromatic hydrocarbons (PAHs) on virgin polystyrene (PS) and PS marine debris led us to examine PS as a source and sink for PAHs in the marine environment. At two locations in San Diego Bay, we measured sorption of PAHs to PS pellets, sampling at 0, 1, 3, 6, 9 and 12 months. We detected 25 PAHs using a new analytical method with comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry. Several congeners were detected on samples before deployment. After deployment, some concentrations decreased (1,3-dimethylnaphthalene and 2,6-methylnaphthalene) while most increased (2-methylanthracene and all parent PAHs (PPAHs) except fluorene and fluoranthene), suggesting PS debris is a source and sink for PAHs. When comparing sorbed concentrations of PPAHs on PS to the five most common polymers (polyethylene terephthalate (PET), high-density polyethylene (HDPE), polyvinyl chloride (PVC), low-density polyethylene (LDPE), and polypropylene (PP)), PS sorbed greater concentrations than PP, PET and PVC, similar to HDPE and LDPE. Most strikingly, at 0 months, PPAHs on PS ranged from 8-200 times greater than on PET, HDPE, PVC, LDPE, and PP. The combination of greater PAHs in virgin pellets and large sorption suggests that PS may pose a greater risk of exposure to PAHs upon ingestion
Recommended from our members
Contaminants of Emerging Concern in Fish from Western U.S. and Alaskan National Parks — Spatial Distribution and Health Thresholds
Remote national parks of the western U.S. and Alaska are not immune to contaminants of emerging
concern. Semivolatile organic compounds (SOCs) such as pesticides and PCBs can selectively deposit from
the atmosphere at higher rates in cold, high-elevation and high-latitude sites, potentially increasing risk to
these ecosystems. In the environment, SOCs magnify up food chains and are known to increase health risks
such as cancer and reproductive impairment. One hundred twenty-eight fish in 8 national parks in Alaska and
the western U.S. were analyzed for contaminant concentrations, assessed by region, and compared to human
and wildlife health thresholds. SOC concentrations from an additional 133 fish from a previous study were also
included, for a total of 31 water bodies sampled. PCBs, endosulfan sulfate, and p,p′-DDE were among the most
frequently detected contaminants. Concentrations of historic-use pesticides dieldrin, p,p′-DDE, and/or chlordanes
in fish exceeded USEPA guidelines for human subsistence fish consumers and wildlife (kingfisher) health
thresholds at 13 of 14 parks. Average concentrations in fish ranged from 0.6-280 ng/g lipid (0.02-7.3 ÎĽg/g ww).
Contaminant loading was highest in fish from Alaskan and Sierra Nevada parks. Historic compounds were highest
in Alaskan parks, while current-use pesticides were higher in the Rockies and Sierra Nevada. This study
provides a rigorous analysis of CECs in fish from national parks and identifies regions at potential risk.Keywords: Consumption thresholds, Fish, Semivolatile organic compounds, National park
Recommended from our members
Polystyrene plastic: a source and sink for polycyclic aromatic hydrocarbons in the marine environment
Polycyclic aromatic hydrocarbons (PAHs) on virgin polystyrene (PS) and PS marine debris led us to examine PS as a source and sink for PAHs in the marine environment. At two locations in San Diego Bay, we measured sorption of PAHs to PS pellets, sampling at 0, 1, 3, 6, 9 and 12 months. We detected 25 PAHs using a new analytical method with comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry. Several congeners were detected on samples before deployment. After deployment, some concentrations decreased (1,3-dimethylnaphthalene and 2,6-methylnaphthalene) while most increased (2-methylanthracene and all parent PAHs (PPAHs) except fluorene and fluoranthene), suggesting PS debris is a source and sink for PAHs. When comparing sorbed concentrations of PPAHs on PS to the five most common polymers (polyethylene terephthalate (PET), high-density polyethylene (HDPE), polyvinyl chloride (PVC), low-density polyethylene (LDPE), and polypropylene (PP)), PS sorbed greater concentrations than PP, PET and PVC, similar to HDPE and LDPE. Most strikingly, at 0 months, PPAHs on PS ranged from 8-200 times greater than on PET, HDPE, PVC, LDPE, and PP. The combination of greater PAHs in virgin pellets and large sorption suggests that PS may pose a greater risk of exposure to PAHs upon ingestion
Recommended from our members
Relative Influence of Trans-Pacific and Regional Atmospheric Transport of PAHs in the Pacific Northwest, US
The relative influences of trans-Pacific and regional atmospheric transport on measured concentrations of polycyclic aromatic hydrocarbons (PAHs), PAH derivatives [Nitro- (NPAH) and Oxy-(OPAH)], organic carbon (OC), and Particulate Matter (PM) less than 2.5 μm in diameter (PM₂.₅) were investigated in the Pacific Northwest, USA in 2010-2011. Ambient high volume PM₂.₅ air samples were collected at two sites in the Pacific Northwest: 1.) Mount Bachelor Observatory (MBO) in the Oregon Cascade Range (2763 m above sea level (asl)) and 2.) Confederated Tribes of the Umatilla Indian Reservation (CTUIR) in the Columbia River Gorge (CRG) (954 m asl). At MBO, the 1,8-dinitropyrene concentration was significantly positively correlated with the time a sampled air mass spent over Asia, suggesting that this NPAH may be a good marker for trans-Pacific atmospheric transport. At CTUIR, NOx, CO₂, and SO₂ emissions from a 585 MW coal fired power plant, in Boardman OR, were found to be significantly positively correlated with PAH, OPAH, NPAH, OC, and PM₂.₅ concentrations. By comparing the Boardman Plant operational time frames when the plant was operating to when it was shut down, the plant was found to contribute a large percentage of the measured PAH (67%), NPAH (91%), OPAH (54%), PM₂.₅ (39%) and OC (38%) concentrations at CTUIR and the CRG prior to Spring 2011 and likely masked trans-Pacific atmospheric transport events to the CRG. Upgrades installed to the Boardman Plant in the spring of 2011 dramatically reduced the plant’s contribution to PAH and OPAH concentrations (by ~72% and ~40%, respectively) at CTUIR and the CRG but not NPAH, PM₂.₅ or OC concentrations
Recommended from our members
Relative influence of trans-pacific and regional atmospheric transport of PAHS in the Pacific Northwest, USA
The relative influences of trans-Pacific and regional atmospheric transport on measured concentrations of polycyclic aromatic hydrocarbons (PAHs), PAH derivatives [Nitro- (NPAH) and Oxy-(OPAH)], organic carbon (OC), and Particulate Matter (PM) less than 2.5 μm in diameter (PM₂.₅) were investigated in the Pacific Northwest, USA in 2010-2011. Ambient high volume PM₂.₅ air samples were collected at two sites in the Pacific Northwest: 1.) Mount Bachelor Observatory (MBO) in the Oregon Cascade Range (2763 m above sea level (asl)) and 2.) Confederated Tribes of the Umatilla Indian Reservation (CTUIR) in the Columbia River Gorge (CRG) (954 m asl). At MBO, the 1,8-dinitropyrene concentration was significantly positively correlated with the time a sampled air mass spent over Asia, suggesting that this NPAH may be a good marker for trans-Pacific atmospheric transport. At CTUIR, NOx, CO₂, and SO₂ emissions from a 585 MW coal fired power plant, in Boardman OR, were found to be significantly positively correlated with PAH, OPAH, NPAH, OC, and PM₂.₅ concentrations. By comparing the Boardman Plant operational time frames when the plant was operating to when it was shut down, the plant was found to contribute a large percentage of the measured PAH (67%), NPAH (91%), OPAH (54%), PM₂.₅ (39%) and OC (38%) concentrations at CTUIR and the CRG prior to Spring 2011 and likely masked trans-Pacific atmospheric transport events to the CRG. Upgrades installed to the Boardman Plant in the spring of 2011 dramatically reduced the plant’s contribution to PAH and OPAH concentrations (by ~72% and ~40%, respectively) at CTUIR and the CRG but not NPAH, PM₂.₅ or OC concentrations.This is an author's in-press, peer-reviewed manuscript, as accepted by the publisher. The published article is copyrighted by the American Chemical Society and after publication and can be found at: http://pubs.acs.org/journal/esthagKeywords: NPAH, PM, Trans-Pacific Transport, OPAH, Air Pollution, PH
Recommended from our members
Completing the Link between Exposure Science and Toxicology for Improved Environmental Health Decision Making: The Aggregate Exposure Pathway Framework
Driven by major scientific advances in analytical methods, biomonitoring, computation, and a newly articulated vision for a greater impact in public health, the field of exposure science is undergoing a rapid transition from a field of observation to a field of prediction. Deployment of an organizational and predictive framework for exposure science analogous to the “systems approaches” used in the biological sciences is a necessary step in this evolution. Here we propose the aggregate exposure pathway (AEP) concept as the natural and complementary companion in the exposure sciences to the adverse outcome pathway (AOP) concept in the toxicological sciences. Aggregate exposure pathways offer an intuitive framework to organize exposure data within individual units of prediction common to the field, setting the stage for exposure forecasting. Looking farther ahead, we envision direct linkages between aggregate exposure pathways and adverse outcome pathways, completing the source to outcome continuum for more meaningful integration of exposure assessment and hazard identification. Together, the two frameworks form and inform a decision-making framework with the flexibility for risk-based, hazard-based, or exposure-based decision making
Recommended from our members
SimonichStaciEMTPolystyrenePlasticSource_SupplementaryMaterials.pdf
Polycyclic aromatic hydrocarbons (PAHs) on virgin polystyrene (PS) and PS marine debris led us to examine PS as a source and sink for PAHs in the marine environment. At two locations in San Diego Bay, we measured sorption of PAHs to PS pellets, sampling at 0, 1, 3, 6, 9 and 12 months. We detected 25 PAHs using a new analytical method with comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry. Several congeners were detected on samples before deployment. After deployment, some concentrations decreased (1,3-dimethylnaphthalene and 2,6-methylnaphthalene) while most increased (2-methylanthracene and all parent PAHs (PPAHs) except fluorene and fluoranthene), suggesting PS debris is a source and sink for PAHs. When comparing sorbed concentrations of PPAHs on PS to the five most common polymers (polyethylene terephthalate (PET), high-density polyethylene (HDPE), polyvinyl chloride (PVC), low-density polyethylene (LDPE), and polypropylene (PP)), PS sorbed greater concentrations than PP, PET and PVC, similar to HDPE and LDPE. Most strikingly, at 0 months, PPAHs on PS ranged from 8-200 times greater than on PET, HDPE, PVC, LDPE, and PP. The combination of greater PAHs in virgin pellets and large sorption suggests that PS may pose a greater risk of exposure to PAHs upon ingestion
Recommended from our members
SimonichStaciEMTPolystyrenePlasticSource.pdf
Polycyclic aromatic hydrocarbons (PAHs) on virgin polystyrene (PS) and PS marine debris led us to examine PS as a source and sink for PAHs in the marine environment. At two locations in San Diego Bay, we measured sorption of PAHs to PS pellets, sampling at 0, 1, 3, 6, 9 and 12 months. We detected 25 PAHs using a new analytical method with comprehensive two-dimensional gas chromatography coupled to time-of-flight mass spectrometry. Several congeners were detected on samples before deployment. After deployment, some concentrations decreased (1,3-dimethylnaphthalene and 2,6-methylnaphthalene) while most increased (2-methylanthracene and all parent PAHs (PPAHs) except fluorene and fluoranthene), suggesting PS debris is a source and sink for PAHs. When comparing sorbed concentrations of PPAHs on PS to the five most common polymers (polyethylene terephthalate (PET), high-density polyethylene (HDPE), polyvinyl chloride (PVC), low-density polyethylene (LDPE), and polypropylene (PP)), PS sorbed greater concentrations than PP, PET and PVC, similar to HDPE and LDPE. Most strikingly, at 0 months, PPAHs on PS ranged from 8-200 times greater than on PET, HDPE, PVC, LDPE, and PP. The combination of greater PAHs in virgin pellets and large sorption suggests that PS may pose a greater risk of exposure to PAHs upon ingestion